- 您現在的位置：買賣IC網 > PDF目錄373933 > AD8062AR (ANALOG DEVICES INC) 16-Bit, 8-Channel Serial Output Sampling Analog-to-Digital Converter 20-SSOP/QSOP PDF資料下載
參數資料
| 型號： | AD8062AR |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | 16-Bit, 8-Channel Serial Output Sampling Analog-to-Digital Converter 20-SSOP/QSOP |
| 中文描述： | DUAL OP-AMP, 6000 uV OFFSET-MAX, PDSO8 |
| 封裝： | MS-012AA, SOIC-8 |
| 文件頁數： | 15/16頁 |
| 文件大小： | 314K |
| 代理商： | AD8062AR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁
AD8061/AD8062/AD8063
–15–
REV. C
500mV
INPUT
OUTPUT
1
2
10 s
Figure 12. Input and Output Waveforms for a Single
Supply Video Sync Stripper Using an AD8061
Some video signals with sync are derived from single supply
devices, such as video DACs. These signals can contain sync,
but the whole waveform is positive, and the black level is not at
ground but at some positive voltage. The circuit can be modified to
provide the sync stripping function for such a waveform. Instead
of connecting RG to ground, it should be connected to a dc
voltage that is two times the black level of the input signal. The
gain from the +input to the output is two, which means that
the black level will be amplified by two to the output. However,
the gain through RG is –unity to the output. It will take a dc
level of twice the input black level to shift the black level to
ground at the output. When this occurs, the sync will be
stripped, and the active video will be passed as in the ground
referenced case.
75
10 F
0.1 F
3V
3
2
4
6
7
75
MONITOR
#1
75
75
75
1k
1k
1k
1k
3V
1k
3
2
5
6
7
8
1
4
MONITOR
#2
GREEN
DAC
RED
GREEN
BLUE
RED
DAC
BLUE
DAC
75
75
75
75
AD8061
75
10 F
0.1 F
1k
AD8062
75
AD8062
75
Figure 13. RGB Cable Driver Using AD8061 and AD8062
RGB Amplifier
Most RGB graphics signals are created by video-DAC outputs
that drive a current through a resistor to ground. At the video
black level, the current goes to zero, and thus the voltage of the
video is also zero. Before the availability of high-speed rail-to-
rail op amps, it was essential that an amplifier have a negative
supply to amplify such a signal. Such an amplifier is necessary
if one wants to drive a second monitor with from the same
DAC outputs.
However, high-speed, rail-to-rail output amplifiers like the
AD8061 and AD8062 can accept ground level input signals and
output ground level signals and thus be used as RGB signal
amplifiers. A combination of the AD8061 (single) and AD8062
(dual) can amplify the three video channels of an RGB system.
Figure 13 shows a circuit that performs this function.
Multiplexer
The AD8063 has a disable pin that can be used to power down
the amplifier to save power, or can be used to create a mux circuit.
If two (or more) AD8063 outputs are connected together and
only one is enabled, then only the signal of the enabled amplifier
will appear at the output. This configuration can be used to select
from various input-signal sources. Additionally, the same input
signal can be applied to different gain stages or differently
tuned filters to make a gain-step amplifier or a selectable-
frequency amplifier.
Figure 14 shows a schematic of two AD8063s used to create a
mux that selects between two inputs. One of these is a 1 V p-p,
3 MHz sine wave and the other is a 2 V p-p, 1 MHz sine wave.
49.9
1k
+4V
1
–
4V
49.9
TIME
BASE
OUT
TIME
BASE
IN
1V
3MHz
2V
1MHz
V
OUT
49.9
SELECT
HCO4
1k
10 F
0.1 F
10 F
0.1 F
AD8063
49.9
1k
+4V
1
–
4V
1k
10 F
0.1 F
10 F
0.1 F
AD8063
Figure 14. Two-to-One Multiplexer Using Two AD8063s
相關PDF資料 |
PDF描述 |
|---|---|
| AD8062AR-REEL | 16-Bit, 8-Channel Serial Output Sampling Analog-to-Digital Converter 20-SSOP/QSOP |
| AD8062AR-REEL7 | Low-Cost, 300 MHz Rail-to-Rail Amplifiers |
| AD8062ARM | 16-Bit, 8-Channel Serial Output Sampling Analog-to-Digital Converter 20-SSOP/QSOP |
| AD8062ARM-REEL | Low-Cost, 300 MHz Rail-to-Rail Amplifiers |
| AD8062ARM-REEL7 | Low-Cost, 300 MHz Rail-to-Rail Amplifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8062AR-EBZ | 功能描述:BOARD EVAL FOR AD8062AR RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8062ARM | 功能描述:IC OPAMP VF R-R DUAL LP 8MSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| AD8062ARM-EBZ | 功能描述:BOARD EVAL FOR AD8062ARM RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8062ARM-REEL | 制造商:Analog Devices 功能描述:OP Amp Dual Volt Fdbk R-R O/P 8V 8-Pin MSOP T/R |
| AD8062ARM-REEL7 | 制造商:Rochester Electronics LLC 功能描述:MINISO DUAL, RAIL-TO-RAIL VLTG-FDBK AMP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。