- 您現在的位置：買賣IC網 > PDF目錄24574 > 051-127-9309 (ITT Corporation) RF Coaxial Connectors PDF資料下載
參數資料
| 型號： | 051-127-9309 |
| 廠商： | ITT Corporation |
| 英文描述： | RF Coaxial Connectors |
| 中文描述： | 射頻同軸連接器 |
| 文件頁數： | 28/42頁 |
| 文件大小： | 489K |
| 代理商： | 051-127-9309 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
Dimensions are shown in mm (inch)
Dimensions subject to change
135
Assy Insts
RF Coaxial Connectors
Assembly Instructions
BBAI-1213
SMB Straight Connectors, Clamp Type for Braided Cable
CLAMP NUT
WASHER
‘O’ RING
SLEEVE
INSULATOR
CONTACT
BODY
1. Slide clamp nut, washer and ‘O’ ring over cable.
2. Trim cable to dimensions shown being careful not to nick the braid.
3. Thumb braid out radially at right angles to cable dielectric.
4. Slide sleeve over dielectric and under braid until sleeve is flush with braid.
NOTE: When using cables with inflexible jackets it is permissible to make two 3,17 (.125)
longitudinal slits in the outer jacket.
5. Trim braid flush with flange of sleeve.
6. Trim back dielectric to dimensions shown.
7. Tin center conductor (DO NOT OVER TIN).
8. Fit insulator over center conductor.
9. Place a solder preform, made from 0,26 - 0,31 (.010 - .012) dia. (28 swg) multi-core solder in rear
of contact on center conductor. Heat to make solder connection ensuring shoulder of contact is
flush against rear insulator. Do not allow solder to protrude outside spill hole.
10. Fit front insulator if not part of body. Slide ‘O’ ring forward to trap braid around sleeve.
11. Thread on body and tighten clamp nut to 1.02 Nm (9 in. lbs.).
相關PDF資料 |
PDF描述 |
|---|---|
| 9-1415054-1 | SPECIAL RELAY-SAFETY RELAY, 4PST, MOMENTARY, 0.089A (COIL), 9VDC (COIL), 802mW (COIL), THROUGH HOLE-STRAIGHT MOUNT |
| 9-1415054-1 | SPECIAL RELAY-SAFETY RELAY, 4PST, MOMENTARY, 0.089A (COIL), 9VDC (COIL), 802mW (COIL), THROUGH HOLE-STRAIGHT MOUNT |
| 9-1415055-1 | SPECIAL RELAY-SAFETY RELAY, 4PST, MOMENTARY, 0.007A (COIL), 110VDC (COIL), 800mW (COIL), THROUGH HOLE-STRAIGHT MOUNT |
| 9-1415055-1 | SPECIAL RELAY-SAFETY RELAY, 4PST, MOMENTARY, 0.007A (COIL), 110VDC (COIL), 800mW (COIL), THROUGH HOLE-STRAIGHT MOUNT |
| 9-1415053-1 | SPECIAL RELAY-SAFETY RELAY, 4PST, MOMENTARY, 0.044A (COIL), 18VDC (COIL), 800mW (COIL), THROUGH HOLE-STRAIGHT MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 051-127-9479A9A | 制造商:ITT Interconnect Solutions 功能描述:Conn SMZ PL 0Hz to 3GHz 75Ohm Crimp ST Cable Mount Gold Tray |
| 051-127-9609A9A | 制造商:ITT Interconnect Solutions 功能描述:Conn SMZ PL 0Hz to 3GHz 75Ohm Crimp ST Cable Mount Gold Tray |
| 051-127-9739A9A | 制造商:ITT Interconnect Solutions 功能描述:Conn SMZ PL 0Hz to 3GHz 75Ohm Crimp ST Cable Mount Gold Tray |
| 051-127-9749A9A | 制造商:ITT Interconnect Solutions 功能描述:Conn SMZ PL 0Hz to 3GHz 75Ohm Crimp ST Cable Mount Gold Tray |
| 051-127-9759A9A | 制造商:ITT Interconnect Solutions 功能描述:Conn SMZ PL 0Hz to 3GHz 75Ohm Crimp ST Cable Mount Gold Tray |
發布緊急采購，3分鐘左右您將得到回復。