- 您現在的位置：買賣IC網 > Datasheet目錄49 > 4432-T-B1 B 915 (Silicon Laboratories Inc)KIT DEV TEST EZRADIOPRO SI4432 Datasheet資料下載
參數資料
| 型號： | 4432-T-B1 B 915 |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 41/47頁 |
| 文件大小： | 799K |
| 描述： | KIT DEV TEST EZRADIOPRO SI4432 |
| 標準包裝： | 1 |
| 附件類型： | 測試卡，收發器，915MHz |
| 適用于相關產品： | EZRadioPRO? |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁
Si4430/31/32-B1
Rev 1.1
41
6. Data Handling and Packet Handler
The internal modem is designed to operate with a packet including a 010101... preamble structure. To configure the
modem to operate with packet formats without a preamble or other legacy packet structures contact customer
support.
6.1. RX and TX FIFOs
Two 64 byte FIFOs are integrated into the chip, one for RX and one for TX, as shown in Figure 17. "Register 7Fh.
FIFO Access" is used to access both FIFOs. A burst write, as described in "3.1. Serial Peripheral Interface (SPI)"
on page 18, to address 7Fh will write data to the TX FIFO. A burst read from address 7Fh will read data from the
RX FIFO.
Figure 17. FIFO Thresholds
The TX FIFO has two programmable thresholds. An interrupt event occurs when the data in the TX FIFO reaches
these thresholds. The first threshold is the FIFO almost full threshold, txafthr[5:0]. The value in this register
corresponds to the desired threshold value in number of bytes. When the data being filled into the TX FIFO crosses
this threshold limit, an interrupt to the microcontroller is generated so the chip can enter TX mode to transmit the
contents of the TX FIFO. The second threshold for TX is the FIFO almost empty threshold, txaethr[5:0]. When the
data being shifted out of the TX FIFO drops below the almost empty threshold an interrupt will be generated. If
more data is not loaded into the FIFO then the chip automatically exits the TX State after the ipksent interrupt
occurs. The chip will return to the mode selected by the remaining bits in SPI Register 07h. For example, the chip
may be placed into TX mode by setting the txon bit, but with the xton bit additionally set. For this condition, the chip
will transmit all of the contents of the FIFO and the ipksent interrupt will occur. When this interrupt event occurs, the
chip will clear the txon bit and return to READY mode, as indicated by the set state of the xton bit. If the pllon bit D1
is set when entering TX mode (i.e., SPI Register 07h = 0Ah), the chip will exit from TX mode after sending the
packet and return to TUNE mode.
However, the chip will not automatically return to STANDBY mode upon exit from the TX state, in the event the TX
packet is initiated by setting SPI Register 07h = 08h (i.e., setting only txon bit D3). The chip will instead return to
READY mode, with the crystal oscillator remaining enabled. This is intentional; the system may be configured such
that the host MCU derives its clock from the MCU_CLK output of the RFIC (through GPIO2), and this clock signal
must not be shut down without allowing the host MCU time to process any interrupt signals that may have
occurred. The host MCU must subsequently perform a WRITE to SPI Register 07h = 00h to enter STANDBY mode
and obtain minimum current consumption.
TX FIFO
RX FIFO
RX FIFO Almost Full
Threshold
TX FIFO Almost Empty
Threshold
TX FIFO Almost Full
Threshold
相關PDF資料 |
PDF描述 |
|---|---|
| 5250AT43A200E | ANTENNA CHIP 5.25GHZ WIFI |
| 5250BL14B100T | BALUN CERAMIC CHIP WIFI 5250MHZ |
| 5250BL15B100E | BALUN CERAMIC CHIP WIFI 5250MHZ |
| 5325BL15B050E | BALUN CERAMIC CHIP WIFI 5325MHZ |
| 5512BL15B100E | BALUN CERAMIC CHIP WIFI 5512MHZ |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 4432-T-B1C470 | 制造商:Silicon Laboratories Inc 功能描述:One antenna Tx/Rx test card 470MHz |
| 4432-T-B1C915 | 制造商:Silicon Laboratories Inc 功能描述:One antenna Tx/Rx test card 915MHz |
| 4432W-1"x72yd | 功能描述:膠帶 70002457219 4432W YDA WHITE 1 IN X 72 YD BULK RoHS:否 制造商:3M Electronic Specialty 產品:Tapes 類型:Shielding 描述/功能:EMI/RFI Foil Shielding Tape 顏色: 材料:Copper Foil 寬度:1 in x 18 yds |
| 4432W-1/2"x72yd | 功能描述:膠帶 4432WYDA WHITE 1/2X72YD BULK RoHS:否 制造商:3M Electronic Specialty 產品:Tapes 類型:Shielding 描述/功能:EMI/RFI Foil Shielding Tape 顏色: 材料:Copper Foil 寬度:1 in x 18 yds |
| 4432W-1/2X72YD | 制造商:3M Electronic Products Division 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。