- 您現在的位置：買賣IC網 > PDF目錄68811 > 71M6533H-IGT/F (TERIDIAN SEMICONDUCTOR CORP) SPECIALTY ANALOG CIRCUIT, PQFP100 PDF資料下載
參數資料
| 型號： | 71M6533H-IGT/F |
| 廠商： | TERIDIAN SEMICONDUCTOR CORP |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PQFP100 |
| 封裝： | LEAD FREE, LQFP-100 |
| 文件頁數： | 72/124頁 |
| 文件大小： | 2008K |
| 代理商： | 71M6533H-IGT/F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁當前第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
FDS_6533_6534_004
71M6533/71M6534 Data Sheet
v1.1
2007-2009 TERIDIAN Semiconductor Corporation
51
1.4.12 Hardware Watchdog Timer
An independent, robust, fixed-duration, watchdog timer (WDT) is included in the 71M6533/71M6534. It
uses the RTC crystal oscillator as its time base and must be refreshed by the MPU firmware at least
every 1.5 seconds. When not refreshed on time, the WDT overflows and the part is reset as if the RESET
pin were pulled high, except that the I/O RAM bits will be in the same
state as after a wake-up from SLEEP or LCD modes (see the I/O RAM
description in Section 4.2 for a list of I/O RAM bit states after RESET and
wake-up). 4100 oscillator cycles (or 125 ms) after the WDT overflow, the
MPU will be launched from program address 0x0000.
A status bit, WD_OVF, is set when the WDT overflow occurs. This bit is
powered by the nonvolatile supply and can be read by the MPU when
WAKE rises to determine if the part is initializing after a WDT overflow
event or after a power-up. After it is read, the MPU firmware must clear
WD_OVF. The WD_OVF bit is also cleared by the RESET pin.
There is no internal digital state that deactivates the WDT. The WDT can
be disabled by tying the V1 pin to V3P3 (see Figure 16). Of course, this
also deactivates V1 power fault detection. Since there is no method in
firmware to disable the crystal oscillator or the WDT, it is guaranteed that
whatever state the part might find itself in, upon watchdog overflow, the
part will be reset to a known state.
Asserting ICE_E will also deactivate the WDT. This is the only method
that will work in BROWNOUT mode. In normal operation, the WDT is re-
set by periodically writing a one to the WDT_RST bit.
Figure 16: Functions defined by V1
The watchdog timer is also reset when the internal signal WAKE=0 (see Section 2.5 Wake Up Behavior).
If enabled with the IEN_WD_NROVF register in I/O RAM, an interrupt occurs roughly 1 ms before the WDT
resets the chip. This can be used to determine the cause of a WDT reset since it allows the code to log
its state (e.g. the current PC value, loop counters, flags, etc.) before a WDT reset occurs.
1.4.13 Test Ports (TMUXOUT Pin)
One of the digital or analog signals listed in Table 44 can be selected to be output on the TMUXOUT pin.
The function of the multiplexer is controlled with the I/O RAM register TMUX (0x20AA[4:0]), as shown in
The TMUXOUT pin may be used for diagnosis purposes or in production test. The RTC 1-second output
may be used to calibrate the crystal oscillator. The RTC 4-second output provides even higher precision.
V3P3
V3P3 -
400mV
V3P3 - 10mV
VBIAS
0V
Battery
modes
Normal
operation,
WDT
enabled
WDT dis-
abled
V1
相關PDF資料 |
PDF描述 |
|---|---|
| 71M6533-IGT/F | SPECIALTY ANALOG CIRCUIT, PQFP100 |
| 71M6542F-IGT/F | SPECIALTY ANALOG CIRCUIT, PQFP100 |
| 71M6542G-IGTR/F | SPECIALTY ANALOG CIRCUIT, PQFP100 |
| 71M6541G-IGTR/F | SPECIALTY ANALOG CIRCUIT, PQFP64 |
| 71M6541F-IGTR/F | SPECIALTY ANALOG CIRCUIT, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 71M6533H-IGTR/F | 功能描述:計量片上系統 - SoC Precision Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel |
| 71M6533H-IGTR/F1 | 功能描述:計量片上系統 - SoC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel |
| 71M6533H-IGTR/F2 | 功能描述:計量片上系統 - SoC Precision Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel |
| 71M6533-IGT/F | 功能描述:計量片上系統 - SoC Precision Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel |
| 71M6533-IGT/F1 | 功能描述:計量片上系統 - SoC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。