- 您現在的位置：買賣IC網 > PDF目錄373944 > AD8348XXX (ANALOG DEVICES INC) 50-1000 MHz Quadrature Demodulator PDF資料下載
參數資料
| 型號： | AD8348XXX |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | 50-1000 MHz Quadrature Demodulator |
| 中文描述： | TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, PDSO28 |
| 封裝： | TSSOP-28 |
| 文件頁數： | 12/13頁 |
| 文件大小： | 778K |
| 代理商： | AD8348XXX |
PRELIMINARY TECHNICAL DATA
Rev. PrF 2/11/03
- 12 -
Table I Evaluation Board Configuration Options
Function
Power Supply and Ground Vector Pins
Device Enable:
Place SW11 in the ENBL position to connect the ENBL
pin to +Vs. Place in the DENBL position to disable the device by
grounding the pin ENBL through a 50 Ohm pull down resistor. The
device may also be enabled via an external voltage applied to ENBL or
VENB.
Gain Control Selection:
With SW13 in the POT position the gain of the
VGA can be set using the potentiometer R15. With SW13 in the EXT
position the VGA gain can be set by an external voltage to SMA connector
VGIN. For VGA operation the VGA must first be enabled by setting
SW12 to the IF position.
VGA Enable Selection:
With SW12 in the IF position, the ENVG pin is
connected to +Vs and the VGA is enabled. The IF input should be used
when SW12 is in the IF position. With SW12 in the MX position the
ENVG pin is grounded and the VGA is disabled. The MX inputs should
be used when SW12 is in the MX position.
IF Input:
The single-ended IF signal should be connected to this SMA
connector. R31 and R32 form a L-pad that presents a 50 Ohm termination
to the input.
Mixer Inputs:
These inputs can be configured for either differential or
single-ended operation. The default is single-ended operation with T41
and R42 installed. In single-ended mode the input is applied to the 50
Ohm SMA connector MXIP. For differential drive, T41 should be
removed along with resistor R42. DC blocking capacitors (C42, C43)
should be installed in place of T41. This will present a nominal
differential impedance of 200 Ohms (100 Ohms each side). The
differential inputs should then be fed into SMA connectors MXIP and
MXIN.
Baseband Amplifier Output Bias
: Installing LK11 connects VREF to
VCMO. This sets the bias level on the baseband amplifiers to V
REF
which
is equal to approximately 1V. Alternatively, with LK11 removed, the bias
level of the baseband amplifiers can be set by applying an external voltage
to the VCMO testpoint.
Baseband Amplifier Outputs and Output Filter:
Additional low-pass
filtering can be provided at the baseband output with these filters.
Mixer Output DC Blocking Capacitors:
The mixer outputs are biased to
VCMO. To prevent damage to test equipment that cannot tolerate DC
biases, C10 is provided to block the DC component, thus protecting the
test equipment.
Baseband Filter:
These components are provided for baseband filtering
between the mixer outputs and the baseband amplifier inputs. The
baseband amplifier input impedance is high and the filter termination
impedance is set by R2. See Table II below for jumper settings.
Offset Compensation Loop Disable:
Installing these jumpers will
disable the offset compensation loop for the corresponding channel.
Component
+Vs, GND
SW11, ENBL
Default Condition
Not Applicable
SW11 = ENBL
SW13, R15,
VGIN
SW2 = POT
SW12
SW12 = IF
IFIP, R31, R32
R31 = 57.6 Ohms
R32 = 174 Ohms
MXIP, MXIN
T41, R42
C42, C43
T41 = ETC4-1-2
R42 = 0 Ohms
LK11, VCMO
LK11 Installed
C8, C9, R4, R5
(I and Q)
C10 (I and Q)
R4, R5 = 0 Ohms
C10 = 0 Ohms
C1 – C7
R1, R2
L1 – L3
(I and Q)
LK5 (I and Q)
All = OPEN
LK5x = OPEN
AD8348
相關PDF資料 |
PDF描述 |
|---|---|
| AD8349 | 700 MHz to 2700 MHz Quadrature Modulator |
| AD8349ARE | 700 MHz to 2700 MHz Quadrature Modulator |
| AD8349ARE-REEL7 | 700 MHz to 2700 MHz Quadrature Modulator |
| AD8350 | Low Distortion 1.0 GHz Differential Amplifier |
| AD8350AR15 | Low Distortion 1.0 GHz Differential Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8349 | 制造商:AD 制造商全稱:Analog Devices 功能描述:400 MHz to 6 GHz Broadband Quadrature Modulator |
| AD8349ARE | 制造商:Analog Devices 功能描述:Quadrature Mod 160MHz 16-Pin TSSOP EP Tube 制造商:Rochester Electronics LLC 功能描述:DIRECT QUADRATURE MODULATOR - Bulk 制造商:Analog Devices 功能描述:IC MODULATOR QUADRATURE |
| AD8349ARE-REEL7 | 功能描述:IC QUADRATURE MOD 700MHZ 16TSSOP RoHS:否 類別:RF/IF 和 RFID >> RF 調制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:調制器 LO 頻率:700MHz ~ 2.3GHz RF 頻率:700MHz ~ 2.3GHz P1dB:1dBm 底噪:-148dBm/Hz 輸出功率:-1dBm 電流 - 電源:46mA 電源電壓:2.7 V ~ 3.6 V 測試頻率:1.75GHz 封裝/外殼:28-WFQFN 裸露焊盤 包裝:帶卷 (TR) |
| AD8349AREZ | 功能描述:IC QUADRATURE MOD 700MHZ 16TSSOP RoHS:是 類別:RF/IF 和 RFID >> RF 調制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:調制器 LO 頻率:700MHz ~ 2.3GHz RF 頻率:700MHz ~ 2.3GHz P1dB:1dBm 底噪:-148dBm/Hz 輸出功率:-1dBm 電流 - 電源:46mA 電源電壓:2.7 V ~ 3.6 V 測試頻率:1.75GHz 封裝/外殼:28-WFQFN 裸露焊盤 包裝:帶卷 (TR) |
| AD8349AREZ-RL7 | 功能描述:IC MOD QUAD 2.7GHZ 16TSSOP RoHS:是 類別:RF/IF 和 RFID >> RF 調制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:調制器 LO 頻率:700MHz ~ 2.3GHz RF 頻率:700MHz ~ 2.3GHz P1dB:1dBm 底噪:-148dBm/Hz 輸出功率:-1dBm 電流 - 電源:46mA 電源電壓:2.7 V ~ 3.6 V 測試頻率:1.75GHz 封裝/外殼:28-WFQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。