- 您現在的位置：買賣IC網 > PDF目錄56759 > 5IMP1-1515-7 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | 5IMP1-1515-7 |
| 元件分類： | 電源模塊 |
| 英文描述： | 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | PLASTIC, DIP-24 |
| 文件頁數： | 3/5頁 |
| 文件大小： | 152K |
| 代理商： | 5IMP1-1515-7 |
Board Mountable
DC-DC Converters
IMP 1 Series
Edition 5/5.2000
3/5
Table 3b: Output data for dual output types
Output
5 IMP 1-0505
5 IMP 1-1212
5 IMP 1-1515
Characteristics
Conditions
min
typ
max
min
typ
max
min
typ
max
Unit
Uo
Output voltage
Ui nom, Io nom
±4.90 ±5 ±5.10
±11.76 ±12 ±12.24 ±14.70 ±15 ±15.30
V
Io nom
Nominal output current
Ui = 4.5...5.5 V DC
±100
±42
±33
mA
uo
Output voltage noise
Ui min...Ui max
80
60
mVpp
(BW = 20 MHz)
Io = 0.2...1 Io nom
DUo U
Static line regulation
Ui min...Ui max, Io nom
±1
±1%
DUo I
Static load regulation
Ui nom
±3
Io = 0...1 Io nom
aUo
Temperature coefficient
Ui nom, Io nom
±0.02
%/K
fs
Switching frequency
50
kHz
Electrical Output Data
General condition:
TA = 25
°C unless otherwise specified
Table 3a: Output data for single output types
Output
5 IMP 1-05
5 IMP 1-12
5 IMP 1-15
Characteristics
Conditions
min
typ
max
min
typ
max
min
typ
max
Unit
Uo
Output voltage
Ui nom, Io nom
4.90
5
5.10
11.76
12
12.24
14.70
15
15.30
V
Io nom
Nominal output current
Ui = 4.5...5.5 V DC
200
84
66
mA
uo
Output voltage noise
Ui nom
100
60
mVpp
(BW = 20 MHz)
Io = 0.2...1 Io nom
DUo U
Static line regulation
Ui min...Ui max, Io nom
±1
±1%
DUo I
Static load regulation
Ui nom
±1
Io = 0...1 Io nom
aUo
Temperature coefficient
Ui nom, Io nom
±0.02
%/K
fs
Switching frequency
50
kHz
Connection in Parallel
The outputs of several units can be connected in parallel.
However, the use of a single unit with a higher power rating
is a better choice because of uneven power distribution
among the outputs connected in parallel. It is recommen-
ded to select converters to be connected in parallel with
very small output voltage differences at full load (i.e.
<
±0.5%). A decoupling diode is not required but recom-
mended.
Protection Scheme
The IMP series is continuously short circuit protected by
means of input power limitation. The unit will not be dam-
aged if started up into a short circuit. After removal of the
short circuit, it will resume normal operation.
The IMP series is also no-load proof, meaning that the
regulation is still effective with no load and the output volt-
age does not rise. However, due to component tolerances,
oscillation could occur and ripple and noise can be outside
of specified values. If the converter is used in senitive elec-
tronic circuits with no-load conditions, it is recommended to
pre-load the outputs with at least 20% of the specified nomi-
nal load.
Thermal Considerations
If a converter is operated, the relationship between the am-
bient temperature
TA and the case temperature TC depends
heavily on the conditions of operation and integration into a
system. The thermal conditions are influenced by input volt-
age, output current, airflow, temperature of surrounding
components and surfaces and the properties of the printed
circuit board. The specified maximum ambient temperature
TA max is therefore only an indicative value and under practi-
cal operating conditions, the ambient temperature
TA may
be higher or lower than this value.
Caution: The case temperature
TC measured at the
Measuring point of case temperature TC (see: Mechani-
cal Data) may under no circumstances exceed the
specified maximum value. The installer must ensure that
under all operating conditions
TC remains within the lim-
its stated in the table:
Temperature specifications.
Connection in Seriess
The outputs of one or more units can be connected in
seriess. No suppressor diodes are required. Power-One
however recommends to protect each individual output with
a Zener diode or preferably a suppressor diode, to avoid re-
verse polarity that may occur if the output voltages do not
rise simultaneously.
相關PDF資料 |
PDF描述 |
|---|---|
| 5IMP1-15-7 | 1-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
| 5IMP1-1515-7 | 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
| 5IMP6-03-7 | 1-OUTPUT 6 W DC-DC REG PWR SUPPLY MODULE |
| 5IMP1-15-7 | 1-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
| 5IMP1-12-7S | 1-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 5IMP1-15-7 | 功能描述:CONVERT DC/DC 15V 1W RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:10 系列:PT4570 類型:隔離 輸出數:1 電壓 - 輸入（最小）:36V 電壓 - 輸入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:3.3A 電源（瓦） - 制造商系列:30W 電壓 - 隔離:1.5kV（1500V） 特點:- 安裝類型:表面貼裝 封裝/外殼:19-SIP SMD 模塊 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包裝:托盤 工作溫度:-40°C ~ 85°C 效率:84% 電源（瓦特）- 最大:30W |
| 5IMP6-03-7 | 制造商:Power-One 功能描述:MELCHER IMP FAMILY - Bulk |
| 5IMP6-05-7 | 功能描述:CONVERT DC/DC 5V 6W RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:10 系列:PT4570 類型:隔離 輸出數:1 電壓 - 輸入（最小）:36V 電壓 - 輸入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:3.3A 電源（瓦） - 制造商系列:30W 電壓 - 隔離:1.5kV（1500V） 特點:- 安裝類型:表面貼裝 封裝/外殼:19-SIP SMD 模塊 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包裝:托盤 工作溫度:-40°C ~ 85°C 效率:84% 電源（瓦特）- 最大:30W |
| 5IMP6-1212-7 | 功能描述:CONVERT DC/DC +12V, -12V 6W RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:10 系列:PT4570 類型:隔離 輸出數:1 電壓 - 輸入（最小）:36V 電壓 - 輸入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:3.3A 電源（瓦） - 制造商系列:30W 電壓 - 隔離:1.5kV（1500V） 特點:- 安裝類型:表面貼裝 封裝/外殼:19-SIP SMD 模塊 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包裝:托盤 工作溫度:-40°C ~ 85°C 效率:84% 電源（瓦特）- 最大:30W |
| 5IMP6-12-7 | 功能描述:CONVERT DC/DC 12V 6W RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:10 系列:PT4570 類型:隔離 輸出數:1 電壓 - 輸入（最小）:36V 電壓 - 輸入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:3.3A 電源（瓦） - 制造商系列:30W 電壓 - 隔離:1.5kV（1500V） 特點:- 安裝類型:表面貼裝 封裝/外殼:19-SIP SMD 模塊 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包裝:托盤 工作溫度:-40°C ~ 85°C 效率:84% 電源（瓦特）- 最大:30W |
發布緊急采購，3分鐘左右您將得到回復。