- 您現在的位置：買賣IC網 > PDF目錄374017 > ADN2870ACPZ (ANALOG DEVICES INC) High Bandwidth, CMOS 8-Bit Serial Interface Multiplying D/A Converter; Package: MSOP; No of Pins: 10; Temperature Range: Industrial PDF資料下載
參數資料
| 型號： | ADN2870ACPZ |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 其它接口 |
| 英文描述： | High Bandwidth, CMOS 8-Bit Serial Interface Multiplying D/A Converter; Package: MSOP; No of Pins: 10; Temperature Range: Industrial |
| 中文描述： | SPECIALTY INTERFACE CIRCUIT, QCC24 |
| 封裝： | 4 X 4 MM, LEAD FREE, MO-220VGGD-2, LFCSP-24 |
| 文件頁數： | 17/20頁 |
| 文件大小： | 764K |
| 代理商： | ADN2870ACPZ |
ADN2870
ALARMS
The ADN2870 has a latched active high monitoring alarm (FAIL).
The FAIL alarm output is an open drain in conformance to SFP
MSA specification requirements.
Rev. 0 | Page 17 of 20
The ADN2870 has a 3-fold alarm system that covers
Use of a bias current higher than expected, probably as a
result of laser aging.
Out-of-bounds average voltage at the monitor photodiode
(MPD) input, indicating an indicating an excessive amount
of laser power or a broken loop.
Undervoltage in IBIAS node (laser diode cathode) that
would increase the laser power.
The bias current alarm trip point is set by selecting the value of
resistor on the IBMON pin to GND. The alarm is triggered
when the voltage on the IBMON pin goes above 1.2 V.
FAIL is activated when the single-point faults in Table 5 occur.
Table 5. ADN2870 Single-Point Alarms
Alarm Type
1. Bias Current
2. MPD Current
3. Crucial Nodes
Pin Name
IBMON
PAVSET
ERREF
IBIAS
Over Voltage or Short to VCC Condition
Alarm if > 1.2 V
Alarm if > 1.7 V
Alarm if shorted to VCC
Ignore
Under Voltage or Short to GND Condition
Ignore
Alarm if < 0.9 V
Alarm if shorted to GND
Alarm if < 600 mV
Table 6. ADN2870 Response to Various Single-Point Faults in AC-Coupled Configuration as Shown in Figure 32
Pin
Short to VCC
Short to GND
CCBIAS
Fault state occurs
Fault state occurs
PAVSET
Fault state occurs
Fault state occurs
PAVREF
Voltage mode: Fault state occurs
Resistor mode: Tied to VCC
RPAV
Voltage mode: Fault state occurs
Resistor mode: Tied to VCC
Open
Does not increase laser average power
Fault state occurs
Fault state occurs
Fault state occurs
Fault state occurs
Voltage mode: Fault state occurs
Resistor mode: Does not increase
average power
Does not increase laser average power
Fault state occurs
Does not increase laser average power
Does not increase laser average power
Output currents shut off
Does not increase laser average power
Does not increase laser average power
Does not increase laser average power
ERCAP
PAVCAP
DATAP
DATAN
ALS
ERSET
IMMON
ERREF
Does not increase laser average power
Fault state occurs
Does not increase laser average power
Does not increase laser average power
Output currents shut off
Does not increase laser average power
Does not affect laser power
Voltage mode: Fault state occurs
Resistor mode: Tied to VCC
Does not increase laser average power
Fault state occurs
Does not increase laser average power
Does not increase laser average power
Normal currents
Does not increase laser average power
Does not increase laser average power
Voltage mode: Does not increase
average power
Resistor mode: Fault state occurs
Does not increase laser average power
Does not increase laser average power
Does not increase laser average power
Does not increase laser average power
Fault state occurs
IBMON
FAIL
IMODP
IMODN
IBIAS
Fault state occurs
Fault state occurs
Does not increase laser average power
Does not increase laser average power
Fault state occurs
Does not increase laser average power
Does not increase laser average power
Does not increase laser average power
Does not increase laser power
Fault state occurs
相關PDF資料 |
PDF描述 |
|---|---|
| ADN2870ACPZ-RL | 3.3 V Dual-Loop, 50 Mbps to 3.3 Gbps Laser Diode Driver |
| ADN2870ACPZ-RL7 | 3.3 V Dual-Loop, 50 Mbps to 3.3 Gbps Laser Diode Driver |
| ADN2890 | 3.3 V 2.7 Gb/s Limiting Amplifier |
| ADN2890ACP | 3.3 V 2.7 Gb/s Limiting Amplifier |
| ADN2890ACP-RL | 3.3 V 2.7 Gb/s Limiting Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADN2870ACPZ-RL | 功能描述:IC LSR DRVR 3.3GPBS 3.6V 24LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 激光驅動器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:激光二極管驅動器 數據速率:- 通道數:4 電源電壓:3.3V 電流 - 電源:- 電流 - 調制:- 電流 - 偏置:- 工作溫度:0°C ~ 70°C 封裝/外殼:40-TQFN 裸露焊盤 供應商設備封裝:40-TQFN EP 包裝:托盤 安裝類型:表面貼裝 |
| ADN2870ACPZ-RL7 | 功能描述:IC LSR DRVR 3.3GPBS 3.6V 24LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 激光驅動器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:激光二極管驅動器 數據速率:- 通道數:4 電源電壓:3.3V 電流 - 電源:- 電流 - 調制:- 電流 - 偏置:- 工作溫度:0°C ~ 70°C 封裝/外殼:40-TQFN 裸露焊盤 供應商設備封裝:40-TQFN EP 包裝:托盤 安裝類型:表面貼裝 |
| ADN2871 | 制造商:AD 制造商全稱:Analog Devices 功能描述:3.3 V, 50 Mbps to 4.25 Gbps Single-Loop Laser Diode Driver |
| ADN2871ACPZ | 功能描述:IC LASER DRIVER 4.25GBPS 24LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 激光驅動器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:激光二極管驅動器 數據速率:- 通道數:4 電源電壓:3.3V 電流 - 電源:- 電流 - 調制:- 電流 - 偏置:- 工作溫度:0°C ~ 70°C 封裝/外殼:40-TQFN 裸露焊盤 供應商設備封裝:40-TQFN EP 包裝:托盤 安裝類型:表面貼裝 |
| ADN2871ACPZ-RL | 功能描述:IC LASER DRIVER 4.25GBPS 24LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 激光驅動器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:激光二極管驅動器 數據速率:- 通道數:4 電源電壓:3.3V 電流 - 電源:- 電流 - 調制:- 電流 - 偏置:- 工作溫度:0°C ~ 70°C 封裝/外殼:40-TQFN 裸露焊盤 供應商設備封裝:40-TQFN EP 包裝:托盤 安裝類型:表面貼裝 |
發布緊急采購，3分鐘左右您將得到回復。