欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: AD7891YP-1
廠商: ANALOG DEVICES INC
元件分類: ADC
英文描述: CAT5E PATCH CORD 6 FOOT BEIGE
中文描述: 8-CH 12-BIT PROPRIETARY METHOD ADC, SERIAL/PARALLEL ACCESS, PQCC44
封裝: PLASTIC, MO-047AC, LCC-44
文件頁數: 8/20頁
文件大小: 173K
代理商: AD7891YP-1
AD7891
–8–
REV. A
PARALLEL INTERFACE MODE FUNCTIONS
Mnemonic
Description
CS
Chip Select Input. Active low logic input which is used in conjunction with
RD
to enable the data
outputs and with
WR
to allow input data to be written to the part.
Read Input. Active low logic input which is used in conjunction with
CS
low to enable the data outputs.
Write Input. Active low, logic input used in conjunction with
CS
to latch the multiplexer address and
software control information. The rising edge of this input also initiates an internal pulse. When using
the software start facility, this pulse delays the point at which the track/hold goes into hold and con-
version is initiated. This allows the multiplexer to settle and acquisition time of the track/hold to
elapse when a channel address is changed. If the SWCON bit of the control register is set to 1, when
this pulse times out, the track/hold then goes into hold and conversion is initiated. If the SWCON bit
of the control register is set to 0 the track/hold and conversion sequence are unaffected by the
WR
operation.
RD
WR
Data I/O Lines
There are 12 data input/output lines on the AD7891. When the part is configured for parallel mode (MODE = 1), the output data
from the part is provided at these 12 pins during a read operation. For a write operation in parallel mode, these lines provide access
to the part’s Control Register.
Parallel Read Operation
During a parallel read operation the 12 lines become the 12 data bits containing the conversion result from the AD7891. These data
bits are labelled Data Bit 0 (LSB) to Data Bit 11 (MSB). They are three-state TTL-compatible outputs. Output data coding is twos
complement when the data FORMAT Bit of the control register is 1 and straight binary when the data FORMAT Bit of the control
register is 0.
Mnemonic
Description
DB0–DB11
Data Bit 0 (LSB) to Data Bit 11 (MSB). Three-state TTL-compatible outputs which are controlled
by the
CS
and
RD
inputs.
Parallel Write Operation
During a parallel write operation the following functions can be written to the control register via the 12 data input/output pins.
Mnemonic
Description
A0
Address Input. The status of this input during a parallel write operation is latched to the A0 bit of the
control register (see Control Register section).
Address Input. The status of this input during a parallel write operation is latched to the A1 bit of the
control register (see Control Register section).
Address Input. The status of this input during a parallel write operation is latched to the A2 bit of the
control register (see Control Register section).
Software Conversion Start. The status of this input during a parallel write operation is latched to the
SWCONV bit of the control register (see Control Register section).
Software Standby Control. The status of this input during a parallel write operation is latched to the
SWSTBY bit of the control register (see Control Register section).
Data Format Selection. The status of this input during a parallel write operation is latched to the
FORMAT bit of the control register (see Control Register section).
A1
A2
SWCON
SWSTBY
FORMAT
相關PDF資料
PDF描述
AD7891AP-1 LC2MOS 8-Channel, 12-Bit High Speed Data Acquisition System
AD7891AS-1 LC2MOS 8-Channel, 12-Bit High Speed Data Acquisition System
AD7891BP-1 LC2MOS 8-Channel, 12-Bit High Speed Data Acquisition System
AD7891BP-2 LC2MOS 8-Channel, 12-Bit High Speed Data Acquisition System
AD7891BS-1 LC2MOS 8-Channel, 12-Bit High Speed Data Acquisition System
相關代理商/技術參數
參數描述
AD7891YP-1REEL 制造商:Analog Devices 功能描述:ADC Single 454.5ksps 12-bit Parallel/Serial 44-Pin PLCC T/R 制造商:Analog Devices 功能描述:ADC SGL 454.5KSPS 12-BIT PARALLEL/SERL 44PLCC - Tape and Reel
AD7891YPZ-1 功能描述:IC DAS 12BIT 8CH 44-PLCC RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統(DAS) 分辨率(位):16 b 采樣率(每秒):21.94k 數據接口:MICROWIRE?,QSPI?,串行,SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(6x6) 包裝:托盤
AD7891YPZ-1REEL 功能描述:IC DAS 12BIT 8CH 44-PLCC RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統(DAS) 分辨率(位):16 b 采樣率(每秒):21.94k 數據接口:MICROWIRE?,QSPI?,串行,SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(6x6) 包裝:托盤
AD7891YS1 制造商:AD 功能描述:New
AD7891YS-1 制造商:Analog Devices 功能描述:ADC Single 454.5ksps 12-bit Parallel/Serial 44-Pin MQFP
主站蜘蛛池模板: 武邑县| 莱阳市| 资中县| 绥江县| 武宁县| 新宾| 原平市| 弥勒县| 萍乡市| 霍邱县| 枝江市| 正安县| 友谊县| 松桃| 辰溪县| 海安县| 华池县| 建德市| 年辖:市辖区| 镇平县| 奇台县| 闵行区| 广州市| 冕宁县| 绥中县| 信宜市| 营山县| 乃东县| 萨嘎县| 伊宁县| 蒲城县| 镇巴县| 辰溪县| 青岛市| 杨浦区| 阜城县| 义马市| 玉环县| 博乐市| 通河县| 遂宁市|