- 您現在的位置：買賣IC網 > PDF目錄373928 > AD8005ART-REEL7 (ANALOG DEVICES INC) 270 MHz, 400 uA Current Feedback Amplifier PDF資料下載
參數資料
| 型號： | AD8005ART-REEL7 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | 270 MHz, 400 uA Current Feedback Amplifier |
| 中文描述： | OP-AMP, 50000 uV OFFSET-MAX, PDSO5 |
| 封裝： | PLASTIC, SOT-23, 5 PIN |
| 文件頁數： | 9/12頁 |
| 文件大小： | 183K |
| 代理商： | AD8005ART-REEL7 |
AD8005
–9–
REV. A
APPLICATIONS
Driving Capacitive Loads
Capacitive loads interact with an op amp’s output impedance
to create an extra delay in the feedback path. This reduces
circuit stability, and can cause unwanted ringing and oscilla-
tion. A given value of capacitance causes much less ringing
when the amplifier is used with a higher noise gain.
The capacitive load drive of the AD8005 can be increased by
adding a low valued resistor in series with the capacitive load.
Introducing a series resistor tends to isolate the capacitive load
from the feedback loop thereby diminishing its influence. Fig-
ure 29 shows the effects of a series resistor on capacitive drive
for varying voltage gains. As the closed-loop gain is increased,
the larger phase margin allows for larger capacitive loads with
less overshoot. Adding a series resistor at lower closed-loop
gains accomplishes the same effect. For large capacitive loads,
the frequency response of the amplifier will be dominated by
the roll-off of the series resistor and capacitive load.
AD8005
R
G
R
F
R
S
R
L
1k
V
C
L
Figure 28. Driving Capacitive Loads
C
80
70
60
1
3
4
5
CLOSED-LOOP GAIN – V/V
50
2
40
30
20
10
0
V
S
=
6
5V
2V OUTPUT STEP
WITH 30% OVERSHOOT
R
S
= 10
V
R
S
= 5
V
R
S
= 0
V
Figure 29. Capacitive Load Drive vs. Closed-Loop Gain
Single-Supply Level Shifter
In addition to providing buffering, many systems require that an
op amp provide level shifting. A common example is the level
shifting that is required to move a bipolar signal into the unipo-
lar range of many modern analog-to-digital converters (ADCs). In
general, single supply ADCs have input ranges that are refer-
enced neither to ground nor supply. Instead the reference level
is some point in between, usually halfway between ground and
supply (+2.5 V for a single supply 5 V ADC). Because high-
speed ADCs typically have input voltage ranges of 1 V to 2 V,
the op amp driving it must be single supply but not necessarily
rail-to-rail.
V
REF
+5V
R2
1.5k
V
V
OUT
0.01
m
F
10
m
F
+5V
R1
1.5k
V
V
IN
0.1
m
F
R4
10k
V
R3
30.1k
V
AD8005
Figure 30. Bipolar to Unipolar Level Shifter
Figure 30 shows a level shifter circuit that can move a bipolar
signal into a unipolar range. A positive reference voltage, derived
from the +5 V supply, sets a bias level of +1.25 V at the nonin-
verting terminal of the op amp. In ac applications, the accuracy of
this voltage level is not important. Noise is however a serious
consideration. A 0.1
μ
F capacitor provides useful decoupling of
this noise.
The bias level on the noninverting terminal sets the input common-
mode voltage to +1.25 V. Because the output will always be
positive, the op amp may therefore be powered with a single
+5 V power supply.
The overall gain function is given by the equation:
V
OUT
=
–
R
2
R
1
V
IN
+
R
4
R
3
+
R
4
1
+
R
2
R
1
V
REF
In the above example, the equation simplifies to
V
OUT
=
–
V
IN
+
2.5
V
相關PDF資料 |
PDF描述 |
|---|---|
| AD8005AN | 270 MHz, 400 uA Current Feedback Amplifier |
| AD8005AR | 270 MHz, 400 uA Current Feedback Amplifier |
| AD8005AR-REEL | 270 MHz, 400 uA Current Feedback Amplifier |
| AD8009 | 1 GHz, 5,500 V/us Low Distortion Amplifier |
| AD8009AR | 1 GHz, 5,500 V/us Low Distortion Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8005ARTZ-R2 | 制造商:Analog Devices 功能描述:OP Amp Single Current Fdbk 制造商:Analog Devices 功能描述:OP AMP SGL CURRENT FDBK 6.3V/12.6V 5PIN SOT-23 - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:SOT23 180MHZ,400UA CURRENT FEEDBACK AMP - Bulk |
| AD8005ARTZ-REEL | 制造商:Analog Devices 功能描述:OP Amp Single Current Fdbk |
| AD8005ARTZ-REEL7 | 功能描述:IC OPAMP CF ULP LDIST SOT23-5 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| AD8005ARZ | 功能描述:IC OPAMP CF ULP LDIST 10MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| AD8005ARZ-REEL | 功能描述:IC OPAMP CF ULP LDIST 10MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。