- 您現在的位置：買賣IC網 > PDF目錄373999 > ADM202EARW (ANALOG DEVICES INC) 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors PDF資料下載
參數資料
| 型號： | ADM202EARW |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 通用總線功能 |
| 英文描述： | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| 中文描述： | DUAL LINE TRANSCEIVER, PDSO16 |
| 封裝： | MS-013AA, SOIC-16 |
| 文件頁數： | 4/12頁 |
| 文件大小： | 163K |
| 代理商： | ADM202EARW |
ADM202E/ADM1181A
–4–
REV. 0
GE NE RAL DE SCRIPT ION
T he ADM202E/ADM1181E are ruggedized RS-232 line drivers/
receivers. Step-up voltage converters coupled with level shifting
transmitters and receivers allow RS-232 levels to be developed
while operating from a single +5 V supply.
Features include low power consumption, high transmission
rates and compatibility with the EU directive on Electromag-
netic compatibility. EM compatibility includes protection
against radiated and conducted interference including high
levels of Electrostatic Discharge.
All inputs and outputs contain protection against Electrostatic
Discharges up to
±
15 kV and Electrical Fast T ransients up to
±
2 kV. T his ensures compliance to IE1000-4-2 and IEC1000-4-4
requirements.
T he devices are ideally suited for operation in electrically harsh
environments or where RS-232 cables are frequently being
plugged/unplugged. T hey are also immune to high RF field
strengths without special shielding precautions.
CMOS technology is used to keep the power dissipation to an
absolute minimum allowing maximum battery life in portable
applications.
T he ADM202E/ADM1181A is a modification, enhancement
and improvement to the AD230–AD241 family and its deriva-
tives. It is essentially plug-in compatible and does not have ma-
terially different applications.
CIRCUIT DE SCRIPT ION
T he internal circuitry consists of four main sections. T hese are:
1. A charge pump voltage converter
2. 5 V logic to EIA-232 transmitters
3. EIA-232 to 5 V logic receivers.
4. T ransient protection circuit on all I/O lines
Charge Pump DC-DC Voltage Converter
T he charge pump voltage converter consists of an 200 kHz os-
cillator and a switching matrix. T he converter generates a
±
10 V
supply from the input +5 V level. T his is done in two stages us-
ing a switched capacitor technique as illustrated below. First,
the 5 V input supply is doubled to 10 V using capacitor C1 as
the charge storage element. T he 10 V level is then inverted to
generate –10 V using C2 as the storage element.
Capacitors C3 and C4 are used to reduce the output ripple.
T heir values are not critical and can be increased if desired. On
the ADM202E, capacitor C3 is shown connected between V+
and V
CC
, while it is connected between V+ and GND on the
ADM1181A. It is acceptable to use either configuration with
both the ADM202E and ADM1181A. If desired, larger capaci-
tors (up to 47
μ
F) can be used for capacitors C1–C4. T his facili-
tates direct substitution with older generation charge pump
RS-232 transceivers.
S1
S2
C1
S4
S3
C3
V+ = 2V
CC
V
CC
V
CC
GND
INTERNAL
OSCILLATOR
NOTE: C3 CONNECTS BETWEEN V+ AND GND ON THE ADM1181A
Figure 1. Charge Pump Voltage Doubler
S1
S2
C2
S4
S3
C4
V– = –(V+)
V+
GND
INTERNAL
OSCILLATOR
GND
FROM
VOLTAGE
DOUBLER
Figure 2. Charge Pump Voltage Inverter
T ransmitter (Driver) Section
T he drivers convert 5 V logic input levels into RS-232 output
levels. With V
CC
= +5 V and driving an RS-232 load, the output
voltage swing is typically
±
9 V.
Receiver Section
T he receivers are inverting level shifters which accept RS-232
input levels and translate them into 5 V logic output levels.
T he inputs have internal 5 k
pull-down resistors to ground
and are also protected against overvoltages of up to
±
30 V. Un-
connected inputs are pulled to 0 V by the internal 5 k
pull-
down resistor. T his, therefore, results in a Logic 1 output level
for unconnected inputs or for inputs connected to GND.
T he receivers have Schmitt trigger inputs with a hysteresis level
of 0.5 V. T his ensures error-free reception for both noisy inputs
and for inputs with slow transition times.
相關PDF資料 |
PDF描述 |
|---|---|
| ADM202E | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM1181 | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM1181A | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM202EAN | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM202EARN | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM202EARW-REEL | 功能描述:IC TX/RX RS-232 5V 15KV 16SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:121 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS422，RS485 電源電壓:3 V ~ 3.6 V 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-DFN（3x3） 包裝:管件 |
| ADM202EARWZ | 功能描述:IC TX/RX RS-232 5V 15KV 16SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:98 系列:* |
| ADM202EARWZ-REEL | 功能描述:IC TXRX RS-232 5V 15KV 16SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:121 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS422，RS485 電源電壓:3 V ~ 3.6 V 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-DFN（3x3） 包裝:管件 |
| ADM202JN | 功能描述:IC TX/RX RS-232 5V 15KV 16DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:121 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS422，RS485 電源電壓:3 V ~ 3.6 V 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-DFN（3x3） 包裝:管件 |
| ADM202JNZ | 功能描述:IC TX/RX RS-232 5V 15KV 16DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1 系列:- 類型:線路收發器 驅動器/接收器數:5/3 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:Digi-Reel® 產品目錄頁面:918 (CN2011-ZH PDF) 其它名稱:296-25096-6 |
發布緊急采購，3分鐘左右您將得到回復。