- 您現在的位置：買賣IC網 > PDF目錄374049 > AIC1761-CS08 (Analog Devices, Inc.) BATTERY CHARGE CONTROLLER PDF資料下載
參數資料
| 型號： | AIC1761-CS08 |
| 廠商： | Analog Devices, Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | BATTERY CHARGE CONTROLLER |
| 中文描述： | 電池充電控制器 |
| 文件頁數： | 8/15頁 |
| 文件大小： | 245K |
| 代理商： | AIC1761-CS08 |
AIC1761/1766
BATTERY CHARGE CONTROLLER
SPEC NO: DS-1761-02
ANALOG INTEGRATIONS CORPORATION
www.analog.com.tw
4F, 9 Industry E. 9th Road, Science-based Industrial Park , Hsinchu, Taiwan, R.O.C. TEL: (8863)577-2500 FAX:(8863)577-2510
8
MODE PIN
The MODE pin determines the mode in which the
IC works:
MODE
Pin
Mode
Function
Floating
NORMAL
Normal operation
V
DD
TEST
1/512 safety timer
GND
AC
V
timer stops (not reset)
detector
reset,
The AIC1761/1766 will operate normally when the
MODE pin is left floating ( a 0.1
μ
F capacitor is re-
commended to be tied to MODE pin if the charge
circuit works in a noisy environment). The
AIC1761/1766 otherwise works in following ways
if the MODE pin is biased either to V
DD
or to GND:
(A) AC Mode (MODE pin biased to GND)
In the midst of normal charge operation, where
VBT pin voltage is in the range from 0.8V to 3.5V
and the preset safety timer has not run out, the
safety timer will stop if the MODE pin is somehow
pulled down to GND level. As long as the MODE
pin remains low, the VOUT pin stays ON and
LED pin OFF regardless whether the battery pack
voltage declines (-
V present) or not.
The AC mode can be activated by pulling MODE
pin to GND to avoid premature battery charge
cutoff due to fluctuating charge current source.
Switching MODE pin after the end of the safety
timer has no effect on the AIC1761/1766 display
outputs, i.e., VOUT pin stays OFF while LED pin
stays ON.
(B) TEST Mode (MODE pin biased to V
DD
)
An unique feature of the AIC1761/1766 is that it
can be put into a TEST mode by pulling the
MODE pin to V
DD
, allowing verification tests for
the AIC1761/1766 charge circuit to be performed
in a few tens of seconds, extremely valuable in fi-
nal phase of production.
When the AIC1761/1766 is in TEST mode, all the
internal timers are reduced by the following fac-
tors when compared to normal operation:
1. Safety timer reduced by 512 times.
2. Initial timer reduced by 512 times.
3. Peak timer reduced by 64 times.
One critical requirement needs to be observed for
-
V detector of the AIC1761/1766 to work prop-
erly in TEST mode. That is, VBT pin voltage must
be kept between approximately 2.8V to 3.3V,
rather than 0.8V to 3.5V in NORMAL mode.
If the TEST mode function is to be utilized in pro-
duction test, it has to be well planned and includ-
ed in circuit design phase to make the voltages of
VBT pin and MODE pin externally controllable. In
addition, an externally controllable TIMER pin can
further reduce test time required for testing the
AIC1761/1766 in TEST mode.
Fig. 3 shows the timing diagram for externally
controlled VBT, TIMER, and MODE pin voltages
of a recommended AIC1766 charge circuit pro-
duction test scheme, utilizing TEST mode func-
tion. Output waveforms of VOUT and LED pins
(and FLASH pin for 14 pin version) of a properly
functioning AIC1766 are also shown in the figure.
In timer segments 4, 8 and 10, VOUT pin should
change from ON to OFF, LED pin from OFF to
ON, and FLASH pin from ON to flashing output
(approximately 4 Hz). For the reset of time,
VOUT pin should remain ON, LED pin OFF, and
FLASH pin ON.
相關PDF資料 |
PDF描述 |
|---|---|
| AIC1761-CS14 | BATTERY CHARGE CONTROLLER |
| AIC1766-CN08 | BATTERY CHARGE CONTROLLER |
| AIC1766-CN14 | BATTERY CHARGE CONTROLLER |
| AIC1766-CS08 | BATTERY CHARGE CONTROLLER |
| AIC1766-CS14 | BATTERY CHARGE CONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AIC1783AGSTR | 制造商: 功能描述:BATTERY CHARGE CONTROLLER 制造商:undefined 功能描述:BATTERY CHARGE CONTROLLER |
| AIC1790GOWTR | 制造商: 功能描述:1 CELL LINEAR LITHIUM-ION BATTERY CHARGE 制造商:undefined 功能描述:1 CELL LINEAR LITHIUM-ION BATTERY CHARGE |
| AIC1896GGTR | 制造商:undefined 功能描述:1.4MHZ CURRENT-MODE STEP-UP PWM DC-DC |
| AIC1952-KUGG6TTR | 制造商: 功能描述:ANIAIC1952-KUGG6TTR 300MA DUAL OUTPUT 制造商:undefined 功能描述:ANIAIC1952-KUGG6TTR 300MA DUAL OUTPUT |
| AIC2 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Controller Miscellaneous - Datasheet Reference |
發布緊急采購，3分鐘左右您將得到回復。