- 您現在的位置：買賣IC網 > PDF目錄68808 > 70IMX7-1212-8XC (POWER-ONE INC) 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | 70IMX7-1212-8XC |
| 廠商： | POWER-ONE INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | 2 X 1 INCH, PACKAGE-5 |
| 文件頁數： | 13/13頁 |
| 文件大小： | 274K |
| 代理商： | 70IMX7-1212-8XC |
Rugged Environment
DC-DC Converters <40 W
IMX 7-Family
Edition 2/96 - Melcher AG
6 - 25
MELCHER
The Power Partners.
6.1
Supplementary Data
Inhibit Function
The output(s) of the converter may be enabled or disabled
by means of a logic signal (TTL, CMOS, etc.) applied to the
inhibit pin. No output voltage overshoot will occur when the
unit is turned on. If the inhibit function is not required the
inhibit pin should be connected to Vo– to enable the output
(active low logic, fail safe).
Converter operating:
–10 V...0.8 V
Converter inhibited
or inhibit pin left open:
2.4 V...
Ui max (<75 V for 70 IMX 7)
either: Between the R pin and Vo– to achieve an output
voltage adjustment range of approximately
Uo = 75...100 % Uo nom.
Uo
Rext ≈ 4 k –––––––––
Uo nom – Uo
or: Between the R pin and Vo+ to achieve an output volt-
age range of approximately
Uo = 100...105 % Uo nom.
(
Uo – 2.5 V)
R'ext ≈ 4 k ––––––––––––––––––––
2.5 V (
Uo/Uo nom – 1)
b) Adjustment by means of an external voltage
Uext be-
tween Vo– and R pins.
The control voltage range is 1.87...2.62 V and allows for
an adjustment in the range of approximately 75...105%.
Uo 2.5 V
Uext
≈ –––––––––
Uo nom
Attempting to adjust the output below this range will
cause the converter to shutdown (hiccup mode).
Note: Applying an external control voltage >2.75 V
may damage the converter.
Fig. 10
If the inhibit is not used the inhibit pin should be con-
nected to Vi–
Connection in Series or in Parallel
Connection in series:
The outputs of single or double output units can be con-
nected in series without any precautions, taking into con-
sideration that the highest output voltage should remain
below 60 V for SELV operation.
Connection in parallel:
The outputs of one or several double output units with equal
nominal voltage can be connected in parallel. Approximate
current sharing between 2 or several units is ensured by
their load dependent output characteristic.
Short Circuit Behaviour
The current limit characteristic shuts down the converter
whenever a short circuit is applied to its output. It acts self-
protecting and automatically recovers after removal of the
overload condition.
Vi+
Vi–
i
Adjustable Output Voltage (R-input)
As a standard feature, the IMX 7 single and double output
units offer adjustable output voltage(s) by using the control
input R pin. If the R pin is left open circuit the output voltage
is set to
Uo nom. The output voltage is adjustable in the range
75...105 % of
Uo nom.The circuit works for single and double
output units in a different way. For output voltages
Uo >
Uo nom, the minimum input voltage Ui min (see "Electrical In-
put Data") increases proportionally to
Uo/Uo nom.
Single output units:
The R input control pin is referenced to the secondary side
of the converter. Adjustment of the output voltage is possi-
ble by means of either an external resistor or a voltage
source.
a) Adjustment by means of an external resistor
Rext:
Depending upon the value of the required output voltage,
the resistor shall be connected
R
Vo+
Vo–
+
U
ext
–
4 k
Uref 2.5 V
control
circuit
Vi+
Vi–
R
ext
R'
ext
Fig. 11
Output voltage control for single output units by means of
the R-input
Double output units:
The R-pin is referenced to the primary side. The figure
below shows the circuit topology. Adjustment of the output
voltage is possible by means of either an external resistor in
the range of 100...105 % of
Uo nom, or an external voltage
source in the range of 75...105% of
Uo nom.
R
Vo1+
Vo2–
+
U
ext
–
Control
circuit
Uref 2.5 V
Vi+
Vi–
R
ext
Vo1–
Vo2+
Fig. 12
Output voltage control for double output units by means of
the R-input
相關PDF資料 |
PDF描述 |
|---|---|
| 70IMX7-1515-8XC | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 70IMX7-2424-7XC | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 70IMX7-12-12-9D | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 70IMX7-0505-8XC | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 70IMX7-1515-9XC | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 70IMX7-12-12-9 | 功能描述:CONVERT DC/DC 2X 12V 7W RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:5 系列:* |
| 70IMX7-15-15-8 | 功能描述:DC/DC轉換器 7W (2x 15V) DC Input (40-121V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 70IMX7-15-15-8G | 功能描述:DC/DC CONVERTER DUAL 15V 0.24A 制造商:bel power solutions 系列:Melcher IMX7 包裝:散裝 零件狀態:有效 類型:隔離模塊 輸出數:2 電壓 - 輸入（最小值）:40V 電壓 - 輸入（最大值）:121V 電壓 - 輸出 1:15V 電壓 - 輸出 2:15V 電壓 - 輸出 3:- 電流 - 輸出（最大值）:240mA，240mA 功率（W） - 制造系列:7W 電壓 - 隔離:2kV（2000V） 應用:ITE（商業） 特性:遠程開/關，OCP，OTP，OVP，SCP，UVLO 安裝類型:通孔 封裝/外殼:14-DIP 模塊（9 引線） 大小/尺寸:2.00" 長 x 1.00" 寬 x 0.42" 高（50.8mm x 25.4mm x 10.5mm） 工作溫度:-40°C ~ 85°C 效率:83% 功率（W） - 最大值:7W 標準包裝:30 |
| 70IMX7-15-15-9 | 功能描述:CONVERT DC/DC 2X 15V 7W RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:5 系列:* |
| 70IMX7-1515-9C | 功能描述:CONVERT DC/DC 2X 15V 7W RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:5 系列:* |
發布緊急采購，3分鐘左右您將得到回復。