- 您現在的位置：買賣IC網 > PDF目錄373993 > ADG904 (Analog Devices, Inc.) Wideband, 37 dB Isolation at 1 GHz, CMOS 1.65 V to 2.75 V, 4:1 Mux/SP4T PDF資料下載
參數資料
| 型號： | ADG904 |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | Wideband, 37 dB Isolation at 1 GHz, CMOS 1.65 V to 2.75 V, 4:1 Mux/SP4T |
| 中文描述： | 寬帶，37月1 GHz的分貝的CMOS 1.65 V至2.75 V的隔離，4:1 Mux/SP4T |
| 文件頁數： | 6/16頁 |
| 文件大小： | 354K |
| 代理商： | ADG904 |
ADG904/ADG904-R
TERMINOLOGY
Table 5.
Parameter
V
DD
I
DD
GND
Ax
V
INL
V
INH
I
INL
(I
INH
)
C
IN
t
ON (EN)
t
OFF (EN)
t
RISE
t
FALL
t
TRANS
Off Isolation
Insertion Loss
Crosstalk
P
–1 dB
Rev. 0 | Page 6 of 16
Description
Most Positive Power Supply Potential.
Positive Supply Current.
Ground (0 V) Reference.
Logic Control Input.
Maximum Input Voltage for Logic 0.
Minimum Input Voltage for Logic 1.
Input Current of the Digital Input.
Digital Input Capacitance.
Delay between Applying the EN Control Input and the Output Switching On.
Delay between Applying the EN Control Input and the Output Switching Off.
Rise Time. Time for the RF signal to rise from 10% of the On level to 90% of the On level.
Fall Time. Time for the RF signal to fall from 90% of the On level to 10% of the On level.
Transition Time. Delay between applying the digital control input and the output switching on.
The Attenuation between Input and Output Ports of the Switch when the Switch Control Voltage is in the Off Condition.
The Attenuation between Input and Output Ports of the Switch when the Switch Control Voltage is in the On Condition.
Measure of Unwanted Signal Coupled through from One Channel to Another as a Result of Parasitic Capacitance.
1 dB Compression Point. The RF input power level at which the switch insertion loss increases by 1 dB over its low level
value. P
–1 dB
is a measure of how much power the On switch can handle before the insertion loss increases by 1 dB.
Third Order Intermodulation Intercept. This is a measure of the power in false tones that occur when closely spaced tones
are passed through a switch, whereby the nonlinearity of the switch causes these false tones to be generated.
The Amount of Reflected Power Relative to the Incident Power at a Port. Large return loss indicates good matching. By
measuring return loss, the VSWR can be calculated from conversion charts. VSWR (voltage standing wave ratio) indicates
the degree of matching present at a switch RF port.
Spurious Signals Present at the RF ports of the Switch when the Control Voltage is Switched from High to Low or Low to
High without an RF Signal Present.
IP
3
Return Loss
Video
Feedthrough
相關PDF資料 |
PDF描述 |
|---|---|
| ADG904-R | Wideband, 37 dB Isolation at 1 GHz, CMOS 1.65 V to 2.75 V, 4:1 Mux/SP4T |
| ADG904BRU | Wideband, 37 dB Isolation at 1 GHz, CMOS 1.65 V to 2.75 V, 4:1 Mux/SP4T |
| ADG904BRU-500RL7 | Wideband, 37 dB Isolation at 1 GHz, CMOS 1.65 V to 2.75 V, 4:1 Mux/SP4T |
| ADG904BRU-R | Wideband, 37 dB Isolation at 1 GHz, CMOS 1.65 V to 2.75 V, 4:1 Mux/SP4T |
| ADG904BRU-R-500RL7 | Wideband, 37 dB Isolation at 1 GHz, CMOS 1.65 V to 2.75 V, 4:1 Mux/SP4T |
相關代理商/技術參數 |
參數描述 |
|---|---|
| adg904bcp | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| ADG904BCP-500RL7 | 制造商:Analog Devices 功能描述:Analog Multiplexer Single 4:1 20-Pin LFCSP EP T/R |
| adg904bcp-r | 制造商:Analog Devices 功能描述: 制造商:Rochester Electronics LLC 功能描述: |
| ADG904BCP-REEL7 | 制造商:Analog Devices 功能描述:ANLG MUX SGL 4:1 2.75V 20LFCSP - Tape and Reel |
| ADG904BCPZ | 功能描述:IC MULTIPLEXER 4X1 20LFCSP RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關，多路復用器，多路分解器 系列:- 標準包裝:1,000 系列:- 功能:多路復用器 電路:1 x 4:1 導通狀態電阻:- 電壓電源:雙電源 電壓 - 電源，單路/雙路(±):±5V 電流 - 電源:7mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。