- 您現在的位置：買賣IC網 > PDF目錄164967 > A22-GW-01A PUSHBUTTON SWITCH, SPST, LATCHED, PANEL MOUNT PDF資料下載
參數資料
| 型號： | A22-GW-01A |
| 元件分類： | 開關 |
| 英文描述： | PUSHBUTTON SWITCH, SPST, LATCHED, PANEL MOUNT |
| 文件頁數： | 35/48頁 |
| 文件大?。?/td> | 1531K |
| 代理商： | A22-GW-01A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
Common To All Assemblies
Common To All Assemblies
41
Installation
J
MOUNTING THE PANEL
Panel Hole Dimensions
22 dia.
(0.87)
25 dia.
(0.98)
24.1
(0.95)
22.3
(0.88)
22.3
(0.88)
25
(0.98)
3.2
(0.13)
For 25 mm-dia. holes, always use 25 mm-dia. Rings. (Since the
cutout dimensions are large, IP65 cannot be guaranteed unless
25-dia. Rings are used.)
If outer surface treatment such as paint is applied to the panel,
the panel dimensions after outer surface treatment must meet the
specified panel dimensions.
J
MATRIX INSTALLATION
1. The following panel hole dimensions apply when Switch Units
and the Standard-size Legend Plate Frame Lock Fitting are
mounted.
30
(1.18)
45
(1.77)
A22N-PR, -MR, -PX
A
22Z
30
(1.18)
41
(1.61)
2. The following panel hole dimensions apply when the
Large-size Legend Plate Frame is mounted.
45
(1.77)
45
(1.77)
A
22N-S
30
(1.18)
41
(1.61)
A
22Z
Locking should be applied toward the Engraving Plate.
Note: The above dimensions are the smallest-possible mounting
dimensions. However, these dimensions do not apply to
large Pushbutton Switches. For large Pushbutton
Switches, determine the distance between holes, taking
the Operational Unit and Legend Plate Frame into
account.
J
MOUNTING THE OPERATIONAL UNIT
ON THE PANEL
Insert the Operational Unit from the front surface of the panel,
insert the Lock Fitting and the mounting nut from the terminal
side, then tighten the nut. Before tightening, check that the rubber
washer is present between the Operational Unit and the panel.
When using a Legend Plate Frame, put one rubber washer each
between the Legend Plate Frame and the panel and between the
Operational Unit and the Legend Plate Frame. (One rubber
washer will be provided when one Legend Plate Frame is
ordered.)
Align the Lock Fitting with the groove in the casing, then insert
the Lock Fitting so that its edge is located on the panel side.
Tighten the mounting nut at a torque of 0.98 to 1.96 N m{10 to
20 kgf cm}.
When using a Lock Ring, replace with the supplied Lock Fitting,
insert the projecting part into the lock slot, and then tighten the
mounting nut.
Hold here
Mounting nut
Lock Fitting
Rubber washer
Panel
Proj-
ecting
part
Panel
Lock
Fitting
When the panel cutout dimension is 25 mm dia., remove the
supplied rubber washer and mount the 25 mm-dia. Ring as
shown below. (Since the A22Z-R25 is not attached to the main
body, order separately.)
Operational Unit
25-dia. Ring
Panel
Lock Fitting
Mounting nut
(A22Z-R25)
22.3 dia.
25 dia.
22.3 dia.
相關PDF資料 |
PDF描述 |
|---|---|
| A22L-HA-24A-11M | PUSHBUTTON SWITCH, SPST, MOMENTARY, 24VDC, PANEL MOUNT |
| A22L-HG-6A-20M | PUSHBUTTON SWITCH, DPST, MOMENTARY, PANEL MOUNT |
| A22L-HG-6D-01A | PUSHBUTTON SWITCH, SPST, LATCHED, 6VDC, PANEL MOUNT |
| A22L-HG-6D-20A | PUSHBUTTON SWITCH, DPST, LATCHED, 6VDC, PANEL MOUNT |
| A22L-HR-12A-01M | PUSHBUTTON SWITCH, SPST, MOMENTARY, 12VDC, PANEL MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| A22GW01M | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:SWITCH PUSH SPST-NC 10A 110V 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:Switch Push Button N.C. SPST Flush Round Button 10A 440VAC 380VDC Momentary Contact Screw Panel Mount |
| A22-GW-01M | 功能描述:按鈕開關 SPST-NC MOM RND WHTE Full-guard actuator RoHS:否 制造商:C&K Components 觸點形式:2 NC - 2 NO 開關功能:ON ? OFF 電流額定值:4 A 電壓額定值 AC:12 V to 250 V 電壓額定值 DC:12 V to 50 V 功率額定值: 安裝風格:Through Hole 照明:Illuminated 照明顏色:None IP 等級:IP 40 端接類型:Solder 觸點電鍍:Silver 執行器:Square 蓋顏色: 封裝: 可燃性等級:UL 94 V-0 |
| A22GW02A | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:SWITCH PUSH DPST-NC 10A 110V 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:Switch Push Button N.C. DPST Flush Round Button 10A 440VAC 380VDC Alternate Contact Screw Panel Mount |
| A22-GW-02A | 功能描述:按鈕開關 DPST-NC ALT RND WHTE Full-guard actuator RoHS:否 制造商:C&K Components 觸點形式:2 NC - 2 NO 開關功能:ON ? OFF 電流額定值:4 A 電壓額定值 AC:12 V to 250 V 電壓額定值 DC:12 V to 50 V 功率額定值: 安裝風格:Through Hole 照明:Illuminated 照明顏色:None IP 等級:IP 40 端接類型:Solder 觸點電鍍:Silver 執行器:Square 蓋顏色: 封裝: 可燃性等級:UL 94 V-0 |
| A22GW02M | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:SWITCH PUSH DPST-NC 10A 110V 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:Switch Push Button N.C. DPST Flush Round Button 10A 440VAC 380VDC Momentary Contact Screw Panel Mount |
發布緊急采購，3分鐘左右您將得到回復。