欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ADP3000AN-12
廠商: ANALOG DEVICES INC
元件分類: 穩壓器
英文描述: Isolated Flyback Switching Regulator with 9V Output
中文描述: SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, PDIP8
封裝: PLASTIC, MO-095-AA, DIP-8
文件頁數: 6/12頁
文件大小: 342K
代理商: ADP3000AN-12
ADP3000
–6–
REV. 0
THEORY OF OPERATION
The ADP3000 is a versatile, high frequency, switch mode
power supply (SMPS) controller. The regulated output
voltage can be greater than the input voltage (boost or step-up
mode) or less than the input (buck or step-down mode). This
device uses a gated oscillator technique to provide high perfor-
mance with low quiescent current.
A functional block diagram of the ADP3000 is shown in
Figure 3a. The internal 1.245 V reference is connected to one
input of the comparator, while the other input is externally
connected (via the FB pin) to a resistor divider connected to
the regulated output. When the voltage at the FB pin falls below
1.245 V, the 400 kHz oscillator turns on. A driver amplifier
provides base drive to the internal power switch and the switching
action raises the output voltage. When the voltage at the FB
pin exceeds 1.245 V, the oscillator is shut off. While the
oscillator is off, the ADP3000 quiescent current is only 500
μ
A.
The comparator’s hysteresis ensures loop stability without
requiring external components for frequency compensation.
The maximum current in the internal power switch can be set
by connecting a resistor between V
IN
and the I
LIM
pin. When
the maximum current is exceeded, the switch is turned OFF.
The current limit circuitry has a time delay of about 0.3
μ
s. If
an external resistor is not used, connect I
LIM
to V
IN
. This
yields the maximum feasible current limit. Further information
on I
LIM
is included in the “Applications” section of this data
sheet. The ADP3000 internal oscillator provides typically 1.7
μ
s ON and 0.8
μ
s OFF times.
An uncommitted gain block on the ADP3000 can be con-
nected as a low battery detector. The inverting input of the
gain block is internally connected to the 1.245 V reference.
The noninverting input is available at the SET pin. A resistor
divider, connected between V
IN
and GND with the junction
connected to the SET pin, causes the AO output to go LOW
when the low battery set point is exceeded. The AO output is
an open collector NPN transistor that can sink in excess of
300
μ
A.
The ADP3000 provides external connections for both the
collector and emitter of its internal power switch, which permits
both step-up and step-down modes of operation. For the step-
up mode, the emitter (Pin SW2) is connected to GND and the
collector (Pin SW1) drives the inductor. For step-down mode,
the emitter drives the inductor while the collector is connected
to V
IN
.
The output voltage of the ADP3000 is set with two external
resistors. Three fixed voltage models are also available:
ADP3000–3.3 (+3.3 V), ADP3000–5 (+5 V) and ADP3000–12
(+12 V). The fixed voltage models include laser-trimmed
voltage-setting resistors on the chip. On the fixed voltage models
of the ADP3000, simply connect the feedback pin (Pin 8)
directly to the output voltage.
APPLICATIONS INFORMATION
COMPONENT SELECTION
Inductor Selection
For most applications the inductor used with the ADP3000 will
fall in the range between 4.7
μ
H to 33
μ
H. Table I shows
recommended inductors and their vendors.
When selecting an inductor, it is very important to make sure
that the inductor used with the ADP3000 is able to handle a
current that is higher than the ADP3000’s current limit without
saturation.
As a rule of thumb, powdered iron cores saturate softly, whereas
Ferrite cores saturate abruptly. Rod or “open” drum core
geometry inductors saturate gradually. Inductors that saturate
gradually are easier to use. Even though rod or drum core
inductors are attractive in both price and physical size, these
types of inductors must be handled with care because they have
high magnetic radiation. Toroid or “closed” core geometry
should be used when minimizing EMI is critical.
In addition, inductor dc resistance causes power loss. It is best
to use low dc resistance inductors so that power loss in the
inductor is kept to the minimum. Typically, it is best to use an
inductor with a dc resistance lower than 0.2
.
Table I. Recommended Inductors
V
endor
Series
Core Type
Phone Numbers
Coiltronics
Coiltronics
OCTAPAC
UNIPAC
Toroid
Open
(407) 241-7876
(407) 241-7876
Sumida
Sumida
CD43, CD54
CDRH62, CDRH73, Semi-Closed
CDRH64
Open
(847) 956-0666
(847) 956-0666
Geometry
Capacitor Selection
For most applications, the capacitor used with the ADP3000
will fall in the range between 33
μ
F to 220
μ
F. Table II shows
recommended capacitors and their vendors.
For input and output capacitors, use low ESR type capacitors
for best efficiency and lowest ripple. Recommended capacitors
include AVX TPS series, Sprague 595D series, Panasonic HFQ
series and Sanyo OS-CON series.
When selecting a capacitor, it is important to make sure the
maximum capacitor ripple current rms rating is higher than the
ADP3000’s rms switching current.
It is best to protect the input capacitor from high turn-on cur-
rent charging surges by derating the capacitor voltage by 2:1.
For very low input or output voltage ripple requirements,
Sanyo OS-CON series capacitors can be used since this type of
capacitor has very low ESR. Alternatively, two or more tanta-
lum capacitors can be used in parallel.
相關PDF資料
PDF描述
ADP3000AN-33 Isolated Flyback Switching Regulator with 9V Output
ADP3000AN-5 Isolated Flyback Switching Regulator with 9V Output
ADP3000AR Isolated Flyback Switching Regulator with 9V Output
ADP3000AR-5 Isolated Flyback Switching Regulator with 9V Output
ADP3000AR-12 Top Entry Connector Hood; Enclosure Material:Aluminum Alloy; For Use With:C146 Rectangular Circular Connectors; Connecting Termination:Screw; Gender:Male; No. of Contacts:48; Operating Voltage:400V; Series:C-146 RoHS Compliant: Yes
相關代理商/技術參數
參數描述
ADP3000AN-3.3 制造商:Rochester Electronics LLC 功能描述:MCROPWR STPUP/DWN H. FRQ. SWT. REG. 3.3V - Bulk
ADP3000AN-33 制造商:AD 制造商全稱:Analog Devices 功能描述:Micropower Step-Up/Step-Down Fixed 3.3 V, 5 V, 12 V and Adjustable High Frequency Switching Regulator
ADP3000AN-5 制造商:Rochester Electronics LLC 功能描述:MCROPWR STPUP/DWN H. FREQ. SWT. REG 5V - Bulk
ADP3000ANZ-12 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:
ADP3000ANZ-3.3 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:
主站蜘蛛池模板: 惠水县| 丹东市| 屏山县| 安仁县| 卓资县| 古田县| 望城县| 休宁县| 光泽县| 定州市| 凤庆县| 临沧市| 平阳县| 五华县| 勃利县| 申扎县| 集贤县| 汶川县| 丹东市| 永安市| 香格里拉县| 竹北市| 庆元县| 万年县| 郁南县| 富顺县| 正安县| 昆明市| 浪卡子县| 延寿县| 阜南县| 永嘉县| 县级市| 年辖:市辖区| 桦川县| 奇台县| 阿图什市| 新兴县| 铁岭县| 麻栗坡县| 宜城市|