- 您現在的位置：買賣IC網 > PDF目錄373994 > ADL5501-EVALZ (Analog Devices, Inc.) 50 MHz to 4 GHz TruPwr Detector PDF資料下載
參數資料
| 型號： | ADL5501-EVALZ |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | 50 MHz to 4 GHz TruPwr Detector |
| 中文描述： | 50 MHz至4 GHz TruPwr檢測器 |
| 文件頁數： | 18/28頁 |
| 文件大小： | 1654K |
| 代理商： | ADL5501-EVALZ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ADL5501
INPUT COUPLING USING A SERIES RESISTOR
Figure 43 shows a technique for coupling the input signal into
the ADL5501 that can be applicable where the input signal is
much larger than the input range of the ADL5501. A series
resistor combines with the input impedance of the ADL5501
to attenuate the input signal. Because this series resistor forms
a divider with the frequency dependent input impedance, the
apparent gain changes greatly with frequency. However, this
method has the advantage of very little power being tapped off
in RF power transmission applications. If the resistor is large
compared to the transmission line’s impedance, the VSWR of
the system is relatively unaffected.
Rev. 0 | Page 18 of 28
ADL5501
RFIN
RFIN
R
SERIES
0
Figure 43. Attenuating the Input Signal
The resistive tap or series resistance, R
SERIES
, can expressed as
R
SERIES
=
R
IN
(1 10
ATTN
/20
)/(10
ATTN
/20
)
where:
R
IN
is the input impedance of RFIN.
ATTN
is the desired attenuation factor in dB.
For example, if a power amplifier with a maximum output power
of +28 dBm is matched to the ADL5501 input at +5 dBm, then
a 23 dB attenuation factor is required. At 900 MHz, the input
resistance, R
IN
, is 55 Ω.
R
SERIES
= (55
Ω)(1 10
23/20
)/(10
23/20
) = 722 Ω
Thus, for an attenuation of 23 dB, a series resistance of
approximately 722 Ω is needed.
MULTIPLE RF INPUTS
Figure 44 shows a technique for combining multiple RF input
signals to the ADL5501. Some applications can share a single
detector for multiple bands. Three 16.5 Ω resistors in a T-network
combine the three 50 Ω terminations (including the ADL5501).
The broadband resistive combiner ensures each port of the
T-network sees a 50 Ω termination. Because there are only 6 dB
of isolation from one port of the combiner to the other ports,
only one band should be active at a time.
(1)
(2)
ADL5501
RFIN
BAND 1
50
BAND 2
DIRECTIONAL
COUPLER
16.5
50
16.5
16.5
DIRECTIONAL
COUPLER
0
Figure 44. Combining Multiple RF Input Signals
SELECTING THE SQUARE-DOMAIN FILTER AND
OUTPUT LOW-PASS FILTER
The internal filter capacitor of the ADL5501 provides averaging
in the square domain but leaves some residual ac on the output.
Signals with high peak-to-average ratios, such as W-CDMA or
CDMA2000, can produce ac-residual levels on the ADL5501
dc output. To reduce the effects of these low frequency components
in the waveforms, some additional filtering is required.
The square-domain filter capacitance of the ADL5501 can be
augmented by connecting a capacitor between Pin 2 (FLTR) and
Pin 1 (VPOS). In addition, the output of the ADL5501 can be
filtered directly by placing a capacitor between VRMS (Pin 6)
and ground. The combination of the on-chip, 100 Ω output
series resistance and the external shunt capacitor forms a low-
pass filter to reduce the residual ac.
Table 4 shows the effect of several capacitor values for various
communications standards with high peak-to-average ratios
along with the residual ripple at the output, in peak-to-peak and
rms volts. Note that large load capacitances increase the turn-on
and pulse response times (see Figure 30, Figure 32, Figure 33,
Figure 35, Figure 37, and Figure 38). For more information on
the effects of the filter capacitances on the response, see the
Power Consumption, Enable, and Power-On/-Off Response
Time section.
相關PDF資料 |
PDF描述 |
|---|---|
| ADL5519 | 1 MHz to 10 GHz, 50 dB Dual Log Detector/Controller |
| ADL5519ACPZ-R2 | 1 MHz to 10 GHz, 50 dB Dual Log Detector/Controller |
| ADL5519ACPZ-R7 | 1 MHz to 10 GHz, 50 dB Dual Log Detector/Controller |
| ADL5519ACPZ-WP | 1 MHz to 10 GHz, 50 dB Dual Log Detector/Controller |
| ADL5519-EVALZ | 1 MHz to 10 GHz, 50 dB Dual Log Detector/Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADL5501-EVALZ1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:50 MHz to 6 GHz TruPwr Detector |
| ADL5502 | 制造商:AD 制造商全稱:Analog Devices 功能描述:450 MHz to 6000 MHz Crest Factor Detector |
| ADL5502_1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:450 MHz to 6000 MHz Crest Factor Detector |
| ADL5502ACBZ-P2 | 制造商:Analog Devices 功能描述:ADL5502: 450 MHZ TO 6000 MHZ CREST FACTOR DETECTOR - Tape and Reel |
| ADL5502ACBZ-P7 | 功能描述:IC RMS CF DET 0.45-6GHZ-8WLCSP RoHS:是 類別:RF/IF 和 RFID >> RF 檢測器 系列:- 產品變化通告:Product Discontinuation 15/May/2006 標準包裝:3,000 系列:- 頻率:100MHz ~ 2GHz RF 型:手機，GSM，DCS，PCS 輸入范圍:- 精確度:- 電源電壓:2.7 V ~ 5.5 V 電流 - 電源:300µA 包裝:帶卷 (TR) 封裝/外殼:SC-74，SOT-457 其它名稱:NCS5000SNT1GOS |
發布緊急采購，3分鐘左右您將得到回復。