- 您現在的位置：買賣IC網 > PDF目錄192295 > S2815S 1-OUTPUT 10 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | S2815S |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 10 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | 1.710 X 1.310 INCH, 0.450 INCH HEIGHT, HERMETIC SEALED PACKAGE-7 |
| 文件頁數： | 6/9頁 |
| 文件大小： | 134K |
| 代理商： | S2815S |
6
www.irf.com
S-SERIES
1.
Parameter is tested as part of design characterization or after design changes. Thereafter, parameter
shall be guaranteed to the limits specified.
2.
Parameter verified during line and load regulation tests.
3.
Output load current must be distributed such that at least 20% of the total load current is being provided by
one of the outputs.
4.
Load currents split equally between outputs on dual output models. For dual output models, the output may
not meet regulation limits but the converter will not be damaged under this condition.
5.
Cross regulation is measured with 20% rated load on output under test while changing the load on the
other output from 20% to 80% of rated.
6.
Guaranteed for a D.C. to 20MHz bandwidth. Tested using a 20KHz to 10MHz bandwidth.
7.
Capacitive load may be any value from 0 to the maximum limit without compromising dc performance. A
capacitive load in excess of the maximum limit may interfere with the proper operation of the converter’s
overload protection, causing erratic behavior during turn-on.
8.
Overload power dissipation is defined as the device power dissipation with the load set such that VOUT =
90% of nominal.
9.
Load step transition time
≥ 10 s.
10. Recovery time is measured from the initiation of the transient to where VOUT has returned to within ±1% of
its steady state value.
11. Line step transition time
≥ 100 s.
12. Turn-on delay time from either a step application of input power or a logic low to a logic high transition on
the inhibit pin (pin 4) to the point where VOUT = 90% of nominal.
13. Current limit point expressed as a percentage of full rated load current.
14. Total Regulation includes all combinations of line and load compared to the nominal output voltage. For dual
models all line, load, and cross regulation conditions are tested per Note 4 and Note 5.
Notes: Electrical Performance Characteristics
相關PDF資料 |
PDF描述 |
|---|---|
| S29AL032D70BAE000 | 32 Megabit CMOS 3.0 Volt-only Flash Memory |
| S29AL032D70BAE002 | 32 Megabit CMOS 3.0 Volt-only Flash Memory |
| S29AL032D90TFI042 | 32 Megabit CMOS 3.0 Volt-only Flash Memory |
| S29AL032D90TFI043 | 32 Megabit CMOS 3.0 Volt-only Flash Memory |
| S29CD016G0JDEI004 | 512K X 32 FLASH 2.7V PROM, 67 ns, UUC76 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S2815S/EM | 制造商:International Rectifier 功能描述:RAD HARD DC/DC CONVERTER, ENGINEERING MODELS - Bulk |
| S2815S/P | 制造商:International Rectifier 功能描述:RAD HARD DC/DC CONVERTER, PROTOTYPE MODELS - Bulk |
| S-2817A | 制造商:SII 制造商全稱:Seiko Instruments Inc 功能描述:CMOS 16K-bit PARALLEL EEPROM |
| S2818 | 制造商:ISC 制造商全稱:Inchange Semiconductor Company Limited 功能描述:isc Silicon NPN Power Transistor |
| S2818A | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:SILICON NPN TRIPPLE DIFFUSED MESA TYPE |
發布緊急采購，3分鐘左右您將得到回復。