- 您現在的位置：買賣IC網 > PDF目錄373993 > ADL5375-15-EVALZ1 (Analog Devices, Inc.) 400 MHz to 6 GHz Broadband Quadrature Modulator PDF資料下載
參數資料
| 型號： | ADL5375-15-EVALZ1 |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | 400 MHz to 6 GHz Broadband Quadrature Modulator |
| 中文描述： | 400 MHz至6 GHz的寬帶正交調制器 |
| 文件頁數： | 20/32頁 |
| 文件大小： | 1074K |
| 代理商： | ADL5375-15-EVALZ1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
ADL5375
BASIC CONNECTIONS
Rev. 0 | Page 20 of 32
VPS1
RFOUT
COMM
NC
COMM
NC
NC
Q
C
N
Q
C
C
V
I
C
I
C
C
DSOP
VPOS
B
A
LOIP
COMM
LOIN
COMM
1
2
3
4
5
6
18
17
16
15
14
13
C1
1000pF
C6
1000pF
C5
0.1μF
C3
1000pF
2
2
2
2
2
1
7
8
9
1
1
1
VPOS
RFOUT
EXPOSED PADDLE
Z1
ADL5375
0
GND
C2
1000pF
C4
0.1μF
QBBN
QBBP
LOIP
C7
1000pF
IBBN
IBBP
VPOS
S1
Figure 54. Basic Connections for the ADL5375
Figure 54 shows the basic connections for the ADL5375.
POWER SUPPLY AND GROUNDING
Pin VPS1 and Pin VPS2 should be connected to the same 5 V
source. Each pin should be decoupled with a 100 pF and
0.1 μF capacitor. These capacitors should be located as close
as possible to the device. The power supply can range between
4.75 V and 5.25 V.
The ten COMM pins should be tied to the same ground plane
through low impedance paths.
The exposed paddle on the underside of the package should also
be soldered to a ground plane with low thermal and electrical
impedance. If the ground plane spans multiple layers on the
circuit board, they should be stitched together with nine vias
under the exposed paddle as illustrated in the Evaluation Board
section. The AN-772 application note discusses the thermal and
electrical grounding of the LFCSP (QFN) package in detail.
BASEBAND INPUTS
The baseband inputs (IBBP, IBBN, QBBP, and QBBN) should be
driven from a differential source. The nominal drive level used
in the characterization of the ADL5375 is 1 V p-p differential
(or 500 mV p-p on each pin).
All the baseband inputs must be externally dc biased. The
recommended common-mode level is dependent on the
version of the ADL5375.
ADL5375-05: 500 mV
ADL5375-15: 1500 mV
LO INPUT
The LO input is designed to be driven from a single-ended
source. The LO source is ac-coupled through a series capacitor
to the LOIP pin while the LOIN pin is ac-coupled to ground
through a second capacitor.
The typical LO drive level, which was used for the
characterization of the ADL5375, is 0 dBm.
Differential operation is also possible, in which case both sides
of the differential LO source should be ac-coupled through a
pair of series capacitors to the LOIP and LOIN pins.
RF OUTPUT
The RF output is available at the RFOUT pin (Pin 16), which can
drive a 50 Ω load. The internal balun provides a low dc path to
ground. In most situations, the RFOUT pin must be ac-coupled
to the load.
相關PDF資料 |
PDF描述 |
|---|---|
| ADL5387 | 50 MHz to 2 GHz Quadrature Demodulator |
| ADL5387ACPZ-R71 | 50 MHz to 2 GHz Quadrature Demodulator |
| ADL5387ACPZ-WP1 | 50 MHz to 2 GHz Quadrature Demodulator |
| ADL5387-EVALZ1 | 50 MHz to 2 GHz Quadrature Demodulator |
| ADL5390-EVAL | RF/IF Vector Multiplier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADL5375ACPZ-R7 | 制造商:AD 制造商全稱:Analog Devices 功能描述:400 MHz to 6 GHz Broadband Quadrature Modulator |
| ADL5380 | 制造商:AD 制造商全稱:Analog Devices 功能描述:400 MHz to 6 GHz Quadrature Demodulator |
| ADL5380-29A-EVALZ | 功能描述:BOARD EVAL FOR ADL5380-29A RoHS:是 類別:RF/IF 和 RFID >> RF 評估和開發套件，板 系列:- 標準包裝:1 系列:- 類型:GPS 接收器 頻率:1575MHz 適用于相關產品:- 已供物品:模塊 其它名稱:SER3796 |
| ADL5380-30A-EVALZ | 功能描述:BOARD EVAL FOR ADL5380-30A RoHS:是 類別:RF/IF 和 RFID >> RF 評估和開發套件，板 系列:- 標準包裝:1 系列:- 類型:GPS 接收器 頻率:1575MHz 適用于相關產品:- 已供物品:模塊 其它名稱:SER3796 |
| ADL5380ACPZ | 制造商:Analog Devices 功能描述:IC DEMOD QUAD I-Q 0.4-6GHZ 24LFCSP 制造商:Analog Devices 功能描述:IC, DEMOD, QUAD, I-Q, 0.4-6GHZ, 24LFCSP 制造商:Analog Devices 功能描述:IC, DEMOD, QUAD, I-Q, 0.4-6GHZ, 24LFCSP, Frequency Min:400MHz, Frequency Max:6GHz, RF Type:GSM, W-CDMA, WiMAX, Supply Voltage Min:4.75V, Supply Voltage Max:5.25V, RF IC Case Style:LFCSP, No. of Pins:24, Operating Temperature |
發布緊急采購，3分鐘左右您將得到回復。