欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: 70IMX7-15-15-9
廠商: POWER-ONE INC
元件分類: 電源模塊
英文描述: 2-OUTPUT 7.2 W DC-DC REG PWR SUPPLY MODULE
封裝: 2 X 1 INCH, 10.50 MM HEIGHT, MA-9
文件頁數: 2/15頁
文件大小: 213K
代理商: 70IMX7-15-15-9
IMX 7 DC/DC Series Data Sheet
7W Board Mountable Converter
REV. OCT 01, 2003
10/15
IMX SERIES
R
Vo+
Vo–
+
U
ext
4 k
Uref 2.5 V
control
circuit
Vi+
Vi–
R
ext1
R
ext 2
06029
Fig. 13
Output voltage control for single output units by means of
the R-input
Double output units:
The R input (Trim) input is referenced to the primary side.
The figure below shows the circuit topology. Adjustment of
the output voltage is possible by means of either an exter-
nal resistor in the range of 100...105% of Vo nom, or an ex-
ternal voltage source in the range of 75...105% of Vo nom.
R (Trim)
Vo1+
Vo2–
+
U
ext
Vi+
Vi–
R
ext
Vo1–
Vo2+
06030
Control
circuit
Uref 2.5 V
Fig. 14
Output voltage control for double output units by means
of the R input
a) Adjustment by means of an external resistor.
Programming of the output voltage by means of an ex-
ternal resistor Rext1 is possible within a limited range of
100...105% of Vo nom. Rext1 should be connected be-
tween the R-pin and Vi–. Connection of Rext1 to Vi+ may
damage the converter. The following table indicates suit-
able resistor values for typical output voltages under
nominal conditions (Vi nom, Io = 0.5 Io nom), with either par-
alleled outputs or equal load conditions on each output.
b) Adjustment by means of an external voltage source Vext.
For external output voltage programming in the range
75...105% of Vo nom a (0...20 V) source Vext is required,
connected to the R-pin and Vi–. The table below indi-
cates typical Vo versus Vext values under nominal condi-
tions (Vi nom, Io = 0.5 Io nom), with either paralleled outputs
or equal load conditions on each output. Applying a con-
trol voltage greater than 20 V will set the converter into a
hiccup mode. Direct paralleling of the R-pins of units
connected in parallel is feasible.
Table 7: Vext for Uo = 75...105% Vo nom;
typical values (Vi nom, Io1, 2 = 0.5 Io1/2 nom)
Vo [% Uo nom]
Vext [V]
105
0
102
1.6
95
4.5
85
9
75
13
b) Adjustment by means of an external voltage Vext be-
tween Vo– and R pins.
The control voltage range is 1.87...2.62 V and allows for
an adjustment in the range of approximately 75...105%.
(85...105% for 3.3 V outputs)
Vo 2.5 V
Vext = –––––––––
Vo nom
Attempting to adjust the output below this range will
cause the converter to shutdown (hiccup mode).
Note: Applying an external control voltage >2.75 V may
damage the converter.
Table 6: Rext1 for Vo > Vo nom;
approximate values (Vi nom, Io1, 2 = 0.5 Io1/2 nom)
Vo [% Vo nom]
Rext [k]
105...108 (107 typically)
0
105
1.5
104
5.6
103
12
102
27
101
68
100
相關PDF資料
PDF描述
70IMX7-03-9 1-OUTPUT 5 W DC-DC REG PWR SUPPLY MODULE
70IMX7-12-12-9 2-OUTPUT 7.2 W DC-DC REG PWR SUPPLY MODULE
70IMX7-24-24-9 2-OUTPUT 7.2 W DC-DC REG PWR SUPPLY MODULE
70IMX7-05-9 1-OUTPUT 6.1 W DC-DC REG PWR SUPPLY MODULE
70IMX7-05-8G 1-OUTPUT 6.1 W DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
70IMX7-1515-9C 功能描述:CONVERT DC/DC 2X 15V 7W RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:5 系列:*
70IMX7-24-24-8 功能描述:DC/DC轉換器 7W (2x 24V) DC Input (40-121V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓(標稱): 輸出端數量:1 輸出電壓(通道 1):3.3 V 輸出電流(通道 1):600 mA 輸出電壓(通道 2): 輸出電流(通道 2): 安裝風格:SMD/SMT 封裝 / 箱體尺寸:
70IMX7-24-24-8G 功能描述:DC/DC CONVERTER 7W 制造商:bel power solutions 系列:Melcher IMX7 零件狀態:在售 類型:隔離模塊,保形涂層 輸出數:2 電壓 - 輸入(最小值):40V 電壓 - 輸入(最大值):121V 電壓 - 輸出 1:24V 電壓 - 輸出 2:24V 電壓 - 輸出 3:- 電壓 - 輸出 4:- 電流 - 輸出(最大值):150mA,150mA 功率(W):7.2W 電壓 - 隔離:2.1kV 應用:ITE(商業),鐵路 特性:遠程開/關,OCP,OTP,OVP,SCP,UVLO 工作溫度:-40°C ~ 85°C 效率:83% 安裝類型:通孔 封裝/外殼:14-DIP 模塊,9 引線 大小/尺寸:2.00" 長 x 1.00" 寬 x 0.41" 高(50.8mm x 25.4mm x 10.5mm) 供應商器件封裝:- 標準包裝:30
70IMX7-24-24-9 制造商:POWER-ONE 制造商全稱:Power-One 功能描述:7 Watt DC-DC Converters
70J00000Z 功能描述:保險絲 3.5A Black/White 125VAC 300VDC RoHS:否 制造商:Littelfuse 產品:Surface Mount Fuses 電流額定值:0.5 A 電壓額定值:600 V 保險絲類型:Fast Acting 保險絲大小/組:Nano 尺寸:12.1 mm L x 4.5 mm W 安裝風格: 端接類型:SMD/SMT 系列:485
主站蜘蛛池模板: 灵川县| 拜泉县| 湖北省| 闻喜县| 延川县| 张家川| 新巴尔虎左旗| 江达县| 泌阳县| 泸定县| 镇安县| 曲沃县| 台东县| 长沙县| 南京市| 黄平县| 大连市| 武强县| 台中市| 博兴县| 天长市| 新竹市| 菏泽市| 平利县| 灵川县| 比如县| 黎城县| 安西县| 历史| 密山市| 蒙阴县| 宜兰县| 平远县| 光泽县| 巩义市| 易门县| 大新县| 四子王旗| 天柱县| 金寨县| 开封市|