- 您現在的位置：買賣IC網 > PDF目錄374046 > ADV7173KST (ANALOG DEVICES INC) Digital PAL/NTSC Video Encoder with Six DACs 10 Bits, Color Control and Enhanced Power Management PDF資料下載
參數資料
| 型號： | ADV7173KST |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 顏色信號轉換 |
| 英文描述： | Digital PAL/NTSC Video Encoder with Six DACs 10 Bits, Color Control and Enhanced Power Management |
| 中文描述： | COLOR SIGNAL ENCODER, PQFP48 |
| 封裝： | PLASTIC, TQFP-48 |
| 文件頁數： | 14/59頁 |
| 文件大小： | 455K |
| 代理商： | ADV7173KST |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
ADV7172/ADV7173
–14–
REV. A
FREQUENCY – MHz
4
0
6
1
2
3
4
5
7
A
3
1
0
–2
–3
–1
2
Figure 20. Extended Mode Luma Filter with Programmable
Gain, Positive Response
COLOR BAR GENERATION
The ADV7172/ADV7173 can be configured to generate 75%
amplitude, 75% saturation (75/7.5/75/7.5) for NTSC or 75%
amplitude, 100% saturation (100/0/75/0) for PAL color bars.
These are enabled by setting MR46 of Mode Register 4 to
Logic “1.”
SQUARE PIXEL MODE
The ADV7172/ADV7173 can be used to operate in square pixel
mode. For NTSC operation, an input clock of 24.5454 MHz
is required. Alternatively, for PAL operation, an input clock of
29.5 MHz is required. The internal timing logic adjusts ac-
cordingly for square pixel mode operation.
COLOR SIGNAL CONTROL
The color information can be switched on and off the video
output using Bit MR44 of Mode Register 4.
BURST SIGNAL CONTROL
The burst information can be switched on and off the video
output using Bit MR45 of Mode Register 4.
NTSC PEDESTAL CONTROL
The pedestal on both odd and even fields can be controlled on
a line-by-line basis using the NTSC Pedestal Control Regis-
ters. This allows the pedestals to be controlled during the
Vertical Blanking Interval (lines 10 to 25 and lines 273 to 288).
COLOR CONTROLS
The ADV7172/ADV7173 allows the user the advantage of con-
trolling the brightness, contrast, hue and saturation of the color.
Contrast Control
Contrast adjustment is achieved by scaling the Y input data
by a factor programmed by the user into the Contrast Control
Register Bits 5–0. This factor allows the data to be scaled
between 75% and 125%.
Brightness Control
The brightness is controlled by adding a programmable setup
level onto the scaled Y data. This brightness level may be added
FREQUENCY – MHz
4
6
1
M
2
3
4
5
2
–6
–8
–10
–12
0
–2
–4
Figure 21. Extended Mode Luma Filter with Programmable
Gain, Combined Response
onto the Y data in PAL mode, NTSC mode without pedestal or
NTSC mode with pedestal, in which case it is added directly
onto the 7.5 IRE pedestal already present.
The level added is programmed by the user into the Brightness
Control Register (Bits 4–0) and the user is capable of adding
from 0 IRE to a maximum of 14 IRE in 32 (2
5
) steps. Because
of different gains in the datapath for each mode, different values
may need to be programmed to obtain the same IRE setup level
in each mode. Maximum brightness is achieved when 31 is
programmed into the Brightness Control Register. Table II
illustrates the maximum setup/brightness amplitudes available in
the various modes. Note that if a level of less than 7.5 IRE is
required on the Y data in NTSC mode, then NTSC without
pedestal must be the mode selected.
Table II. Maximum Brightness Levels Available
Brightness Control
Register
Mode
Setup
NTSC No Pedestal
NTSC Pedestal
PAL
00011111
00011111
00011111
14 IRE
13 IRE
99 mV
Color Saturation Control
Color adjustment is achieved by scaling the Cr and Cb input
data by a factor programmed by the user into the Color Control
Registers 1 and 2, Bits 5–0. This factor allows the data to be
scaled between 75% and 125%.
Hue Control
The hue adjustment is achieved on the composite and chroma
outputs by adding a phase offset onto the color subcarrier in the
active video but leaving the color burst unmodified, i.e., only
the phase between the video and the color burst is modified
and hence the hue is shifted. Hue adjustment is under the con-
trol of the Hue Control Register. The ADV7172/ADV7173
provides a range of
±
22
°
change in increments of 0.17578125
°
.
相關PDF資料 |
PDF描述 |
|---|---|
| ADV7172KST | Digital PAL/NTSC Video Encoder with Six DACs 10 Bits, Color Control and Enhanced Power Management |
| ADV7172 | Digital PAL/NTSC Video Encoder with Six DACs 10 Bits, Color Control and Enhanced Power Management |
| ADV7173 | Digital PAL/NTSC Video Encoder with Six DACs 10 Bits, Color Control and Enhanced Power Management |
| ADV7173* | Digital PAL/NTSC Video Encoder with Six DACs (10 Bits). Color Control and Enhanced Power Management |
| ADV7174 | Chip Scale PAL/NTSC Video Encoder with Advanced Power Management |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADV7173KST-REEL | 制造商:Analog Devices 功能描述:Video Encoder 6DAC 10-Bit 48-Pin LQFP T/R |
| ADV7173KSTZ | 功能描述:IC DAC VIDEO NTSC 6-CH 48LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:- 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799 |
| ADV7173KSTZ-REEL | 功能描述:IC DAC VIDEO NTSC 6-CH 48LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:- 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799 |
| ADV7174 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Chip Scale PAL/NTSC Video Encoder with Advanced Power Management |
| ADV7174BCP | 制造商:AD 制造商全稱:Analog Devices 功能描述:Chip Scale PAL/NTSC Video Encoder with Advanced Power Management |
發布緊急采購，3分鐘左右您將得到回復。