欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: AD7575SQ
廠商: ANALOG DEVICES INC
元件分類: ADC
英文描述: LC2MOS 5 us 8-Bit ADC with Track/Hold
中文描述: 1-CH 8-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, CDIP18
封裝: 0.300 INCH, CERDIP-18
文件頁數: 11/12頁
文件大小: 146K
代理商: AD7575SQ
AD7575
–11–
REV. B
Taking the 25
°
C measurement as the starting point, the
full-scale error introduced is always in the negative direction
whether the temperature goes to T
MIN
or T
MAX
. This can be
seen from the AD589 temperature characteristic shown in Fig-
ure 20. If the reference voltage is adjusted for 1.23 V at 45
°
C
(for the 0
°
C to +70
°
C range) and 75
°
C (for the –55
°
C to
+125
°
C range) the magnitude of the error introduced is reduced
since it is distributed in both the positive and negative direc-
tions. Alternatively, this can be achieved not by adjusting at
these temperatures, which would be impractical, but by adjust-
ing the reference to 1.231 V instead of 1.23 V (for the extended
temperature range) at 25
°
C. This has the required effect of
distributing the plot of Figure 20 more evenly about the desired
value.
An additional error source is the mismatch between the tem-
perature coefficients (TCs) of the 10 k
and 1 k
resistors in
the feedback loop of the TLC271. If these resistors have
±
50 ppm/
°
C absolute TCs, the worst case difference in drift be-
tween both resistors is 100 ppm/
°
C. From +25
°
C to +125
°
C, this
introduces a worst case shift of 1.22 mV, which results in an addi-
tional full-scale error of 0.25 LSB. If
±
25 ppm/
°
C
resistors are
used, then the worst case error is 0.13 LSB. Over the 0
°
C to
+70
°
C range, the
±
50 ppm/
°
C resistors introduce an additional
full-scale error of 0.11 LSB. All these errors are worst case and
assume that the resistance values drift in opposite directions. In
practice, resistors of the same type, and from the same manufac-
turer, would drift in the same direction and hence the above
error would be considerably reduced. An additional error source
is the offset drift of the TLC271. This is significant only over
the –55
°
C to +125
°
C range and, even in this case, it contrib-
utes <0.1 LSB worth of full-scale error.
The error outlined in the right-hand column of Table I is a total
unadjusted error specification, excluding resistor and offset drift
(the effect of these can be controlled by the user). It consists of
errors from two error sources: a
±
l LSB contribution from the
AD7575 (including full-scale, offset and relative accuracy er-
rors), and the remainder is a full-scale error introduced by the
AD589. It is important to note that the variation of the AD589
voltage only introduces a full-scale error; the relative accuracy
(or endpoint nonlinearity) of the system, with a top grade
AD7575, is still
±
1/2 LSB (i.e., 8-bits accurate).
TEMPERATURE –
8
C
1.2370
1.2365
1.2345–50
125
–25
O
0
25
50
75
100
1.2360
1.2355
1.2350
Figure 20. Typical AD589 Temperature Characteristics
The effect the TC has on the system error is that it introduces a
full-scale error in the ADC. This, in turn, affects the total unad-
justed error specification. For example, using the AD589KH
with a 50 ppm/
°
C max TC the change in reference voltage from
25
°
C to 70
°
C will be from 1.23 V to 1.22724 V, a change of –
2.76 mV. This results in a change in the full-scale range of the
ADC of –5.52 mV, since the full-scale range on the AD7575 is
2 V
REF
. Because the LSB size for the AD7575 is 9.61 mV, the
AD589 introduces an additional full-scale error of –0.57 LSBs
on top of the existing full-scale error specification for the ADC.
Since the total unadjusted error specification for the ADC
includes the full-scale error, there is also a corresponding in-
crease in the total unadjusted error of –0.57 LSBs. The change
in reference voltage at 0
°
C is –1.5 mV, resulting in a full-scale
change of –3 mV or –0.31 LSBs worth of full-scale error. Table I
shows the amount of additional total unadjusted error, which is
introduced by the temperature variation of the AD589, for
different grades and for different temperature ranges. This table
applies only to nonratiometric applications, because the tem-
perature variation of the reference does not affect the system
error in ratiometric applications as outlined earlier. It shows the
amount of error introduced over T
MIN
to T
MAX
for a system in
which the reference has been adjusted to the desired value at
25
°
C. The final or right-most column of the table gives the total
combined error for the AD589 and the top grade AD7575.
Table I. AD589/AD7575 Error over Temperature (Nonratiometric Applications)
Full-Scale Error Introduced
by AD589 @ T
MAX
(Worst Case)
Combined Worst Case
AD589/AD7575
T.U.E. @ T
MAX
–2.15 LSB
–1.57 LSB
–1.29 LSB
–1.115 LSB
–3.56 LSB
–2.28 LSB
–1.64 LSB
AD589
Grade
Temperature
Range
0
°
C to +70
°
C
0
°
C to +70
°
C
0
°
C to +70
°
C
0
°
C to +70
°
C
–55
°
C to +125
°
C
–55
°
C to +125
°
C
–55
°
C to +125
°
C
AD589JH
AD589KH
AD589LH
AD589MH
AD589SH
AD589TH
AD589UH
–1.15 LSB
–0.57 LSB
–0.29 LSB
–0.115 LSB
–2.56 LSB
–1.28 LSB
–0.64 LSB
*Excluding resistor and offset drift.
相關PDF資料
PDF描述
AD7575TE LC2MOS 5 us 8-Bit ADC with Track/Hold
AD7575TQ LC2MOS 5 us 8-Bit ADC with Track/Hold
AD7576JN LC2MOS 10 us uP-Compatible 8-Bit ADC
AD7576 LC2MOS 10 us uP-Compatible 8-Bit ADC
AD7576AQ LC2MOS 10 us uP-Compatible 8-Bit ADC
相關代理商/技術參數
參數描述
AD7575TCHIPS 功能描述:8 Bit Analog to Digital Converter 1 Input 1 SAR Die 制造商:analog devices inc. 系列:- 包裝:托盤 - 晶粒 零件狀態:上次購買時間 位數:8 采樣率(每秒):- 輸入數:1 輸入類型:單端 數據接口:并聯 配置:S/H-ADC 無線電 - S/H:ADC:1:1 A/D 轉換器數:1 架構:SAR 參考類型:外部 電壓 - 電源,模擬:5V 電壓 - 電源,數字:5V 特性:- 工作溫度:-55°C ~ 125°C 封裝/外殼:模具 供應商器件封裝:模具 標準包裝:1
AD7576AQ 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Analog Devices 功能描述:
AD7576BQ 制造商:Rochester Electronics LLC 功能描述:- Bulk
AD7576JN 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Analog Devices 功能描述:IC 8BIT ADC 7576 DIP18
AD7576JP 制造商:Rochester Electronics LLC 功能描述:- Bulk
主站蜘蛛池模板: 独山县| 英山县| 安塞县| 郁南县| 顺昌县| 湖南省| 恩平市| 乌恰县| 凤翔县| 清徐县| 宾川县| 横山县| 海口市| 胶州市| 正镶白旗| 黄骅市| 永福县| 鞍山市| 得荣县| 贡山| 罗山县| 鲁甸县| 望江县| 株洲县| 博罗县| 合江县| 阿荣旗| 密山市| 涟水县| 天门市| 靖宇县| 玉门市| 承德市| 北川| 安国市| 黄平县| 临颍县| 全南县| 林口县| 印江| 铅山县|