欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: 88EM8081XX-SAG2C000-T
廠商: MARVELL SEMICONDUCTOR INC
元件分類: 穩壓器
英文描述: 2 A POWER FACTOR CONTROLLER, 120 kHz SWITCHING FREQ-MAX, PDSO8
封裝: GREEN, SOIC-8
文件頁數: 17/64頁
文件大小: 667K
代理商: 88EM8081XX-SAG2C000-T
88EM8080/88EM8081
Datasheet
Doc. No. MV-S106340-01 Rev. B
Copyright 2010 Marvell
Page 24
Document Classification: Proprietary
August 6, 2010, Preliminary Information
3.8
Mixed Modes of Operation
The 88EM8080/88EM8081 controller operates in Continuous Conduction Mode (CCM) or
Discontinuous Mode (DCM) modes of operation. The transformer primary inductance and the load
determine the modes of operation. The CCM mode will have lower peak current than the
discontinuous mode of operation. At high power levels CCM is recommended because of reduction
of copper losses in the transformer and also the conduction losses in the primary MOSFET. In
addition CCM could reduce the input filter size. DCM mode may be recommended at lower power
levels to reduce the turn-on switching losses and the Primary FET losses due to reverse recovery
time and charge of the output diode.
3.9
Compensation and Adaptive Control Loop
The LED current control is a feedback control system. The bandwidth of the voltage loop for the
single stage LED feedback control system has to be much less than twice the line frequency to
provide a high power factor and low THD. The entire feedback system needs to be designed for high
power factor and low THD at low line (90-132VAC) and high line (180-264VAC). Marvell has an
internal proportional and integral gain control feature for the voltage loop due to Marvell's DSP
Control Technology. This means by sensing the input voltage, the IC sets PI control automatically to
change the bandwidth for different AC input line ranges. This innovative adaptive feature will help
achieve low THD and high power factor at all lines and loads. Because of this proportional and
integral control within the IC, no external compensation is required for non-isolated outputs. Minimal
external compensation is required for isolated outputs mainly for the compensation on the error
amplifier (TL431) at the secondary side. This compensation network provides enough attenuation at
120Hz so that the second harmonic ripple voltage from the sensed current signal is attenuated and
not amplified.
3.10
Over Temperature Protection
The 88EM8080/88EM8081 IC has an internal over temperature sensing circuit. On over
temperature, the fault detection signal shuts off the PWM switching output at the SW pin.
相關PDF資料
PDF描述
890-001-9PA1-2C2-18T 9 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG
890-001-15PA2-2C7-18T 15 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG
890-001-25PA2-2C2-18T 25 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG
890-001-51PA1-2A1-18T 51 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG
890-001-9PA2-2A1-18T 9 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, CRIMP, PLUG
相關代理商/技術參數
參數描述
88EM8082A1-SAG2C000 制造商:Marvell 功能描述:?ACTIVE PFC CONTROLLER FOR AC-DC FLYBACK LED APPLICATIONS - Bulk 制造商:Marvell 功能描述:88EM8082 Series - Single-Stage 120 kHz Fly-back AC/DC LED Driver - SOIC-8
88EM8182B0-SAE2C000-AL00 制造商:Marvell 功能描述:?NON-DIMMABLE, TRIAC AC/DC LED DRIVER, 110V/220V, LOW VOLTAG - Trays
88EM8182B0-SAE2C000TAL00 制造商:Marvell 功能描述:?NON-DIMMABLE; TRIAC AC/DC LED DRIVER; 110V/220V; LOW VOLTAG - Tape and Reel 制造商:Marvell 功能描述:88EM8182 Series - Fly-back Non-Dimmable LED Driver 110V/220V - 8-Pin SOIC
88EM8183B0-SAE2C000-AL00 制造商:MARVELL 功能描述:0
88EM8183B0-SAE2C000TAL00 制造商:Marvell 功能描述:?DIMMABLE; TRIAC AC/DC LED DRIVER; 110V/220V; LOW VOLTAGE + - Tape and Reel 制造商:Marvell 功能描述:Marvell 88EM8183 Series 19V Universal Triac Dimmable LED Driver - SOIC-8
主站蜘蛛池模板: 叶城县| 昆山市| 元谋县| 沙坪坝区| 高平市| 盖州市| 克拉玛依市| 古蔺县| 凤城市| 左权县| 犍为县| 东至县| 靖边县| 个旧市| 蓬溪县| 博野县| 拉萨市| 呼图壁县| 新龙县| 库车县| 凌源市| 漳浦县| 大埔县| 屯留县| 容城县| 凤城市| 凤山市| 新营市| 藁城市| 霸州市| 西乌珠穆沁旗| 连山| 察隅县| 苍梧县| 锡林浩特市| 江源县| 高陵县| 武义县| 威宁| 政和县| 金昌市|