- 您現在的位置：買賣IC網 > PDF目錄373928 > AD8010AN (ANALOG DEVICES INC) 200 mA Output Current High Speed Amplifier PDF資料下載
參數資料
| 型號： | AD8010AN |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | 200 mA Output Current High Speed Amplifier |
| 中文描述： | OP-AMP, 15000 uV OFFSET-MAX, 90 MHz BAND WIDTH, PDIP8 |
| 封裝： | MINI, PLASTIC, DIP-8 |
| 文件頁數： | 10/12頁 |
| 文件大小： | 164K |
| 代理商： | AD8010AN |
AD8010
–10–
REV. A
Differential Line Driver
Twisted pair transmission lines are more often being used for
high frequency analog and digital signals. Over long distances,
however, the attenuation characteristics of these lines can
degrade the performance of the transmission system. To com-
pensate for this, larger signals are transmitted, which after the
attenuation, will still have useful signal strength.
The high output current of two AD8010s can be used along
with a transformer to create a high power differential line driver.
The differential configuration effectively doubles the output
swing, while the step-up transformer further increases the out-
put voltage.
In the circuit in Figure 31 the A device is configured as a gain-
of-two follower, while the B device is a gain-of-two inverter.
These will produce a differential output signal whose maximum
value is twice the peak-to-peak value of the maximum output of
one device. For this circuit a 12 V peak-to-peak output can be
obtained.
The op amps drive a 1:2 step-up transformer that drives a
100
transmission line. Since the impedance reflected back to
the primary varies as the square of the turns ratio, it will appear
as 25
at the primary. This source terminating resistor is split
as a 12.4
resistor at the output of each device.
The circuit shown is capable of delivering 12 V p-p to the line
and operates with a –3 dB bandwidth of 40 MHz. The peak
current output of either op amp is 100 mA.
Figure 31. High Output Differential Line Driver Using Two AD8010s.
NOTE: Please see Figure 29 for Recommended Bypassing Technique.
AD8010
V
IN
499
V
499
V
150
V
402
V
AD8010
150
V
806
V
12.4
V
12.4
V
+6
–6
1:2
100
V
相關PDF資料 |
PDF描述 |
|---|---|
| AD8010AR | 200 mA Output Current High Speed Amplifier |
| AD8010AR-REEL | 200 mA Output Current High Speed Amplifier |
| AD8010AR-REEL7 | 200 mA Output Current High Speed Amplifier |
| AD8010AR-16 | Smartcard Connector; Body Material:Thermoplastic; Contact Material:Tin Bronze; Series:C702A; Operating Temperature Range : C to C RoHS Compliant: Yes |
| AD8010AR-16-REEL | Smartcard Connector; No. of Contacts:6; Body Material:Thermosplastic; Contact Material:Tin Bronze; Contact Plating:Gold Over Nickel; Series:C707A; Operating Temperature Range +/-:-40 C to +85 C; Voltage Rating:540V RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8010ANZ | 功能描述:IC OPAMP CF 200MA LP 8DIP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT |
| AD8010AR | 功能描述:IC OPAMP CF 200MA LP 8SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| AD8010AR-16 | 制造商:Analog Devices 功能描述:ADSL Driver Single 16-Pin SOIC W Tube 制造商:Rochester Electronics LLC 功能描述:SOIC-WB 160MA OUTPUT CURRENT HI SPD AMP - Bulk |
| AD8010AR-16-REEL | 制造商:Analog Devices 功能描述:ADSL Driver Single 16-Pin SOIC W T/R |
| AD8010AR-16-REEL7 | 制造商:Analog Devices 功能描述:ADSL Driver Single 16-Pin SOIC W T/R 制造商:Rochester Electronics LLC 功能描述:SOIC-WB 160MA OUTPUT CURRENT HI SPD AMP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。