- 您現在的位置：買賣IC網 > PDF目錄373960 > AD9216BCPZ-80 (ANALOG DEVICES INC) 10-Bit, 65/80/105 MSPS Dual A/D Converter PDF資料下載
參數資料
| 型號： | AD9216BCPZ-80 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | ADC |
| 英文描述： | 10-Bit, 65/80/105 MSPS Dual A/D Converter |
| 中文描述： | 2-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, QCC64 |
| 封裝： | 9 X 9 MM, LEAD FREE, MO-220-VMMD, LFCSP-64 |
| 文件頁數： | 16/20頁 |
| 文件大小： | 298K |
| 代理商： | AD9216BCPZ-80 |
AD9216
Preliminary Technical Data
The data format can be selected for either offset binary or twos
complement. This is discussed later in the Data Format section.
Rev. PrD
Page 16 of 20
6/15/2004
TIMING
The AD9216 provides latched data outputs with a pipeline
delay of six clock cycles. Data outputs are available one
propagation delay (t
) after the rising edge of the clock signal.
Refer to Figure 2 for a detailed timing diagram.
The internal duty cycle stabilizer can be enabled on the
AD9216 using the DCS pin. This provides a stable 50% duty
cycle to internal circuits.
The length of the output data lines and loads placed on them
should be minimized to reduce transients within the AD9216.
These transients can detract from the converter’s dynamic
performance. The lowest typical conversion rate of the AD9216
is 1 MSPS. At clock rates below 1 MSPS, dynamic
performance may degrade.
Figure 6.
NEEDS UPDATING
Example of Multiplexed Data Format Using the Channel A Output and the Same Clock Tied to CLK_A, CLK_B, and
MUX_SELECT
DATA FORMAT
The AD9216 data output format can be configured for either
twos complement or offset binary. This is controlled by the
Data Format Select pin (DFS). Connecting DFS to AGND will
produce offset binary output data. Conversely, connecting DFS
to AVDD will format the output data as twos complement.
The output data from the dual A/D converters can be
multiplexed onto a single 10-Bits output bus. The multiplexing
is accomplished by toggling the MUX_SELECT bit, which
directs channel data to the same or opposite channel data port.
When MUX_SELECT is logic high, the Channel A data is
directed to Channel A output bus, and Channel B data is
directed to the Channel B output bus. When MUX_SELECT is
logic low, the channel data is reversed, i.e., Channel A data is
directed to the Channel B output bus and Channel B data is
directed to the Channel A output bus. By toggling the
MUX_SELECT bit, multiplexed data is available on either of
the output data ports.
If the ADCs are run with synchronized timing, this same clock
can be applied to the MUX_SELECT bit. After the
MUX_SELECT rising edge, either data port will have the data
for its respective channel; after the falling edge, the alternate
channel’s data will be placed on the bus. Typically, the other
unused bus would be disabled by setting the appropriate OEB
high to reduce power consumption and noise. Figure 6 shows
an example of multiplex mode. When multiplexing data, the
data rate is two times the sample rate. Note that both channels
must remain active in this mode and that each channel's power-
down pin must remain low.
相關PDF資料 |
PDF描述 |
|---|---|
| AD9216BCPZRL7-105 | 10-Bit, 65/80/105 MSPS Dual A/D Converter |
| AD9216BCPZRL7-80 | 10-Bit, 65/80/105 MSPS Dual A/D Converter |
| AD9218BST-80 | 10-Bit, 40/65/80/105 MSPS 3 V Dual A/D Converter |
| AD9218BST-105 | 10-Bit, 40/65/80/105 MSPS 3 V Dual A/D Converter |
| AD9218 | 10-Bit, 40/65/80/105 MSPS 3 V Dual A/D Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD9216BCPZRL7-105 | 功能描述:IC ADC 10BIT DL 105MSPS 64-LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| AD9216BCPZRL7-65 | 功能描述:IC ADC 10BIT DUAL 65MSPS 64LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| AD9216BCPZRL7-80 | 功能描述:IC ADC 10BIT DUAL 80MSPS 64LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| AD9218 | 制造商:AD 制造商全稱:Analog Devices 功能描述:10-Bit, 40/65/80/105 MSPS 3 V Dual A/D Converter |
| AD9218_06 | 制造商:AD 制造商全稱:Analog Devices 功能描述:10-Bit, 40/65/80/105 MSPS 3 V Dual Analog-to-Digital Converter |
發布緊急采購，3分鐘左右您將得到回復。