- 您現在的位置：買賣IC網 > PDF目錄374015 > ADM8690ARN (ANALOG DEVICES INC) Microprocessor Supervisory Circuits PDF資料下載
參數資料
| 型號： | ADM8690ARN |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 電源管理 |
| 英文描述： | Microprocessor Supervisory Circuits |
| 中文描述： | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO8 |
| 封裝： | MS-012AA, SOIC-8 |
| 文件頁數： | 7/16頁 |
| 文件大小： | 183K |
| 代理商： | ADM8690ARN |
ADM8690–ADM8695
REV. 0
–7–
T able I. ADM8691, ADM8693, ADM8695 Reset Pulse Width and Watchdog T imeout Selections
Watchdog T imeout Period
Reset Active Period
Immediately
After Reset
OSC SE L
OSC IN
Normal
ADM8691/ADM8693
ADM8695
Low
Low
Floating or High
Floating or High
External Clock Input
External Capacitor
Low
Floating or High
1024 CLK S
400 ms
×
C/47 pF
100 ms
1.6 s
4096 CLK S
1.6 s
×
C/47 pF
1.6 s
1.6 s
512 CLK S
200 ms
×
C/47 pF
50 ms
50 ms
2048 CLK S
520 ms
×
C/47 pF
200 ms
200 ms
NOT E
With the OSC SEL pin low, OSC IN can be driven by an external clock signal, or an external capacitor can be connected between OSC IN and GND. T he nominal
internal oscillator frequency is 10.24 kHz. T he nominal oscillator frequency with external capacitor is: F
OSC
(Hz) = 184,000/C (pF)
On the ADM8690/ADM8692 the watchdog timeout period is
fixed at 1.6 seconds and the reset pulse width is fixed at 50 ms.
On the ADM8694 the watchdog timeout period is also 1.6 sec-
onds but the reset pulse width is fixed at 200 ms. T he ADM8691/
ADM8693/ADM8695 allow these times to be adjusted as
shown in T able I. Figure 4 shows the various oscillator configu-
rations that can be used to adjust the reset pulse width and
watchdog timeout period.
T he internal oscillator is enabled when OSC SEL is high or
floating. In this mode, OSC IN selects between the 1.6 second
and 100 ms watchdog timeout periods. With OSC IN connected
high or floating, the 1.6 second timeout period is selected; while
with it connected low, the 100 ms timeout period is selected. In
either case, immediately after a reset the timeout period is 1.6
seconds. T his gives the microprocessor time to reinitialize the
system. If OSC IN is low, then the 100 ms watchdog period be-
comes effective after the first transition of WDI. T he software
should be written such that the I/O port driving WDI is left in
its power-up reset state until the initialization routines are com-
pleted and the microprocessor is able to toggle WDI at the mini-
mum watchdog timeout period of 70 ms.
Watchdog Output (WDO)
T he Watchdog Output
WDO
(ADM8691/ADM8693/
ADM8695) provides a status output which goes low if the
watchdog timer “times out” and remains low until set high by
the next transition on the Watchdog Input.
WDO
is also set
high when V
CC
goes below the reset threshold.
8
7
CLOCK
0 TO 500kHz
OSC SEL
OSC IN
ADM8691
ADM8693
ADM8695
Figure 4a. External Clock Source
8
7
OSC SEL
OSC IN
ADM8691
ADM8693
ADM8695
C
OSC
Figure 4b. External Capacitor
8
7
NC
NC
OSC SEL
OSC IN
ADM8691
ADM8693
ADM8695
Figure 4c. Internal Oscillator (1.6 Second Watchdog)
8
7
OSC SEL
OSC IN
ADM8691
ADM8693
ADM8695
NC
Figure 4d. Internal Oscillator (100 ms Watchdog)
相關PDF資料 |
PDF描述 |
|---|---|
| ADM8692 | Linear 1-cell Li-Ion Battery Charger w/Integrated FET, One LED 20-VQFN -40 to 70 |
| ADM8692AN | Linear 1-cell Li-Ion Battery Charger W/Integrated FET, Bi-Color LED 20-HTSSOP -20 to 70 |
| ADM8692ARN | Linear 1-cell Li-Ion Battery Charger W/Integrated FET, Bi-Color LED 20-HTSSOP -20 to 70 |
| ADM8694 | bqTINY(TM) Linear 1-cell Li-Ion Charger w/ 1-A FET, Charge Enable & Term Enable in QFN-10 10-SON -40 to 85 |
| ADM8694AN | bqTINY(TM) Linear 1-cell Li-Ion Charger w/ 1-A FET, Temp Sense & Charge Enable in QFN-10 10-SON -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM8690ARN-REEL | 功能描述:IC SUPERVISOR MPU 4.65V 8SOIC TR RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:高有效 復位超時:- 電壓 - 閥值:1.8V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-TSOP（0.059"，1.50mm 寬）5 引線 供應商設備封裝:5-TSOP 包裝:剪切帶 (CT) 其它名稱:NCP301HSN18T1GOSCT |
| ADM8690ARNZ | 功能描述:IC SUPERVISOR MPU 4.65V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 其它有關文件:STM6717 View All Specifications 標準包裝:1 系列:- 類型:多壓監控器 監視電壓數目:2 輸出:開路漏極或開路集電極 復位:低有效 復位超時:最小為 600 ms 電壓 - 閥值:1.11V，3.075V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:Digi-Reel® 產品目錄頁面:1194 (CN2011-ZH PDF) 其它名稱:497-7019-6 |
| ADM8691 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Microprocessor Supervisory Circuits |
| ADM8691AN | 制造商:Analog Devices 功能描述:Processor Supervisor 4.65V 4.75V to 5.5V 16-Pin PDIP 制造商:Rochester Electronics LLC 功能描述:IMPROVED ADM691 I.C. - Bulk 制造商:Analog Devices 功能描述:IC SUPERVISORY CCT 8691 DIP16 |
| ADM8691ANZ | 功能描述:IC SUPERVSR MPU 4.65V ADJ 16DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:高有效 復位超時:- 電壓 - 閥值:1.8V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-TSOP（0.059"，1.50mm 寬）5 引線 供應商設備封裝:5-TSOP 包裝:剪切帶 (CT) 其它名稱:NCP301HSN18T1GOSCT |
發布緊急采購，3分鐘左右您將得到回復。