- 您現在的位置：買賣IC網 > PDF目錄373987 > ADG528FBP (ANALOG DEVICES INC) 4/8 Channel Fault-Protected Analog Multiplexers PDF資料下載
參數資料
| 型號： | ADG528FBP |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | 4/8 Channel Fault-Protected Analog Multiplexers |
| 中文描述： | 8-CHANNEL, SGL ENDED MULTIPLEXER, PQCC20 |
| 封裝： | PLASTIC, MO-047AA, LCC-20 |
| 文件頁數： | 7/12頁 |
| 文件大小： | 170K |
| 代理商： | ADG528FBP |
ADG508F/ADG509F/ADG528F
REV. C
–7–
THEORY OF OPERATION
The ADG508F/ADG509F/ADG528F multiplexers are capable
of withstanding overvoltages from –40 V to +55 V, irrespective
of whether the power supplies are present or not. Each channel
of the multiplexer consists of an n-channel MOSFET, a p-
channel MOSFET and an n-channel MOSFET, connected in
series. When the analog input exceeds the power supplies, one
of the MOSFETs will switch off, limiting the current to sub-
microamp levels, thereby preventing the overvoltage from dam-
aging any circuitry following the multiplexer. Figure 12 illustrates
the channel architecture that enables these multiplexers to with-
stand continuous overvoltages.
When an analog input of V
SS
+ 3 V to V
DD
– 1.5 V is applied to
the ADG508F/ADG509F/ADG528F, the multiplexer behaves
as a standard multiplexer, with specifications similar to a stan-
dard multiplexer, for example, the on-resistance is 400
maxi-
mum. However, when an overvoltage is applied to the device,
one of the three MOSFETs will turn off.
Figures 12 to 15 show the conditions of the three MOSFETs for
the various overvoltage situations. When the analog input ap-
plied to an ON channel approaches the positive power supply
line, the n-channel MOSFET turns OFF since the voltage on
the analog input exceeds the difference between V
DD
and the
Q1
Q2
Q3
+55V
OVERVOLTAGE
n-CHANNEL
MOSFET IS
OFF
V
DD
V
SS
Figure 12. +55 V Overvoltage Input to the ON Channel
Q1
Q2
Q3
–40V
OVERVOLTAGE
n-CHANNEL
MOSFET IS
ON
V
DD
V
SS
p-CHANNEL
MOSFET IS
OFF
Figure 13. –40 V Overvoltage on an OFF Channel with
Multiplexer Power ON
n-channel threshold voltage (V
TN
). When a voltage more nega-
tive than V
SS
is applied to the multiplexer, the p-channel
MOSFET will turn off since the analog input is more negative
than the difference between V
SS
and the p-channel threshold
voltage (V
TP
). Since V
TN
is nominally 1.5 V and V
TP
is typically
3 V, the analog input range to the multiplexer is limited to
–12 V to +13.5 V when a
±
15 V power supply is used.
When the power supplies are present but the channel is off,
again either the p-channel MOSFET or one of the n-channel
MOSFETs will turn off when an overvoltage occurs.
Finally, when the power supplies are off, the gate of each
MOSFET will be at ground. A negative overvoltage switches
on the first n-channel MOSFET but the bias produced by the
overvoltage causes the p-channel MOSFET to remain turned
off. With a positive overvoltage, the first MOSFET in the
series will remain off since the gate to source voltage applied to
this MOSFET is negative.
During fault conditions, the leakage current into and out of the
ADG508F/ADG509F/ADG528F is limited to a few microamps.
This protects the multiplexer and succeeding circuitry from over
stresses as well as protecting the signal sources which drive the
multiplexer. Also, the other channels of the multiplexer will be
undisturbed by the overvoltage and will continue to operate
normally.
Q1
Q2
Q3
+55V
OVERVOLTAGE
n-CHANNEL
MOSFET IS
OFF
Figure 14. +55 V Overvoltage with Power OFF
Q1
Q2
Q3
–40V
OVERVOLTAGE
n-CHANNEL
MOSFET IS
ON
p-CHANNEL
MOSFET IS
OFF
Figure 15. –40 V Overvoltage with Power OFF
相關PDF資料 |
PDF描述 |
|---|---|
| ADG508F | 4/8 Channel Fault-Protected Analog Multiplexers |
| ADG509ABQ | CMOS 4/8 CHAANNEL ANALOG MULTIPLEXERS |
| ADG509AKN | CMOS 4/8 CHAANNEL ANALOG MULTIPLEXERS |
| ADG508FBN | 4/8 Channel Fault-Protected Analog Multiplexers |
| ADG508FBRN | 4/8 Channel Fault-Protected Analog Multiplexers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADG528FBP-REEL | 制造商:Analog Devices 功能描述:Analog Multiplexer Single 8:1 20-Pin PLCC T/R |
| ADG528FBPZ | 功能描述:IC MULTIPLEXER 8X1 20PLCC RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關，多路復用器，多路分解器 系列:- 應用說明:Ultrasound Imaging Systems Application Note 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:250 系列:- 功能:開關 電路:單刀單擲 導通狀態電阻:48 歐姆 電壓電源:單電源 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V 電流 - 電源:5µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:48-LQFP 供應商設備封裝:48-LQFP（7x7） 包裝:托盤 |
| ADG528FTQ | 制造商:AD 制造商全稱:Analog Devices 功能描述:4/8 Channel Fault-Protected Analog Multiplexers |
| ADG528FTQ/883B | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Channel Analog Multiplexer |
| ADG5298HFRZ | 功能描述:1 Circuit IC Switch 8:1 350 Ohm 16-CFlatPack 制造商:analog devices inc. 系列:- 包裝:散裝 零件狀態:在售 開關電路:- 多路復用器/解復用器電路:8:1 電路數:1 導通電阻（最大值）:350 歐姆 通道至通道匹配（ΔRon）:1.5 歐姆 電壓 -?電源，單（V+）:9 V ~ 40 V 電壓 - 電源，雙（V±）:±9 V ~ 22 V 開關時間（Ton, Tof）（最大值）:245ns，260ns -3db 帶寬:121MHz 電荷注入:0.4pC 溝道電容 （CS(off），CD（off））:2.8pF，33pF 電流 - 漏泄（IS（off））（最大值）:8nA 串擾:-80dB @ 1MHz 工作溫度:-55°C ~ 210°C（TA） 封裝/外殼:16-CFlatPack 供應商器件封裝:16-CFlatPack 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。