- 您現在的位置：買賣IC網 > PDF目錄106298 > 110IMY15-15-15-7 2-OUTPUT 16.8 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | 110IMY15-15-15-7 |
| 元件分類： | 電源模塊 |
| 英文描述： | 2-OUTPUT 16.8 W DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 15/16頁 |
| 文件大?。?/td> | 401K |
| 代理商： | 110IMY15-15-15-7 |
IMX/IMY 15 Series
DC-DC Converters <40 Watt
Rugged Environment
Edition 6/7.99
8/16
MELCHER
The Power Partners.
Thermal Considerations
If a converter, mounted on a PCB, is located in free, quasi-
stationary air (convection cooling) at the indicated maxi-
mum ambient temperature
TA max (see table: Temperature
specifications) and is operated at its nominal input voltage
and output power, the case temperature
TC measured at
the
Measuring point of case temperature TC (see: Mechani-
cal Data) will approach the indicated value TC max after the
warm-up phase. However, the relationship between
TA and
TC depends heavily on the conditions of operation and inte-
gration into a system. The thermal conditions are influ-
enced by input voltage, output current, airflow, temperature
of surrounding components and surfaces and the proper-
ties of the printed circuit board.
TA max is therefore only an
indicative value and under practical operating conditions,
the ambient temperature
TA may be higher or lower than
this value.
Caution: The case temperature
TC measured at the:
Measuring point of case temperature TC (see: Mechani-
cal Data) may under no circumstances exceed the
specified maximum value. The installer must ensure that
under all operating conditions
TC remains within the lim-
its stated in the table:
Temperature specifications.
Output Overvoltage Protection
The output of single output units as well as -0503- and
-05-05- types are protected against overvoltages by a sec-
ond control loop. In the event of an overvoltage on one of
the outputs the unit will shut down and attempt to restart
approximately every 50 to 60 ms. Double and dual output
units (with exception of the -0503- and -05-05- types) are
protected against overvoltages by a Zener diode across the
second output. Under worst case conditions the Zener di-
ode will short circuit. Since with double output units both
outputs track each other the protection diode is only pro-
vided in one of the outputs. The main purpose of this fea-
ture is to protect against possible overvoltages which could
occur due to a failure in the feedback control circuit. The
output overvoltage protection is not designed to withstand
externally applied overvoltages.
Overtemperature Protection
The converters are protected from possible overheating by
means of an internal temperature monitoring circuit. It shuts
down the unit above the internal temperature limit and at-
tempts to automatically restart every 50 to 60 ms. This fea-
ture prevents from excessive internal temperature building
up which could occur in heavy overload conditions.
Short Circuit Behaviour
The current limit characteristic shuts down the converter
whenever a short circuit is applied to its output. It acts self-
protecting and automatically recovers after removal of the
overload condition (hiccup mode).
Connection in Series
The outputs of one or several single or double output units
can be connected in series without any precautions, taking
into consideration that the highest output voltage should
remain below 42 V to ensure that the output remains SELV.
Connection in Parallel
The outputs of one or several double output units (except
-0503- types) with equal nominal output voltage can be
connected in parallel. Approximate current sharing be-
tween 2 or several units is ensured by their load dependent
output characteristic. The two outputs of a double output
unit fitted with option R can be connected in parallel to
configure a single output with tight regulation at full load.
Typical Performance Curves
General conditions:
– TA = 25oC, unless TC is specified.
– Shut down pin left open circuit.
– Trim or R input not connected.
Fig. 11
Uo versus Io (typ) of units with Uo = 5.1 V.
(110 IMY 15-05-7R)
Fig. 12
Uo versus Io (typ) of double output units (2
× 12 V), with
both outputs in parallel. (110 IMY 15-12-12-7)
7
8
9
10
11
12
13
Uo [V]
0.2
0.4
0.6
0.8
1.0
1.2
1.4
1.6 1.8 Io total [A]
0
05020
5.5
5.0
4.5
4.0
3.5
3.0
00.4 0.8 1.2 1.6 2.0 2.4 2.8 3.2 3.6 4.0 Io [A]
Uo [V]
05019
相關PDF資料 |
PDF描述 |
|---|---|
| 12IYR1-05-05-T | 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
| 12IYR1-12-12-T | 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
| 15IYR1-05-12-N | 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
| 15IYR1-1212-N | 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
| 15IZR1-0505-T | 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 110IMY15-15-15-8 | 功能描述:DC/DC轉換器 15W (2x 15V) DC Input (60-150V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 110IMY15-15-15-8G | 功能描述:DC/DC CONVERT DUAL 15V 0.56A 制造商:bel power solutions 系列:* 零件狀態:新產品 標準包裝:12 |
| 110IMY15-15-15-8-G | 功能描述:DC/DC轉換器 RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 110IMY15-15-15-9 | 制造商:Power-One 功能描述: |
| 110IMY15-24-24-8 | 功能描述:DC/DC轉換器 15W (2x 24V) DC Input (60-150V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。