- 您現在的位置：買賣IC網 > PDF目錄374000 > ADM2209EARU (ANALOG DEVICES INC) Sealed Modular Connector; Body Material:Metal; Connector Shell Back Termination:IEEE1394 Receptacle; Connector Shell Finish:Nickel; Leaded Process Compatible:Yes; Modular Connector Shell Style:Square Flange Receptacle; Series:FWFTV RoHS Compliant: Yes PDF資料下載
參數資料
| 型號： | ADM2209EARU |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 通用總線功能 |
| 英文描述： | Sealed Modular Connector; Body Material:Metal; Connector Shell Back Termination:IEEE1394 Receptacle; Connector Shell Finish:Nickel; Leaded Process Compatible:Yes; Modular Connector Shell Style:Square Flange Receptacle; Series:FWFTV RoHS Compliant: Yes |
| 中文描述： | HEX LINE TRANSCEIVER, PDSO38 |
| 封裝： | TSSOP-38 |
| 文件頁數： | 10/12頁 |
| 文件大小： | 142K |
| 代理商： | ADM2209EARU |
REV. 0
ADM2209E
–10–
The ADM2209E is tested using both of the above-mentioned
test methods. All pins are tested with respect to all other pins as
per the MIL-STD-883B specification. In addition, all I-O pins
are tested as per the IEC test specification. The products were
tested under the following conditions:
(a) Power-On—Normal Operation
(b) Power-Off
There are four levels of compliance defined by IEC1000-4-2.
The ADM2209E meets the most stringent compliance level for
both contact and air-gap discharge. This means that the products
are able to withstand contact discharges in excess of 8 kV and air-
gap discharges in excess of 15 kV.
Table IV. IEC1000-4-2 Compliance Levels
Contact Discharge
kV
2
4
6
8
Air Discharge
kV
2
4
8
15
Level
1
2
3
4
Table V. ADM2209E ESD Test Results
ESD Test Method
I-O Pins
±
15 kV
Other Pins
±
2.5 kV
MIL-STD-883B
IEC1000-4-2
Contact
Air
±
8 kV
±
15 kV
FAST TRANSIENT BURST TESTING (IEC1000-4-4)
IEC1000-4-4 (previously 801-4) covers electrical fast-transient/
burst (EFT) immunity. Electrical fast transients occur as a
result of arcing contacts in switches and relays. The tests simu-
late the interference generated when, for example, a power relay
disconnects an inductive load. A spark is generated due to the
well-known back EMF effect. In fact the spark consists of a burst
of sparks as the relay contacts separate. The voltage appearing
on the line, therefore, consists of a burst of extremely fast tran-
sient impulses. A similar effect occurs when switching on fluo-
rescent lights.
The fast transient burst test defined in IEC1000-4-4 simulates
this arcing and its waveform is illustrated in Figure 26. It con-
sists of a burst of 2.5 kHz to 5 kHz transients repeating at
300 ms intervals. It is specified for both power and data lines.
300ms
15ms
t
V
5ns
0.2/0.4ms
50ns
V
t
Figure 26. IEC1000-4-4 Fast Transient Waveform
Table VI.
V Peak (kV)
PSU
V Peak (kV)
I-O
Level
1
2
3
4
0.5
1
2
4
0.25
0.5
1
2
A simplified circuit diagram of the actual EFT generator is
illustrated in Figure 27.
R
C
R
M
C
C
HIGH
VOLTAGE
SOURCE
L
Z
S
C
D
50
OUTPUT
Figure 27. IEC1000-4-4 Fast Transient Generator
The transients are coupled onto the signal lines using an EFT
coupling clamp. The clamp is 1 meter long and it completely
surrounds the cable, providing maximum coupling capacitance
(50 pF to 200 pF typ) between the clamp and the cable. High
energy transients are capacitively coupled onto the signal lines.
Fast rise times (5 ns) as specified by the standard result in very
effective coupling. This test is very severe since high voltages
are coupled onto the signal lines. The repetitive transients can
often cause problems where single pulses do not. Destructive
latch-up may be induced due to the high energy content of the
transients. Note that this stress is applied while the interface
products are powered up and transmitting data. The EFT test
applies hundreds of pulses with higher energy than ESD. Worst
case transient current on an I-O line can be as high as 40 A.
Test results are classified according to the following:
1. Normal performance within specification limits.
2. Temporary degradation or loss of performance which is self-
recoverable.
3. Temporary degradation or loss of function or performance
which requires operator intervention or system reset.
4. Degradation or loss of function which is not recoverable due
to damage.
The ADM2209E has been tested under worst case conditions
using unshielded cables and meets Classification 2. Data trans-
mission during the transient condition is corrupted, but it may
be resumed immediately following the EFT event without user
intervention.
IEC1000-4-3 RADIATED IMMUNITY
IEC1000-4-3 (previously IEC801-3) describes the measure-
ment method and defines the levels of immunity to radiated
electromagnetic fields. It was originally intended to simulate the
electromagnetic fields generated by portable radio transceivers
or any other device that generates continuous wave radiated
electromagnetic energy. Its scope has since been broadened to
include spurious EM energy which can be radiated from fluores-
cent lights, thyristor drives, inductive loads, etc.
相關PDF資料 |
PDF描述 |
|---|---|
| ADM2209E | EMI-/EMC-Compliant +-15 kV ESD Protected, Dual RS-232 Port with Standby |
| ADM237L | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM231LJN | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM231LJR | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM241LJR | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM2209EARU-REEL | 功能描述:IC TXRX6/10 RS-232 12V 38TSSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
| ADM2209EARU-REEL7 | 功能描述:IC TXRX6/10 RS-232 12V 38TSSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
| ADM2209EARUZ | 功能描述:IC TXRX6/10 RS-232 12V 38TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2 |
| ADM2209EARUZ-REEL | 功能描述:IC TXRX 6/10 RS-232 DUAL 38TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
| ADM2209EARUZ-REEL7 | 功能描述:IC TXRX 6/10 RS-232 DUAL 38TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。