- 您現在的位置：買賣IC網 > PDF目錄374004 > ADM489ARU (ANALOG DEVICES INC) PHOTODIODE, 0.05A, 1.3V; Area, active:7.5mm2; Case style:SOT-23; Sensitivity:0.6A/W @ 950nm; Wavelength, peak:940nm RoHS Compliant: Yes PDF資料下載
參數資料
| 型號： | ADM489ARU |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 通用總線功能 |
| 英文描述： | PHOTODIODE, 0.05A, 1.3V; Area, active:7.5mm2; Case style:SOT-23; Sensitivity:0.6A/W @ 950nm; Wavelength, peak:940nm RoHS Compliant: Yes |
| 中文描述： | LINE TRANSCEIVER, PDSO16 |
| 封裝： | MO-153AB, TSSOP-16 |
| 文件頁數： | 8/12頁 |
| 文件大小： | 212K |
| 代理商： | ADM489ARU |
ADM488/ADM489
–8–
REV. 0
GE NE RAL INFORMAT ION
T he ADM488/ADM489 is a ruggedized RS-485 transceiver that
operates from a single +5 V supply.
It contains protection against radiated and conducted interference.
It is ideally suited for operation in electrically harsh environ-
ments or where cables may be plugged/unplugged. It is also
immune to high RF field strengths without special shielding
precautions. It is intended for balanced data transmission and
complies with both EIA Standards RS-485 and RS-422. It con-
tains a differential line driver and a differential line receiver, and
is suitable for full duplex data transmission.
T he input impedance on the ADM488/ADM489 is 12 k
,
allowing up to 32 transceivers on the differential bus.
T he ADM488/ADM489 operates from a single +5 V
±
10%
power supply. Excessive power dissipation caused by bus con-
tention or by output shorting is prevented by a thermal shut-
down circuit. T his feature forces the driver output into a high
impedance state if, during fault conditions, a significant tem-
perature increase is detected in the internal driver circuitry.
T he receiver contains a fail-safe feature that results in a logic
high output state if the inputs are unconnected (floating).
A high level of robustness is achieved using internal protection
circuitry, eliminating the need for external protection compo-
nents such as tranzorbs or surge suppressors.
Low electromagnetic emissions are achieved using slew limited
drivers, minimizing interference both conducted and radiated.
T he ADM488/ADM489 can transmit at data rates up to
250 kbps.
A typical application for the ADM488/ADM489 is illustrated in
Figure 19. T his shows a full-duplex link where data may be
transferred at rates up to 250 kbps. A terminating resistor is
shown at both ends of the link. T his termination is not critical
since the slew rate is controlled by the ADM488/ADM489 and
reflections are minimized.
T he communications network may be extended to include
multipoint connections as shown in Figure 25. Up to 32 trans-
ceivers may be connected to the bus.
T ables I and II show the truth tables for transmitting and
receiving.
T able I. T ransmitting T ruth T able
Inputs
DE
Outputs
RE
DI
Z
Y
X
X
0
1
1
1
0
0
1
0
X
X
0
1
Hi-Z
Hi-Z
1
0
Hi-Z
Hi-Z
X = Don’t Care.
T able II. Receiving T ruth T able
Inputs
DE
Output
RO
RE
A-B
≥
+0.2 V
≤
+0.2 V
Inputs O/C
X
0
0
0
1
0
1
0
0
1
0
1
Hi-Z
X = Don’t Care.
E FT T RANSIE NT PROT E CT ION SCHE ME
T he ADM488/ADM489 uses protective clamping structures on
its inputs and outputs that clamp the voltage to a safe level and
dissipates the energy present in ESD (Electrostatic) and EFT
(Electrical Fast T ransients) discharges.
FAST T RANSIE NT BURST IMMUNIT Y (IE C1000-4-4)
IEC1000-4-4 (previously 801-4) covers electrical fast-transient/
burst (EFT ) immunity. Electrical fast transients occur as a
result of arcing contacts in switches and relays. T he tests simu-
late the interference generated when, for example, a power relay
disconnects an inductive load. A spark is generated due to the
well known back EMF effect. In fact, the spark consists of a
burst of sparks as the relay contacts separate. T he voltage ap-
pearing on the line, therefore, consists of a burst of extremely
fast transient impulses. A similar effect occurs when switching
on fluorescent lights.
ADM488
D
RO
DI
A
B
Z
Y
RE
DE
+5V
0.1
m
F
RS-485/RS-422 LINK
R
R
ADM489
+5V
0.1
m
F
D
RO
DI
RE
DE
GND
GND
V
CC
V
CC
A
B
Z
Y
Figure 19. ADM488/ADM489 Full-Duplex Data Link
相關PDF資料 |
PDF描述 |
|---|---|
| ADM5104 | Four-channel FastFast Ethernet 110Base-TX Transceiver(四通道110Base-TX快速以太網收發器) |
| ADM5170AN | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM5170AP | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM5170JN | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM5170JP | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM489ARU-REEL | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 16-Pin TSSOP T/R 制造商:Analog Devices 功能描述:LINE TRNSCVR 1TR 1TX 1RX 16TSSOP - Tape and Reel |
| ADM489ARU-REEL7 | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 16-Pin TSSOP T/R |
| ADM489ARUZ | 功能描述:IC TXRX RS-485 DIFF LP 16TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1 系列:- 類型:線路收發器 驅動器/接收器數:5/3 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:Digi-Reel® 產品目錄頁面:918 (CN2011-ZH PDF) 其它名稱:296-25096-6 |
| ADM489ARUZ# | 制造商:Analog Devices 功能描述: |
| ADM489ARUZ-REEL | 功能描述:IC TXRX RS-485 DIFF LP 16TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:121 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS422，RS485 電源電壓:3 V ~ 3.6 V 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-DFN（3x3） 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。