- 您現在的位置：買賣IC網 > PDF目錄379646 > ADS-943MM (Electronic Theatre Controls, Inc.) 14-Bit, 3MHz, Low-Distortion Sampling A/D Converters PDF資料下載
參數資料
| 型號： | ADS-943MM |
| 廠商： | Electronic Theatre Controls, Inc. |
| 元件分類： | 串行ADC |
| 英文描述： | 14-Bit, 3MHz, Low-Distortion Sampling A/D Converters |
| 中文描述： | 14位，3MHz的，低失真的采樣A / D轉換器 |
| 文件頁數： | 3/8頁 |
| 文件大?。?/td> | 166K |
| 代理商： | ADS-943MM |
ADS -943
3
+25°C
TYP.
0 to +70°C
TYP.
–55 to +125°C
TYP.
DYNAMIC PERFORMANCE cont.
MIN.
MAX.
MIN.
MAX.
MIN.
MAX.
UNITS
S/H Acquisition Time
( to ±0.003%FSR, 4V step)
Overvoltage Recovery Time
A/D Conversion Rate
—
—
3
208
100
—
215
333
—
—
—
3
208
100
—
215
333
—
—
—
3
208
100
—
215
333
—
ns
ns
MHz
DIGITAL OUTPUTS
Logic Levels
Logic "1"
Logic "0"
Logic Loading "1"
Logic Loading "0"
Output Coding
+2.4
—
—
—
—
—
—
—
—
+0.4
–4
+4
+2.4
—
—
—
—
—
—
—
Offset Binary
—
+0.4
–4
+4
+2.4
—
—
—
—
—
—
—
—
+0.4
–4
+4
Volts
Volts
mA
mA
POWER REQUIREMENTS
Power Supply Ranges
+5V Supply
–5V Supply
Power Supply Currents
+5V Supply
–5V Supply
Power Dissipation
Power Supply Rejection
+4.75
–4.75
+5.0
–5.0
+5.25
–5.25
+4.75
–4.75
+5.0
–5.0
+5.25
–5.25
+4.9
–4.9
+5.0
–5.0
+5.25
–5.25
Volts
Volts
—
—
—
—
+210
–125
1.7
—
+230
–145
1.9
±0.05
—
—
—
—
+210
–125
1.7
—
+230
–145
1.9
±0.05
—
—
—
—
+210
–125
1.7
—
+230
–145
1.9
±0.05
mA
mA
Watts
%FSR/%V
6.02
(SNR + Distortion) – 1.76 + 20 log
Full Scale Amplitude
Actual Input Amplitude
Effective bits is equal to:
This is the time required before the A/D output data is valid once the analog input
is back within the specified range. This time is only guaranteed if the input does
not exceed ±2.2V (S/H Saturation Voltage).
The mnimumsupply voltages of +4.9V and –4.9V for ±V
DD
are required for
–55°C operation only. The mnumumlimts are +4.75V and –4.75V when
operating at +125°C.
TECHNICAL NOTES
1. Obtaining fully specified performance from the ADS-943
requires careful attention to pc-card layout and power
supply decoupling. The device's analog and digital ground
systems are connected to each other internally. For optimal
performance, tie all ground pins (14, 19 and 24) directly to a
large
analog
ground plane beneath the package.
Bypass all power supplies to ground with 4.7μF tantalum
capacitors in parallel with 0.1μF ceramic capacitors. Locate
the bypass capacitors as close to the unit as possible.
2. The ADS-943 achieves its specified accuracies without the
need for external calibration. If required, the device's small
initial offset and gain errors can be reduced to zero using
the adjustment circuitry shown in Figures 2 and 3.
When using this circuitry, or any similar offset and gain-
calibration hardware, make adjustments following warmup.
To avoid interaction, always adjust offset before gain.
3. Applying a start convert pulse while a conversion is in
progress (EOC = logic "1") will initiate a new and inaccurate
conversion cycle. Data for the interrupted and subsequent
conversions will be invalid.
4. A passive bandpass filter is used at the input of the A/D for
all production testing.
Footnotes:
All power supplies should be on before applying a start convert pulse. All
supplies and the clock (start convert pulses) must be present during warmup
periods. The device must be continuously converting during this time.
Contact DATEL for other input voltage ranges.
A 3MHz clock with a 20nsec positive pulse width is used for all production testing.
When sampling at 3MHz, the start convert pulse must be between 10 and
110nsec wide or between 160 and 300nsec wide. The falling edge must not occur
between 110 and 160nsec. For lower sampling rates, wider start pulses may be
used.
Figure 2. Optional ADS-943 Gain Adjust Calibration Circuit
To Pin21
of ADS-943
–5V
SIGNAL
INPUT
GAIN
ADJUST
1.98k
50
+5V
2k
相關PDF資料 |
PDF描述 |
|---|---|
| ADS-943GC | 14-Bit, 3MHz, Low-Distortion Sampling A/D Converters |
| ADS-951 | 18-Bit, 1MHz, Low-Power Sampling A/D Converters |
| ADS-951MC | 18-Bit, 1MHz, Low-Power Sampling A/D Converters |
| ADS-951ME | 18-Bit, 1MHz, Low-Power Sampling A/D Converters |
| ADS-953 | 18-Bit, 1MHz, Low-Distortion Sampling A/D Converters |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADS944 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:14-Bit, 5MHz Sampling A/D Converters |
| ADS-944 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:14-Bit 5MHZ Sampling A/D Converters |
| ADS-944/883 | 制造商:Murata Power Solutions 功能描述:ADC Single 2-Step Flash 5Msps 14-bit Parallel 32-Pin TDIP |
| ADS-944MC | 制造商:Murata Power Solutions 功能描述:ADC Single 2-Step Flash 5Msps 14-bit Parallel 32-Pin TDIP |
| ADS-944MM | 制造商:Murata Power Solutions 功能描述:ADC Single 2-Step Flash 5Msps 14-bit Parallel 32-Pin TDIP |
發布緊急采購，3分鐘左右您將得到回復。