- 您現在的位置：買賣IC網 > PDF目錄293815 > 40IMX35D05D05-9I 4-OUTPUT 35 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | 40IMX35D05D05-9I |
| 元件分類： | 電源模塊 |
| 英文描述： | 4-OUTPUT 35 W DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 4/18頁 |
| 文件大小： | 375K |
| 代理商： | 40IMX35D05D05-9I |
Board Mountable
DC-DC Converters
IMX 35 Series
Edition 3/4.2000
12/18
Synchronisation (W)
This logic input can be used to synchronise the oscillator to
an external frequency source. This pin is edge triggered
with TTL thresholds, and requires a source frequency of
490...540 kHz (duty cycle 10...90%). The external source
frequency is internally divided by 2 to define the switching
frequency for the converter. If unused, this pin can be con-
nected to V1– (pin 2) or left open-circuit.
Reference (Ref)
This option provides a stable 5 V (
±0.1 V) reference signal
on pin Ref. It is protected by a 1.33 k
resistor. This signal
may be used also in conjunction with the Trim input pin 5
(primary side) as a limited external voltage reference. We
recommend to connect a filter capacitor (0.1
F) between
Ref and Vi–, if Vref is used.
a) Adjustment by means of an external resistor
Rext:
Adjustment of the output voltage by means of an external
resistor
Rext is possible within the range of 100...105% of
Uo nom. Rext should be connected between the Trim pin 5
and Vi–. Connection of
Rext to Vi+ may damage the con-
verter. The following table indicates suitable resistor val-
ues for typical output voltages under nominal conditions
(
Ui nom, Io = 0.5 Io nom).
b) Adjustment by means of an external voltage source
Uext.
For external output voltage adjustment in the range
80...105% of
Uo nom a (0...20 V) source Uext is required,
connected to the Trim pin 5 and Vi–. The table below indi-
cates typical
Uo versus Uext values. Applying a control
voltage 15...20 V will set the converter into a hiccup
mode. Direct paralleling of the Trim pins of units of the
same type connected in parallel is feasible.
Table 11: Uo versus Uext for Uo = 80...105% Uo nom;
typical values (Ui nom, Io = 0.5 Io nom)
Uo [% Uo nom]
Uext [V]
≥105
0
102
1.8
100
2.5
95
4.25
85
8.25
80
10.2
Table 10: Rext1 for Uo > Uo nom;
approximate values (Ui nom, Io = 0.5 Io nom)
Uo [% Uo nom]
Rext [k]
105...108 (107 typically)
0
105
3.3
104
6.2
103
10
102
18
101
39
100
∞
The block diagram 2 shows the triple output units. They of-
fer a Trim1 input (pin 18) on the secondary side to adjust
Uo1. The other outputs remain unchanged. Pin 18 is not
connected. Refer to Fig. 15 for the schematic and Table 8 to
determine
Rext.
The quadruple output units are shown in block diagram 3.
All types with equal output voltage have the Trim function
connected to pin 5 referenced to the primary side which in-
fluences all outputs simultaneously. The schematics are
shown in fig. 16, the values of the adjust resistor
Rext in Ta-
ble 10 and the external voltage source in Table 11.
相關PDF資料 |
PDF描述 |
|---|---|
| 411SM1 | SNAP ACTING/LIMIT SWITCH, SPDT, MOMENTARY, 5A, 30VDC, 0.63mm, PANEL MOUNT |
| 41320S | INTERCONNECTION DEVICE |
| 4141A-22 | TOGGLE SWITCH, DPST, LATCHED, 6A, 30VDC, PANEL MOUNT-THREADED |
| 41456-1001 | 1 CONTACT(S), MALE, STRAIGHT TWO PART BOARD CONNECTOR, SOLDER |
| 41456-1202 | 1 CONTACT(S), MALE, STRAIGHT TWO PART BOARD CONNECTOR, SOLDER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 40IMX35D05D12-8 | 功能描述:DC/DC轉換器 35W (2x 5V, 2x 12V) DC Input (16.8-75V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 40IMX35D05D12-8-G | 功能描述:DC/DC轉換器 RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 40IMX35D05D12-8Z | 制造商:Power-One 功能描述:DC/DC PS QUAD-OUT 5V/12V/12V/5V 1.4A/0.7A/0.7A/1.4A 35W 17PI - Bulk |
| 40IMX35D05D12-8ZG | 制造商:Power-One 功能描述:DC/DC PS QUAD-OUT 5V/12V 1.4A/0.7A 35W 17PIN - Bulk |
| 40IMX35D05D15-8 | 功能描述:DC/DC轉換器 35W (2x 5V, 2x 15V) DC Input (16.8-75V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。