- 您現在的位置：買賣IC網 > PDF目錄374010 > ADM691AQ (ANALOG DEVICES INC) IC SW OFF-LINE PS 10/15W 8DIP PDF資料下載
參數資料
| 型號： | ADM691AQ |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 電源管理 |
| 英文描述： | IC SW OFF-LINE PS 10/15W 8DIP |
| 中文描述： | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, CDIP16 |
| 封裝： | CERDIP-16 |
| 文件頁數： | 8/12頁 |
| 文件大小： | 337K |
| 代理商： | ADM691AQ |
ADM691A/ADM693A/ADM800L/M
–8–
REV. 0
Changing the Watchdog and Reset Timeout
The watchdog and reset timeout periods may be controlled us-
ing OSC SEL and OSC IN. Please refer to Table II. With both
these inputs floating (or connected to V
OUT
) as in Figure 16, the
reset timeout is fixed at 200 ms and the watchdog timeout is
fixed at 1.6 sec.. If OSC IN is connected to GND as in Figure
16, the reset timeout period remains at 200 ms but a short
(100 ms) watchdog timeout period is selected (except immedi-
ately following a reset where it reverts to 1.6 sec). By connecting
OSC SEL to GND it is possible to select alternative timeout pe-
riods by either connecting a capacitor from OSC IN to GND or
by overdriving OSC IN with an external clock. With an external
capacitor, the watchdog timeout period is
Twd
(
ms
) = 600 (
C
/47
pF
)
and the reset active period is
Treset
(
ms
) = 1200 (C/47
pF
)
With an external clock connected to OSC IN, the timeout
periods become
Twd
= 1024 (1/
f
CLK
)
Treset
= 2048 (1/
f
CLK
)
Battery-Switchover Section
During normal operation with V
CC
higher than the reset thresh-
old and higher than V
BATT
, V
CC
is internally switched to V
OUT
via an internal PMOS transistor switch. This switch has a typi-
cal on-resistance of 0.75
and can supply up to 250 mA at the
V
OUT
terminal. V
OUT
is normally used to drive a RAM memory
bank which may require instantaneous currents of greater than
250 mA. If this is the case then a bypass capacitor should be
connected to V
OUT
. The capacitor will provide the peak current
transients to the RAM. A capacitance value of 0.1
μ
F or greater
may be used.
If the continuous output current requirement at V
OUT
exceeds
250 mA or if a lower V
CC
–V
OUT
voltage differential is desired,
an external PNP pass transistor may be connected in parallel
with the internal transistor. The BATT ON output can drive
the base of the external transistor.
If V
CC
drops below V
BATT
and below the reset threshold, battery
backup is selected. A 7
MOSFET switch connects the V
BATT
input to V
OUT
. This MOSFET has very low input-to-output
differential (dropout voltage) at the low current levels required for
battery backup of CMOS RAM or other low power CMOS cir-
cuitry. The supply current in battery backup is typically 0.04
μ
A.
High value capacitors, either standard electrolytic or the farad-
size double layer capacitors, can also be used for short-term
memory backup.
If the battery-switchover section is not used, V
BATT
should be
connected to GND and V
OUT
should be connected to V
CC
.
When V
CC
is below the reset threshold, the watchdog function is
disabled and WDI goes high impedance as it is disconnected
from its internal resistor network.
The internal oscillator is enabled when OSC SEL is high or
floating. In this mode, OSC IN selects between the 1.6 second
and 100 ms watchdog timeout periods.
CE
IN
RESET
RESET
V
CC
CE
OUT
OSC SEL
t
RS
RESET
THRESHOLD
80μs
12μs
t
RS
80μs
Figure 17. RESET and Chip Enable Timing
OSC SEL
OSC IN
7
8
ADM69_A
ADM800_
CLOCK
0 TO 250kHz
Figure 18a. External Clock Source
OSC SEL
OSC IN
7
8
ADM69_A
ADM800_
NC
NC
Figure 18b. Internal Oscillator (1.6 s Watchdog)
7
OSC SEL
OSC IN
8
ADM69_A
ADM800_
C
OSC
Figure 18c. External Capacitor
Table II. Reset Pulse Width and Watchdog Timeout Selections
Watchdog Timeout Period
Normal
OSC SEL
OSC IN
Immediately After Reset
Reset Active Period
Low
Low
Floating
Floating
External Clock Input
External Capacitor
Low
Floating or V
OUT
1024 clks
600 ms
×
C/47 pF
100 ms
1.6 s
4096 clks
2.4 s
×
C/47 pF
1.6 s
1.6 s
2048 clks
1200 ms
×
C/47 pF
200 ms
200 ms
相關PDF資料 |
PDF描述 |
|---|---|
| ADM800L | Microprocessor Supervisory Circuits |
| ADM800LAN | Microprocessor Supervisory Circuits |
| ADM800M | Microprocessor Supervisory Circuits |
| ADM691 | Microprocessor Supervisory Circuits |
| ADM691AN | Analog Switch / Multiplexer (Mux) IC; Analog Switch Function:Switch; Package/Case:6-SC-89; Leaded Process Compatible:Yes; Leakage Current:1nA; On Resistance, Rds(on):2ohm; Peak Reflow Compatible (260 C):Yes; Reel Quantity:3000 RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM691AR | 功能描述:IC SUPER MPU 4.65 250MA 16SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:高有效 復位超時:- 電壓 - 閥值:1.8V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-TSOP（0.059"，1.50mm 寬）5 引線 供應商設備封裝:5-TSOP 包裝:剪切帶 (CT) 其它名稱:NCP301HSN18T1GOSCT |
| ADM691AR-REEL | 功能描述:IC SUPER MPU 4.65 250MA 16SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:400 系列:- 類型:備用電池電路 監視電壓數目:1 輸出:開路漏極，推挽式 復位:高有效/低有效 復位超時:最小為 35 ms 電壓 - 閥值:4.65V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC W 包裝:帶卷 (TR) 其它名稱:ADM691ARZ-REEL7TR |
| ADM691AR-REEL7 | 制造商:Analog Devices 功能描述:Processor Supervisor 4.65V 4.75V to 5.5V 16-Pin SOIC T/R |
| ADM691ARZ | 功能描述:IC SUPER MPU 4.65 250MA 16SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極，開路漏極 復位:高有效/低有效 復位超時:最小為 250 ms 電壓 - 閥值:4.37V，4.62V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:管件 產品目錄頁面:1337 (CN2011-ZH PDF) |
| ADM691ARZ | 制造商:Analog Devices 功能描述:Microprocessor Supervisor |
發布緊急采購，3分鐘左右您將得到回復。