欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: AD7871KP
廠商: ANALOG DEVICES INC
元件分類: ADC
英文描述: LC2MOS Complete 14-Bit, Sampling ADCs
中文描述: 1-CH 14-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL/PARALLEL ACCESS, PQCC28
封裝: PLASTIC, LCC-28
文件頁數: 11/16頁
文件大小: 344K
代理商: AD7871KP
AD7871/AD7872
–11–
REV. D
microprocessor and the conversion result is read from the ADC
with the following instruction:
ADSP-2100 MR0 = DM(ADC)
T MS32020/C25: IN D,ADC
MR0 = ADSP-2100 MR0 Register
D = Data Memory Address
ADC = AD7871 Address
Figure 17. AD7871 to ADSP-2100 Parallel Interface
Figure 18. AD7871 to TMS32020/C25 Interface
Some applications may require that conversions be initiated by
the microprocessor rather than an external timer. One option is
to decode the AD7871
CONVST
from the address bus so that a
write operation to the ADC starts a conversion. Data is read at
the end of conversion as described earlier. Note, a read opera-
tion must not be attempted during conversion.
Using the CCIF standard where two input frequencies near the
top end of the input bandwidth are used, the second and third or-
der terms are of different significance. T he second order terms
are usually distanced in frequency from the original sine waves
while the third order terms are usually at a frequency close to the
input frequencies. As a result, the second and third order terms
are specified separately. T he calculation of the intermodulation
distortion is as per the T HD specification where it is the ratio of
the rms sum of the individual distortion products to the rms
amplitude of the fundamental expressed in dBs. In this case, the
input consists of two, equal amplitude, low distortion sine waves.
Figure 16 shows a typical IMD plot for the AD7871/AD7872.
Figure 16. IMD Plot
Peak Harmonic or Spurious Noise
Peak Harmonic or Spurious Noise is defined as the ratio of the
rms value of the next largest component in the ADC output
spectrum (up to fs/2 and excluding dc) to the rms value of the
fundamental. Normally, the value of this specification will be
determined by the largest harmonic in the spectrum, but for
parts where the harmonics are buried in the noise floor, peak
will be a noise peak.
MICROPROCE SSOR INT E RFACE
T he AD7871 and AD7872 have a wide variety of interfacing op-
tions. T he AD7871 offers two operating modes and three
data-output formats, while the AD7872 is a dedicated serial
output device. T he fast data access times on the parallel modes
of the AD7871 allow interfacing to the very fast DSPs. T he se-
rial mode on both the AD7871 and AD7872 is compatible with
the serial port structures on all the popular DSPs.
Parallel Read Interfacing
Figures 17 and 18 show interfaces to the ADSP-2100 and the
T MS32020/C25 DSP processors. T he AD7871 is operating in
Mode 1, parallel read for both interfaces. An external timer con-
trols conversion start asynchronously to the microprocessor. At
the end of each conversion the ADC
BUSY
/
INT
interrupts the
相關PDF資料
PDF描述
AD7871TQ LC2MOS Complete 14-Bit, Sampling ADCs
AD7872 LC2MOS Complete 14-Bit, Sampling ADCs
AD7872AN LC2MOS Complete 14-Bit, Sampling ADCs
AD7872BR LC2MOS Complete 14-Bit, Sampling ADCs
AD7872JN LC2MOS Complete 14-Bit, Sampling ADCs
相關代理商/技術參數
參數描述
AD7871KP-REEL 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel
AD7871KPZ 功能描述:IC ADC 14BIT SAMPLING 28-PLCC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
AD7871TQ 制造商:Analog Devices 功能描述:ADC SGL SAR 83KSPS 14BIT PARALLEL/SERL 28CDIP - Rail/Tube 制造商:Analog Devices 功能描述:IC ADC 14BIT SAMPLING 28-CDIP 制造商:Analog Devices Inc. 功能描述:Analog to Digital Converters - ADC 14-BIT SAMPLING DAC IC 制造商:Analog Devices 功能描述:CONVERTER - ADC
AD7871TQ/883B 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog-to-Digital Converter, 14-Bit
AD7871TQ4 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS Complete 14-Bit, Sampling ADCs
主站蜘蛛池模板: 霍州市| 新竹县| 修水县| 霍山县| 铅山县| 阳山县| 河源市| 会东县| 红原县| 海门市| 抚顺市| 泰兴市| 东城区| 易门县| 滨州市| 探索| 清原| 泰宁县| 甘肃省| 咸丰县| 洛南县| 长沙市| 云浮市| 永登县| 乌鲁木齐县| 安塞县| 宁武县| 丰县| 永新县| 义马市| 英德市| 浠水县| 东兰县| 田林县| 登封市| 怀来县| 绥阳县| 东平县| 通州区| 五华县| 昌图县|