- 您現在的位置：買賣IC網 > PDF目錄360337 > 73LDI-4K10 Converter PDF資料下載
參數資料
| 型號： | 73LDI-4K10 |
| 英文描述： | Converter |
| 中文描述： | 轉換器 |
| 文件頁數： | 1/4頁 |
| 文件大?。?/td> | 23K |
| 代理商： | 73LDI-4K10 |
Apex Signal, A Division of NAI, Inc.
Bohemia, NY 11716 USA
www.naii.com
Code: 0VGU1
Model PC104-73LD1 Specifications
PC104-73LD1 Rev E
SHEET 1 OF 4
PC104-73LD1
FOUR LVDT
"PROGRAMMABLE"
TRACKING CONVERTERS
WITH WRAP-AROUNDSELF TEST. +5 VDC ONLY
FEATURES:
Only +5 VDC.
16 bit Resolution
Accuracy 0.025% FS
Continuous background bit testing with Reference and Signal loss detection
360 Hz to 10 Khz
Transformer isolated
Programmable reference and signal voltages
Accurate Digital Velocity outputs
Latch feature
Synthetic reference compensates for
±
60
°
phase shift
No adjustments or trimming required
8 bit or 16 bit data bus versions
DESCRIPTION:
This PC104 compliant stackthrough module offers four (4) separate transformer isolated
“PROGRAMMABLE” LVDT/RVDT-to-Digital tracking converters with extensive diagnostics, digital
velocity, and (A+B) outputs.
Instead of buying cards that are set for specific inputs, the uniqueness of this
design makes it possible to order our generic card that is Autoranging between 2.0 and 28 volts for 4-wire LVTD
input. For 2-wire inputs, the card can be programmed and reprogrammed in the field for any excitation and signal
voltage between 2.0 and 28 volts. This card uses a derived reference ratiometric design approach that is insensitive
to magnitude, temperature, frequency and phase shift effects. The conversion technique assures that the output
will change only when the LVDT position changes and will ignore excitation voltage variations. The “Latch” feature
permits the user to read all channels at the same time. Reading will unlatch that channel. The converters utilize a
Type II servo loop processing technique that enables tracking, at full accuracy, up to the specified rate.
Intermediate transparent latches, on all data and velocity outputs, guarantee that current valid data is always
available for any channel without effecting the tracking performance of the converters. The optional on
board
excitation supply can be factory set for a particular voltage and frequency, or can be supplied as field
programmable. To simplify logistics, Part number, S/N, Date code, & Rev. are stored in permanent memory
locations.
Major diagnostic are incorporated
that
offer
substantial improvements to system reliability because user is
immediately alerted to channel malfunctions. Self-Test (POST) diagnostic can immediately initiate (D3) test.
See
Programming Instructions for further details.
Three different tests (one on-line and two off-line) can be
selected:
The (D2) test
initiates automatic background bit testing. Each channel is checked over the Signal range to a
measuring accuracy 0.1% FS, and each Signal and Excitation is monitored. Results are available in registers The
testing is totally transparent to the user, requires no external programming, has no effect on the standard
operation of this card and can be enabled or disabled via the bus.
The (D3) or POST test,
if enabled,
starts
an initiated bit test
that disconnects all channels from the outside world
and connects them across an internal stimulus that generates and measures multiple voltages to a test accuracy
of 0.1%FS. Results can be read from Status registers. External excitation is not required. The testing is totally
transparent to the user, requires no external programming, and can be enabled or disabled via the bus. Power-On
(POST) test can be enabled or disabled via the bus.
The (D0) test
is used to check the card and the interface. All channels are disconnected from the outside world
allowing user to write any number of input voltages to the card and then read the data from the interface. External
excitation is not required.
相關PDF資料 |
PDF描述 |
|---|---|
| 73LDI-4K20 | Low-Cost, 7ns, Low-Power Voltage Comparators |
| 73LDI-4L10 | Converter |
| 73LDI-4L20 | Converter |
| 73M1903 | Low-Cost, 7ns, Low-Power Voltage Comparators |
| 73M2910L-IG | Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 73L-II020 | 功能描述:I/O MODULE 0-20MA 12-BIT;4.88UA RoHS:是 類別:繼電器 >> 輸入/輸出繼電器模塊 - 模擬 系列:73 產品變化通告:73G Series/ProMux Obsolescence 03/Feb/2012 標準包裝:1 系列:73 類型:輸入，電流 顏色:藍 樣式:G5 輸入、輸出通道數:1 通道，差分 分辨率:12 位；4.88µA/計數 邏輯電壓:5VDC（4.5 ~ 5.5VDC） 模塊類型:0 ~ 20mA 串行數據格式:12 位數據包 |
| 73L-II1 | 制造商:GRAYHILL 制造商全稱:Grayhill, Inc 功能描述:Contact Closure DC Input Modules |
| 73L-II10 | 制造商:GRAYHILL 制造商全稱:Grayhill, Inc 功能描述:Contact Closure DC Input Modules |
| 73L-II100M | 制造商:GRAYHILL 制造商全稱:Grayhill, Inc 功能描述:Contact Closure DC Input Modules |
| 73L-II10B | 制造商:GRAYHILL 制造商全稱:Grayhill, Inc 功能描述:Contact Closure DC Input Modules |
發布緊急采購，3分鐘左右您將得到回復。