- 您現在的位置：買賣IC網 > PDF目錄30701 > 48SD1616 (Maxwell Technologies, Inc) 256 Mb SDRAM 4-Meg X 16-Bit X 4-Banks PDF資料下載
參數資料
| 型號： | 48SD1616 |
| 廠商： | Maxwell Technologies, Inc |
| 英文描述： | 256 Mb SDRAM 4-Meg X 16-Bit X 4-Banks |
| 中文描述： | 256 MB的SDRAM的4梅格x 16位× 4，銀行 |
| 文件頁數： | 3/42頁 |
| 文件大小： | 596K |
| 代理商： | 48SD1616 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
48SD1616
M
em
o
ry
11
All data sheets are subject to change without notice
2005 Maxwell Technologies
All rights reserved.
256Mb (4-Meg X 16-Bit X 4-Banks) SDRAM
01.07.05 REV 4
CKE Truth Table
Note: H:V
IH L:VIL x VIH or VIL
Clock suspend mode entry: The SDRAM enters clock suspend mode from active mode by setting CKE to
Low. If a command is input in the clock suspend mode entry cycle, the command is valid. The clock suspend
mode change depending on the current status (1 clock before) as described below.
ACTIVE clock suspend: This suspend mode ignores inputs after the next clock by internally maintaining
the bank active status.
READ suspend and READ with Auto-precharge suspend: The data being output is held ( and continues
to be output).
WRITE suspend and WRIT with Auto-precharge suspended: In this mode, external signals are not
accepted. However, the internal state is held.
Clock suspend: During clock suspend mode, keep the CKE to Low.
Clock suspend mode exit: The SDRAM exits from clock suspend mode by setting CKE to High during the
clock suspend state.
IDLE: In this state, all banks are not selected, and have completed precharge operation.
Auto-refresh command (REF): When this command is input from the IDLE state, the SDRAM starts auto-
refresh operation. (The auto-refresh is the same as the CBR refresh of conventional DRAMs.) During the
auto-refresh operation, refresh address and bank select address are generated inside the SDRAM. For
every auto-refresh cycle, the internal address counter is updated. Accordingly, 8192 cycles are required to
refresh the entire memory contents. Before executing the auto-refresh command, all the banks must be in
CURRENT STATE
COMMAND
N
-1
N
CS
RAS
CAS
WE
ADDRESS
Active
Clock suspended mode entry
H
L
x
Any
Clock Suspend
L
x
Clock Suspend
Clock Suspend mode exit
L
H
x
Idle
Auto-refresh command (REF)
H
L
H
x
Idle
Self-refresh entry (SELF)
H
L
H
x
Idle
Power down entry
HL
LH
H
x
H
L
HL
xxx
x
Self Refresh
Self Refresh exit (SELFX)
L
H
L
H
x
Power down
Power down exit
LH
H
x
L
H
xxx
x
相關PDF資料 |
PDF描述 |
|---|---|
| 48SD3208RPFK | CAP 1.5UF 50V CERAMIC MONO 20% |
| 48SD3208RPFE | 256 Mb SDRAM 8-Meg X 8-Bit X 4-Banks |
| 48SD3208RPFH | 256 Mb SDRAM 8-Meg X 8-Bit X 4-Banks |
| 48SD3208RPFI | CAP 1.5UF 50V CERAMIC MONO 20% |
| 48SD3208 | 256 Mb SDRAM 8-Meg X 8-Bit X 4-Banks |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 48SD1616RPFE | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:256 Mb SDRAM 4-Meg X 16-Bit X 4-Banks |
| 48SD1616RPFH | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:256 Mb SDRAM 4-Meg X 16-Bit X 4-Banks |
| 48SD1616RPFI | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:256 Mb SDRAM 4-Meg X 16-Bit X 4-Banks |
| 48SD1616RPFK | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:256 Mb SDRAM 4-Meg X 16-Bit X 4-Banks |
| 48SD3208 | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:256 Mb SDRAM 8-Meg X 8-Bit X 4-Banks |
發布緊急采購，3分鐘左右您將得到回復。