欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ADT7519ARQ-REEL
廠商: Analog Devices, Inc.
元件分類: 溫度/濕度傳感器
英文描述: SPI/I2C Compatible, Temperature Sensor, Four Channel ADC and Quad Voltage Output DAC
中文描述: SPI/I2C兼容,溫度傳感器,四通道ADC和四路電壓輸出DAC
文件頁數: 21/44頁
文件大小: 1350K
代理商: ADT7519ARQ-REEL
ADT7516/ADT7517/ADT7519
DAC Reference Inputs
There is an input reference pin for the DACs. This reference
input is buffered (see Figure 44).
Rev. A | Page 21 of 44
The advantage with the buffered input is the high impedance it
presents to the voltage source driving it. The user can have an
external reference voltage as low as 1 V and as high as V
DD
. The
restriction of 1 V is due to the footroom of the reference buffer.
The LDAC configuration register controls the option to select
between internal and external voltage references. The default
setting is for external reference selected.
Output Amplifier
The output buffer amplifier can generate output voltages to
within 1 mV of either rail. Its actual range depends on the value
of V
REF
, gain, and offset error.
If a gain of 1 is selected (Bits 0 to 3 of the DAC configuration
register = 0), the output range is 0.001 V to V
REF
.
If a gain of 2 is selected (Bits 0 to 3 of the DAC configuration
register = 1), the output range is 0.001 V to 2 V
REF
. Because
of clamping, however, the maximum output is limited to
V
DD
– 0.001 V.
The output amplifier can drive a load of 4.7 k to GND or V
DD
,
in parallel with 200 pF to GND or V
DD
(see Figure 5). The
source and sink capabilities of the output amplifier can be seen
in the plot of Figure 20.
The slew rate is 0.7 V/μs with a half-scale settling time to
±0.5 LSB (at 8 bits) of 6 μs.
Thermal Voltage Output
The ADT7516/ADT7517/ADT7519 can output voltages that are
proportional to temperature. DAC A output can be configured
to represent the temperature of the internal sensor while DAC B
output can be configured to represent the external temperature
sensor. Bits C5 and C6 of the Control Configuration 3 register
select the temperature proportional output voltage. Each time a
temperature measurement is taken, the DAC output is updated.
The output resolution for the ADT7519 is 8 bits with 1°C
change corresponding to 1 LSB change. The output resolution
for the ADT7516 and ADT7517 are capable of 10 bits with
0.25°C change corresponding to 1 LSB change. The default
output resolution for the ADT7516 and ADT7517 is 8 bits. To
increase this to 10 bits, set C1 = 1 in the Control Configuration
3 register. The default output range is 0 V to V
REF
and this can be
increased to 0 V to 2 V
REF
. Increasing the output voltage span to
2 V
REF
can be done by setting D0 = 1 for DAC A (internal temp-
erature sensor) and D1 = 1 for DAC B (external temperature
sensor) in the DAC configuration register (Address 1Bh).
The output voltage is capable of tracking a maximum temp-
erature range of –128°C to +127°C, but the default setting is
–40°C to +127°C. If the output voltage range is 0 V to V
REF
-IN
(V
REF
-IN = 2.25 V), then this corresponds to 0 V representing
–40°C, and 1.48 V representing +127°C. This, of course, will
give an upper deadband between 1.48 V and V
REF
.
The internal and external analog temperature offset registers
can be used to vary this upper deadband and, consequently, the
temperature that 0 V corresponds to. Table 6 and Table 7 give
examples of how this is done using a DAC output voltage span
of V
REF
and 2 V
REF
, respectively. Simply write in the temperature
value, in twos complement format, at which 0 V is to start. For
example, if using the DAC A output and 0 V to start at –40°C,
program D8h into the internal analog temperature offset reg-
ister (Address 21h). This is an 8-bit register and has a temp-
erature offset resolution of only 1°C for all device models. Use
the formulas following the tables to determine the value to
program into the offset registers.
