- 您現在的位置：買賣IC網 > PDF目錄374009 > ADM697AQ (ANALOG DEVICES INC) Microprocessor Supervisory Circuits PDF資料下載
參數資料
| 型號： | ADM697AQ |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 電源管理 |
| 英文描述： | Microprocessor Supervisory Circuits |
| 中文描述： | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, CDIP16 |
| 封裝： | CERDIP-16 |
| 文件頁數： | 6/12頁 |
| 文件大小： | 407K |
| 代理商： | ADM697AQ |
ADM696/ADM697
REV. 0
–6–
Table I. ADM696, ADM697 Reset Pulse Width and Watchdog Timeout Selections
Watchdog Timeout Period
Immediately After Reset
Reset Active Period
OSC SEL
OSC IN
Normal
Low
Low
Floating or High
Floating or High
External Clock Input
External Capacitor
Low
Floating or High
1024 CLKS
400 ms
×
C/47 pF
100 ms
1.6 s
4096 CLKS
1.6 s
×
C/47 pF
1.6 s
1.6 s
512 CLKS
200 ms
×
C/47 pF
50 ms
50 ms
NOTE
With the OSC SEL pin low, OSC IN can be driven by an external clock signal, or an external capacitor can be connected between OSC IN and GND. The nominal
internal oscillator frequency is 10.24 kHz. The nominal oscillator frequency with external capacitor is: F
OSC
(Hz) = 184,000/C (pF).
t
2
RESET
WDO
WDI
t
1
= RESET TIME
t
2
= NORMAL (SHORT) WATCHDOG TIMEOUT PERIOD
t
3
= WATCHDOG TIMEOUT PERIOD IMMEDIATELY FOLLOWING A RESET
t
1
t
1
t
1
t
3
Figure 3. Watchdog Timeout Period and Reset Active Time
The watchdog timeout period defaults to 1.6 s and the reset
pulse width defaults to 50 ms but these times to be adjusted as
shown in Table I. Figure 4 shows the various oscillator configu-
rations which can be used to adjust the reset pulse width and
watchdog timeout period.
The internal oscillator is enabled when OSC SEL is high or
floating. In this mode, OSC IN selects between the 1.6 second
and 100 ms watchdog timeout periods. In either case, immedi-
ately after a reset the timeout period is 1.6 s. This gives the mi-
croprocessor time to reinitialize the system. If OSC IN is low,
then the 100 ms watchdog period becomes effective after the
first transition of WDI. The software should be written such
that the I/O port driving WDI is left in its power-up reset state
until the initialization routines are completed and the micropro-
cessor is able to toggle WDI at the minimum watchdog timeout
period of 70 ms.
OSC IN
OSC SEL
ADM69x
CLOCK
0 TO 250kHz
8
7
Figure 4a. External Clock Source
OSC IN
OSC SEL
ADM69x
8
7
C
OSC
Figure 4b. External Capacitor
OSC IN
OSC SEL
ADM69x
8
7
NC
NC
Figure 4c. Internal Oscillator (1.6 s Watchdog)
OSC IN
OSC SEL
ADM69x
8
7
NC
Figure 4d. Internal Oscillator (100 ms Watchdog)
Watchdog Output (
WDO
)
The Watchdog Output
WDO
provides a status output which
goes low if the watchdog timer “times out” and remains low
until set high by the next transition on the watchdog input.
WDO
is also set high when LL
IN
goes below the reset threshold.
相關PDF資料 |
PDF描述 |
|---|---|
| ADM697AR | Microprocessor Supervisory Circuits |
| ADM697SQ | Microprocessor Supervisory Circuits |
| ADM696AN | Microprocessor Supervisory Circuits |
| ADM696AQ | Microprocessor Supervisory Circuits |
| ADM696AR | Microprocessor Supervisory Circuits |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM697AR | 功能描述:IC SUPERVISOR MPU 100MA 16SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:高有效 復位超時:- 電壓 - 閥值:1.8V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-TSOP（0.059"，1.50mm 寬）5 引線 供應商設備封裝:5-TSOP 包裝:剪切帶 (CT) 其它名稱:NCP301HSN18T1GOSCT |
| ADM697AR-REEL | 制造商:Analog Devices 功能描述:Processor Supervisor Adj 3V to 5.5V 16-Pin SOIC W T/R 制造商:Analog Devices 功能描述:PROCESSOR SUPERVISOR ADJV 1950UA 16SOIC W - Tape and Reel 制造商:Analog Devices 功能描述:Power Supply Supervisor Circuit, 16 Pin, Plastic, SOP |
| ADM697ARZ | 功能描述:IC SUPERVISOR MPU 16SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 其它有關文件:STM6717 View All Specifications 標準包裝:1 系列:- 類型:多壓監控器 監視電壓數目:2 輸出:開路漏極或開路集電極 復位:低有效 復位超時:最小為 600 ms 電壓 - 閥值:1.11V，3.075V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:Digi-Reel® 產品目錄頁面:1194 (CN2011-ZH PDF) 其它名稱:497-7019-6 |
| ADM697ARZ-REEL | 功能描述:IC SUPERVISOR MPU 16SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:高有效 復位超時:- 電壓 - 閥值:1.8V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-TSOP（0.059"，1.50mm 寬）5 引線 供應商設備封裝:5-TSOP 包裝:剪切帶 (CT) 其它名稱:NCP301HSN18T1GOSCT |
| adm697sq | 制造商:Analog Devices 功能描述: 制造商:Rochester Electronics LLC 功能描述:5V CMOS SUPERVISORS IC - Bulk |
發布緊急采購，3分鐘左右您將得到回復。