- 您現在的位置：買賣IC網 > PDF目錄364071 > 115JP300C102D1 (CTS Corporation) Commercial 3/4 (19.05mm) diameter, 2 watt variable resistor PDF資料下載
參數資料
| 型號： | 115JP300C102D1 |
| 廠商： | CTS Corporation |
| 英文描述： | Commercial 3/4 (19.05mm) diameter, 2 watt variable resistor |
| 中文描述： | 商業3 / 4（十九點零五毫米）直徑2瓦特可變電阻 |
| 文件頁數： | 1/4頁 |
| 文件大?。?/td> | 1077K |
| 代理商： | 115JP300C102D1 |
Commercial
3
/
4
"
(19.05mm) diameter,
2 watt variable
resistor
Fully enclosed construction
Four mounting styles
Long rotational life
Optional grounded or insulated rotor
construction
Incorporated fixed resistor available
Available with nylon shaft
Interchangeable mounting with
CTS series 110 preset potentiometers
Series 115
Technical Data Sheet 1448C
Technical Data Sheet 1115
CTS CORPORATION /
MANUFACTURER OF RELIABLE ELECTRONIC COMPONENTS
Electrical and Mechanical Specifications
Resistance Range
1 ohm through 20K ohms (linear taper)
Resistance Tolerance
Available: ±5%, ±10%, ±20%
Power Rating, Watts
Standard: 2 watts @ 55°C, derated to no load @ 105°C
linear taper, control mounted on metal panel
4" x 4" x .050" (101.6mm x 101.6mm x 1.27mm)
Voltage Rating
Terminals to case (insulated types only)
High pot test, one minute — 900 VAC
Operating maximum — 500 VDC
Across end terminals
Determined by resistance value and wattage rating
Resistance Taper
Linear (±3% independent linearity, standard)
Taps
None
Incorporated Fixed Resistor
A fixed resistor can be incorporated in the Series 115
at the end of CW or CCW rotation to a minimum of 15%
of the total resistance value. The rotation is shortened
by an amount proportional to the ratio of the fixed resistor
to the total resistance value.
Angle of Rotation
270° ± 5°
Adjustment of Resistance
Standard: Cross slot provided in rotor for screwdriver
adjustment.
Special:
Molded nylon, screwdriver-slotted shafts which
are integral with rotor are available in many lengths
in increments of
1
/
8
" (3.2mm) up to a maximum
of 2" (50.8mm).
Available Mounting Types
Printed circuit mounted: Type 115
Twist tab mounted:
Ear mounted:
Rivet ear mounted:
Type P115
Type 116
Type 117
Terminal Information
Grounded Construction
— The grounded construction is
supplied without a center terminal and the contactor is
connected to the case. This construction can be furnished
with one end terminal at either end of the resistance
element or with terminals at both ends of the element.
Insulated Construction
— The contactor is insulated from the
base and connected to the center terminal on the insulated
construction. This construction can be supplied with the
center terminal and one end terminal at either end of the
resistance element or with the center terminal and terminals
at both ends of the resistance element.
Rotational Torque
Turning Torque:
1
/
2
to 10 inch-ounces (36 – 720 g-cm)
Stop Strength: 4 inch-pounds (4.6 Kg-cm)
相關PDF資料 |
PDF描述 |
|---|---|
| 115JP300C500A1 | Commercial 3/4 (19.05mm) diameter, 2 watt variable resistor |
| 115JP300C500B1 | Commercial 3/4 (19.05mm) diameter, 2 watt variable resistor |
| 115JP300C500D1 | Commercial 3/4 (19.05mm) diameter, 2 watt variable resistor |
| 115JP300C501A1 | Commercial 3/4 (19.05mm) diameter, 2 watt variable resistor |
| 115JP300C501B1 | Commercial 3/4 (19.05mm) diameter, 2 watt variable resistor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 115JP300C103A1 | 制造商:CTS Corporation 功能描述:RES WW POT 10K OHM 10% 2W 6.35MM PIN TH - Bulk |
| 115JP300C103B1 | 制造商:CTS Corporation 功能描述:- Bulk |
| 115JP300C201B1 | 制造商:CTS Corporation 功能描述:Res Wirewound Trimmer 200 Ohm 20% 2W 1(Elec)/1(Mech)Turn 6.35mm (19.84 X 18.11mm) Pin Thru-Hole 制造商:CTS 功能描述:Res Wirewound Trimmer 200 Ohm 20% 2W 1(Elec)/1(Mech)Turn 6.35mm (19.84 X 18.11mm) Pin Thru-Hole |
| 115JP300C251A1 | 制造商:CTS Corporation 功能描述:RES WW POT 250 OHM 10% 2W 6.35MM PIN TH - Bulk |
| 115JP300C252A1 | 制造商:CTS Corporation 功能描述:RES WW POT 2.5K OHM 10% 2W 6.35MM PIN TH - Bulk |
發布緊急采購，3分鐘左右您將得到回復。