Table 6. Thermal Voltage Output (0 V to V
REF
)
O/P Voltage (V)
0
0.5
1
1.12
1.47
1.5
2
2.25
Default °C
–40
+17
+73
+87
+127
UDB
UDB
UDB
Max °C
–128
–71
–15
–1
+39
+42
+99
+127
Sample °C
0
+56
+113
+127
UDB
UDB
UDB
UDB
Upper deadband has been reached. DAC output is not capable of
increasing. See Fig
.
ure 9
C1
D–
D+
LOW-PASS
FILTER
f
C
= 65kHz
BIAS
V
DD
TO ADC
V
OUT+
V
OUT–
REMOTE
SENSING
TRANSISTOR
(2N3906)
OPTIONAL CAPACITOR, UP TO
3nF MAX. CAN BE ADDED TO
IMPROVE HIGH FREQUENCY
NOISE REJECTION IN NOISY
ENVIRONMENTS
I
N
×
I
I
BIAS
0
Figure 45. Signal Conditioning for External Diode Temperature Sensor
相關PDF資料
PDF描述
ADT7517ARQ-REEL SPI/I2C Compatible, Temperature Sensor, Four Channel ADC and Quad Voltage Output DAC
ADT7516ARQ-REEL SPI/I2C Compatible, Temperature Sensor, Four Channel ADC and Quad Voltage Output DAC
ADT7519ARQ-REEL7 SPI/I2C Compatible, Temperature Sensor, Four Channel ADC and Quad Voltage Output DAC
ADT7517ARQ-REEL7 SPI/I2C Compatible, Temperature Sensor, Four Channel ADC and Quad Voltage Output DAC
ADT7516ARQ-REEL7 SPI/I2C Compatible, Temperature Sensor, Four Channel ADC and Quad Voltage Output DAC
相關代理商/技術參數
參數描述
ADT7519ARQ-REEL7 制造商:Analog Devices 功能描述:Temp Sensor Digital Serial (4-Wire, SPI, I2C) 16-Pin QSOP T/R 制造商:Analog Devices 功能描述:TEMP SENSOR DGTL SERL (4-WIRE, SPI) 16QSOP - Tape and Reel
ADT7519ARQZ 功能描述:IC TEMP SNSR QUAD DAC 16-QSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱管理 系列:- 標準包裝:3,000 系列:- 功能:溫度開關 傳感器類型:內部 感應溫度:85°C 分界點 精確度:±6°C(最小值) 拓撲:ADC(三角積分型),比較器,寄存器庫 輸出類型:開路漏極 輸出警報:是 輸出風扇:是 電源電壓:2.7 V ~ 5.5 V 工作溫度:-55°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SC-74A,SOT-753 供應商設備封裝:SOT-23-5 包裝:帶卷 (TR) 其它名稱:ADT6501SRJZP085RL7-ND
ADT7519ARQZ1 制造商:AD 制造商全稱:Analog Devices 功能描述:SPI/I2C Compatible, Temperature Sensor, Four Channel ADC and Quad Voltage Output DAC
ADT7519ARQZ1-REEL 制造商:AD 制造商全稱:Analog Devices 功能描述:SPI/I2C Compatible, Temperature Sensor, Four Channel ADC and Quad Voltage Output DAC
ADT7519ARQZ1-REEL7 制造商:AD 制造商全稱:Analog Devices 功能描述:SPI/I2C Compatible, Temperature Sensor, Four Channel ADC and Quad Voltage Output DAC
主站蜘蛛池模板: 柳州市| 喀喇| 永济市| 山西省| 永修县| 遂溪县| 佛冈县| 建宁县| 体育| 大埔县| 仪陇县| 溧阳市| 苍溪县| 高密市| 和田市| 偏关县| 江永县| 榆社县| 霍林郭勒市| 兰坪| 潼南县| 平武县| 红原县| 阿巴嘎旗| 龙川县| 迁西县| 江油市| 扶沟县| 揭西县| 内江市| 江北区| 克山县| 阿克苏市| 苏尼特右旗| 宁津县| 乌兰察布市| 南丰县| 东阳市| 海晏县| 南雄市| 宜兰市|