- 您現在的位置：買賣IC網 > PDF目錄373947 > AD8510ARM-R2 (ANALOG DEVICES INC) Precision, Very Low Noise, Low Input Bias Current, Wide Bandwidth JFET Operational Amplifiers PDF資料下載
參數資料
| 型號： | AD8510ARM-R2 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | Precision, Very Low Noise, Low Input Bias Current, Wide Bandwidth JFET Operational Amplifiers |
| 中文描述： | OP-AMP, 1800 uV OFFSET-MAX, 8 MHz BAND WIDTH, PDSO8 |
| 封裝： | MO-187AA, MSOP-8 |
| 文件頁數： | 13/20頁 |
| 文件大小： | 497K |
| 代理商： | AD8510ARM-R2 |
AD8510/AD8512/AD8513
GENERAL APPLICATION INFORMATION
INPUT OVERVOLTAGE PROTECTION
The AD8510/AD8512/AD8513 have internal protective
circuitry that allows voltages as high as 0.7 V beyond the
supplies to be applied at the input of either terminal without
causing damage. For higher input voltages, a series resistor is
necessary to limit the input current. The resistor value can be
determined from the formula
Rev. E | Page 13 of 20
mA
5
R
V
V
S
S
IN
≤
With a very low offset current of <0.5 nA up to 125°C, higher
resistor values can be used in series with the inputs. A 5 k
resistor will protect the inputs to voltages as high as 25 V
beyond the supplies and will add less than 10 μV to the offset.
OUTPUT PHASE REVERSAL
Phase reversal is a change of polarity in the transfer function of
the amplifier. This can occur when the voltage applied at the
input of an amplifier exceeds the maximum common-mode
voltage.
Phase reversal can cause permanent damage to the device and
may result in system lockups. The AD8510/AD8512/AD8513 do
not exhibit phase reversal when input voltages are beyond the
supplies.
TIME (20
μ
s/DIV)
0
V
V
IN
V
OUT
V
SY
= ±5V
A
V
= 1
R
L
= 10k
Figure 41. No Phase Reversal
THD + NOISE
The AD8510/AD8512/AD8513 have low total harmonic distor-
tion and excellent gain linearity, making these amplifiers a great
choice for precision circuits with high closed-loop gain, and for
audio application circuits. Figure 42 shows that the AD8510/
AD8512/AD8513 have approximately 0.0005% of total distor-
tion when configured in positive unity gain (the worst case) and
driving a 100 k load.
FREQUENCY (Hz)
D
0
0.01
0.001
0.000120
100
1k
20k
V
SY
= ±5V
R
= 100k
BW = 22kHz
Figure 42. THD + N vs. Frequency
TOTAL NOISE INCLUDING SOURCE RESISTORS
The low input current noise and input bias current of the
AD8510/AD8512/AD8513 make them the ideal amplifiers for
circuits with substantial input source resistance. Input offset
voltage increases by less than 15 nV per 500 of source
resistance at room temperature. The total noise density of the
circuit is
(
)
S
S
n
n
nTOTAL
kTR
R
i
e
e
4
2
2
+
+
=
where:
e
n
is the input voltage noise density of the parts.
i
n
is the input current noise density of the parts.
R
S
is the source resistance at the noninverting terminal.
k
is Boltzman’s constant (1.38 × 10
–23
J/K).
T
is the ambient temperature in Kelvin (T = 273 + °C).
For
R
S
< 3.9 k,
e
n
dominates and
e
nTOTAL
≈
e
n
.
The current noise of the AD8510/AD8512/AD8513 is so low
that its total density does not become a significant term unless
R
S
is greater than 165 M, an impractical value for most
applications.
The total equivalent rms noise over a specific bandwidth is
expressed as
BW
e
e
nTOTAL
nTOTAL
=
where
BW
is the bandwidth in Hertz.
Note that the above analysis is valid for frequencies larger than
150 Hz and assumes flat noise above 10 kHz. For lower frequen-
cies, flicker noise (1/f) must be considered.
相關PDF資料 |
PDF描述 |
|---|---|
| AD8510ARM-REEL | Precision, Very Low Noise, Low Input Bias Current, Wide Bandwidth JFET Operational Amplifiers |
| AD8510ARZ | Precision, Very Low Noise, Low Input Bias Current, Wide Bandwidth JFET Operational Amplifiers |
| AD8510BR | Precision, Very Low Noise, Low Input Bias Current, Wide Bandwidth JFET Operational Amplifiers |
| AD8512 | Precision, Very Low Noise, Low Input Bias Current, Wide Bandwidth JFET Operational Amplifiers |
| AD8512AR | Precision, Very Low Noise, Low Input Bias Current, Wide Bandwidth JFET Operational Amplifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8510ARM-REEL | 制造商:Analog Devices 功能描述:OP Amp Single GP 制造商:Analog Devices 功能描述:OP Amp Single GP ±15V 8-Pin MSOP T/R |
| AD8510ARMZ | 功能描述:IC OPAMP JFET 8MHZ PREC LN 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
| AD8510ARMZ-R2 | 功能描述:IC OPAMP JFET 8MHZ PREC LN 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR) |
| AD8510ARMZ-REEL | 功能描述:IC OPAMP JFET 8MHZ PREC LN 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| AD8510AR-REEL | 制造商:Analog Devices 功能描述:OP Amp Single GP 制造商:Analog Devices 功能描述:OP Amp Single GP ±15V 8-Pin SOIC N T/R |
發布緊急采購，3分鐘左右您將得到回復。