- 您現在的位置：買賣IC網 > PDF目錄68811 > 71M6521DE-IM/F (MAXIM INTEGRATED PRODUCTS INC) SPECIALTY ANALOG CIRCUIT, QCC68 PDF資料下載
參數資料
| 型號： | 71M6521DE-IM/F |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, QCC68 |
| 封裝： | LEAD FREE, LQFN-68 |
| 文件頁數： | 7/103頁 |
| 文件大小： | 1691K |
| 代理商： | 71M6521DE-IM/F |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁
71M6521DE/71M6521FE
Energy Meter IC
DATA SHEET
OCTOBER 2010
v1.1
2005-2010 Teridian Semiconductor Corporation
Page: 11 of 103
A Maxim Integrated Products Brand
19-5370; 10/10
Regular MUX Sequence
ALT MUX Sequence
Mux State
EQU
0
1
2
3
0
1
2
3
0, 1, 2
IA
VA
IB
VB
TEMP
VA
IB
VBAT
Table 1: Inputs Selected in Regular and Alternate Multiplexer Cycles
In a typical application, IA and IB are connected to current transformers that sense the current on each phase of the line
voltage. VA and VB are typically connected to voltage sensors through resistor dividers.
The multiplexer control circuit handles the setting of the multiplexer. The function of the control circuit is governed by the I/O
RAM registers MUX_ALT, MUX_DIV and EQU. MUX_DIV controls the number of samples per cycle. It can request 2, 3, or 4
multiplexer states per cycle. Multiplexer states above 4 are reserved and must not be used. The multiplexer always starts at
the beginning of its list and proceeds until MUX_DIV states have been converted.
The MUX_ALT bit requests an alternative multiplexer frame. The bit may be asserted on any MPU cycle and may be
subsequently de-asserted on any cycle including the next one. A rising edge on MUX_ALT will cause the multiplexer control
circuit to wait until the next multiplexer cycle and implement a single alternate cycle.
The multiplexer control circuit also controls the FIR filter initiation and the chopping of the ADC reference voltage, VREF. The
multiplexer control circuit is clocked by CK32, the 32768Hz clock from the PLL block, and launches with each new pass of the
CE program.
A/D Converter (ADC)
A single delta-sigma A/D converter digitizes the voltage and current inputs to the 71M6521DE/FE. The resolution of the ADC is
programmable using the FIR_LEN register as shown in the I/O RAM section. ADC resolution can be selected to be 21 bits
(FIR_LEN=0), or 22 bits (FIR_LEN=1). Conversion time is two cycles of CK32 with FIR_LEN = 0 and three cycles with FIR_LEN
= 1.
In order to provide the maximum resolution, the ADC should be operated with FIR_LEN = 1. Accuracy and timing
specifications in this data sheet are based on FIR_LEN = 1.
Initiation of each ADC conversion is controlled by the multiplexer control circuit as described previously. At the end of each
ADC conversion, the FIR filter output data is stored into the CE DRAM location determined by the multiplexer selection.
FIR Filter
The finite impulse response filter is an integral part of the ADC and it is optimized for use with the multiplexer. The purpose of
the FIR filter is to decimate the ADC output to the desired resolution. At the end of each ADC conversion, the output data is
stored into the fixed CE DRAM location determined by the multiplexer selection. FIR data is stored LSB justified, but shifted left
by nine bits.
Voltage References
The device includes an on-chip precision bandgap voltage reference that incorporates auto-zero techniques. The reference is
trimmed to minimize errors caused by component mismatch and drift. The result is a voltage output with a predictable
temperature coefficient.
The amplifier within the reference is chopper stabilized, i.e. the polarity can be switched by the MPU using the I/O RAM
register CHOP_E (0x2002[5:4]). The two bits in the CHOP_E register enable the MPU to operate the chopper circuit in regular
or inverted operation, or in “toggling” mode. When the chopper circuit is toggled in between multiplexer cycles, DC offsets on
the measured signals will automatically be averaged out.
The general topology of a chopped amplifier is given in Figure 2.
相關PDF資料 |
PDF描述 |
|---|---|
| 71M6521FE-IMR/F | SPECIALTY ANALOG CIRCUIT, QCC68 |
| 71M6521DE-IGT/F | SPECIALTY ANALOG CIRCUIT, QFP64 |
| 71M6521FE-IGTR/F | SPECIALTY ANALOG CIRCUIT, QFP64 |
| 71M6521DE-IMR/F | SPECIALTY ANALOG CIRCUIT, QCC68 |
| 71M6521FE-IM/F | SPECIALTY ANALOG CIRCUIT, QCC68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 71M6521DE-IMR/F | 功能描述:計量片上系統 - SoC Residential Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel |
| 71M6521DH | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Energy Meter ICs |
| 71M6521DH-IGT/F | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Energy Meter ICs |
| 71M6521DH-IGTR/F | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Energy Meter ICs |
| 71M6521FE | 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:Energy Meter IC |
發布緊急采購，3分鐘左右您將得到回復。