- 您現在的位置：買賣IC網 > PDF目錄379692 > ASM121 (Electronic Theatre Controls, Inc.) SIMISTOR⑩ TEMPERATURE SENSOR ULTRA-LOW-POWER SILICON THERMISTOR PDF資料下載
參數資料
| 型號： | ASM121 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 元件分類： | 熱敏電阻 |
| 英文描述： | SIMISTOR⑩ TEMPERATURE SENSOR ULTRA-LOW-POWER SILICON THERMISTOR |
| 中文描述： | SIMISTOR⑩溫度傳感器超低功率硅熱敏電阻 |
| 文件頁數： | 3/8頁 |
| 文件大小： | 249K |
| 代理商： | ASM121 |
aSM121
- 3 -
Andigilog, Inc. 2004
www.andigilog.com
July 2005 - 70A04006
25
Figure 1. aSM121 Output Voltage vs. Temperature
Mounting
The aSM121 package provides good thermal
conductivity to the surface to which it is soldered. It’s
low mass allows it to respond quickly to changes in
board temperature. In this case, its temperature will be
within about 0.02°C of the temperature of the surface it
is attached to if the ambient air temperature is almost
the same as the surface temperature. If the air
temperature is much higher or lower than the surface
temperature, the actual temperature of the aSM121
die will be at an intermediate temperature between the
surface temperature and the air temperature.
To ensure good thermal conductivity, the backside of
the aSM121 die is directly attached to the GND pin.
The lands and traces to the aSM121 will, of course, be
part of the printed circuit board, which is the object
whose temperature is being measured. These printed
circuit board lands and traces will not cause the
aSM121’s temperature to deviate from the desired
temperature.
Alternatively, the aSM121 can be mounted inside a
sealed-end metal tube, and can then be dipped into a
bath or screwed into a threaded hole in a tank. As
with any IC, the aSM121 and accompanying wiring
and circuits must be kept insulated and dry to avoid
leakage and corrosion. This is especially true if the
circuit may operate at cold temperatures where
condensation can occur. Printed-circuit coatings and
varnishes such as Humiseal and epoxy paint or dips
can be used to ensure that moisture cannot corrode
the aSM121 or its connections.
50
75
100
125
-30
0
1750
200
750
500
V
OUT
(mV)
Temperature (oC)
1350
Temp (oC) = (V
OUT
– 500mV) / 10mV/oC)
900
300
1500
相關PDF資料 |
PDF描述 |
|---|---|
| ASM121Q3 | SIMISTOR⑩ TEMPERATURE SENSOR ULTRA-LOW-POWER SILICON THERMISTOR |
| ASM51AA | 3.3V SURFACE MOUNT CRYSTALCLOCK OSCILLATORS |
| ASM52AA | 3.3V SURFACE MOUNT CRYSTALCLOCK OSCILLATORS |
| ASM53AA | 3.3V SURFACE MOUNT CRYSTALCLOCK OSCILLATORS |
| ASM54AA | 3.3V SURFACE MOUNT CRYSTALCLOCK OSCILLATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ASM121Q3 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SIMISTOR⑩ TEMPERATURE SENSOR ULTRA-LOW-POWER SILICON THERMISTOR |
| ASM1232LP | 制造商:PULSECORE 制造商全稱:PulseCore Semiconductor 功能描述:5V μP Power Supply Monitor and Reset Circuit |
| ASM1232LPCMA | 制造商:ALSC 制造商全稱:Alliance Semiconductor Corporation 功能描述:5V uP Power Supply Monitor and Reset Circuit |
| ASM1232LPEMA | 制造商:ALSC 制造商全稱:Alliance Semiconductor Corporation 功能描述:5V uP Power Supply Monitor and Reset Circuit |
| ASM1232LPF | 制造商:PULSECORE 制造商全稱:PulseCore Semiconductor 功能描述:5V μP Power Supply Monitor and Reset Circuit |
發布緊急采購，3分鐘左右您將得到回復。