欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號： AD8129ARZ-REEL7
廠商： ANALOG DEVICES INC
元件分類： 模擬信號調理
英文描述： Low Cost 270 MHz Differential Receiver Amplifiers
中文描述： SPECIALTY ANALOG CIRCUIT, PDSO8
封裝： LEAD FREE, SOIC-8
文件頁數： 33/40頁
文件大小： 549K
代理商： AD8129ARZ-REEL7
AD8129/AD8130
APPLICATIONS
BASIC GAIN CIRCUITS
The gain of the AD8129/AD8130 can be set with a pair of
feedback resistors. The basic configuration is shown in Figure 132.
The gain equation is the same as that of a conventional op amp:
G = 1 + R
F
/R
G
. For unity-gain applications using the AD8130,
R
F
can be set to 0 (short circuit), and R
G
can be removed (see
Figure 133). The AD8129 is compensated to operate at gains of
10 and higher; therefore, shorting the feedback path to obtain
unity gain causes oscillation.
Rev. C | Page 33 of 40
R
F
R
G
–V
V
OUT
+V
V
IN
–V
S
2
PD
+V
S
+
+
AD8129/
AD8130
6
5
4
8
1
3
7
0.1
μ
F
10
μ
F
0.1
μ
F
10
μ
F
0
Figure 132. Basic Gain Circuit: V
OUT
= V
IN
(1 + R
F
/R
G
)
0.1
μ
F
–V
V
OUT
+V
0.1
μ
F
10
μ
F
V
IN
AD8130
–V
S
2
PD
+V
S
+
+
6
5
4
8
1
3
7
10
μ
F
0
Figure 133. An AD8130 with Unity Gain
The input signal can be applied either differentially or in a
single-ended fashion—all that matters is the magnitude of the
differential signal between the two inputs. For single-ended
input applications, applying the signal to the +IN with IN
grounded creates a noninverting gain, while reversing these
connections creates an inverting gain. Because the two inputs
are high impedance and matched, both of these conditions
provide the same high input impedance. Thus, an advantage of
the active feedback architecture is the ability to make a high
input impedance inverting op amp. If conventional op amps are
used, a high impedance buffer followed by an inverting stage is
needed. This requires two op amps.
TWISTED-PAIR CABLE, COMPOSITE VIDEO
RECEIVER WITH EQUALIZATION USING AN AD8130
The AD8130 has excellent common-mode rejection at its
inputs. This makes it an ideal candidate for a receiver for signals
that are transmitted over long distances on twisted-pair cables.
Category 5 cables are very common in office settings and are
extensively used for data transmission. These cables can also be
used for the analog transmission of signals such as video.
These long cables pick up noise from the environment they pass
through. This noise does not favor one conductor over another
and therefore is a common-mode signal. A receiver that rejects
the common-mode signal on the cable can greatly enhance the
signal-to-noise ratio performance of the link.
The AD8130 is also very easy to use as a differential receiver,
because the differential inputs and the feedback inputs are
entirely separate. This means that there is no interaction
between the feedback network and the termination network,
as there would be in conventional op amp types of receivers.
Another issue with long cables is that there is more attenuation
of the signal at longer distances. Attenuation is also a function
of frequency; it increases to roughly the square root of frequency.
For good fidelity of video circuits, the overall frequency
response of the transmission channel should be flat vs.
frequency. Because the cable attenuates the high frequencies, a
frequency-selective boost circuit can be used to undo this effect.
These circuits are called equalizers.
An equalizer uses frequency-dependent elements (Ls and Cs) to
create a frequency response that is the opposite of the rest of the
channel’s response to create an overall flat response. There are
many ways to create such circuits, but a common technique is to
put the frequency-selective elements in the feedback path of an
op amp circuit. The AD8130 in particular makes this easier
than other circuits, because, once again, the feedback path is
completely independent of the input path and there is no
interaction.
The circuit in Figure 134 was developed as a receiver/equalizer
for transmitting composite video over 300 meters of Category 5
cable. This cable has an attenuation of approximately 20 dB at
10 MHz for 300 meters. At 100 MHz, the attenuation is
approximately 60 dB (see Figure 135).
相關PDF資料
PDF描述
AD8130ARM-REEL Low Cost 270 MHz Differential Receiver Amplifiers
AD8130ARM-REEL7 Low Cost 270 MHz Differential Receiver Amplifiers
AD8130ARMZ Low Cost 270 MHz Differential Receiver Amplifiers
AD8130ARMZ-REEL Low Cost 270 MHz Differential Receiver Amplifiers
AD8130ARMZ-REEL7 Low Cost 270 MHz Differential Receiver Amplifiers
相關代理商/技術參數
參數描述
AD8129-EVAL 制造商:Analog Devices 功能描述:AD8129 EVALUATION BOARD
AD812AN 制造商:Analog Devices 功能描述:OP Amp Dual Current Fdbk 制造商:Rochester Electronics LLC 功能描述:DUAL LO PWR I-FDBK OP AMP - Bulk 制造商:Analog Devices 功能描述:IC OP-AMP LOW POWER
AD812ANZ 功能描述:IC OPAMP DUAL CURR-FDBK 8-DIP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件
AD812AR 功能描述:IC OPAMP DUAL CURR-FDBK 8-SOIC RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR)
AD812AR-8 制造商:Analog Devices 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*
主站蜘蛛池模板： 百色市| 宜黄县| 兰西县| 乡宁县| 鄂温| 邛崃市| 紫阳县| 荃湾区| 泊头市| 军事| 措勤县| 潮安县| 新丰县| 应用必备| 平湖市| 静海县| 长汀县| 拜城县| 封开县| 阜城县| 边坝县| 嘉祥县| 邮箱| 金坛市| 龙州县| 崇信县| 石楼县| 寿光市| 弥渡县| 大宁县| 茌平县| 汨罗市| 太康县| 马山县| 上高县| 凌源市| 元氏县| 甘泉县| 鄱阳县| 玉田县| 揭阳市|