- 您現在的位置：買賣IC網 > PDF目錄379696 > ATT3020-50H84I (Electronic Theatre Controls, Inc.) Field-Programmable Gate Arrays PDF資料下載
參數資料
| 型號： | ATT3020-50H84I |
| 廠商： | Electronic Theatre Controls, Inc. |
| 元件分類： | FPGA |
| 英文描述： | Field-Programmable Gate Arrays |
| 中文描述： | 現場可編程門陣列 |
| 文件頁數： | 17/80頁 |
| 文件大小： | 528K |
| 代理商： | ATT3020-50H84I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
Lucent Technologies Inc.
17
Data Sheet
February 1997
ATT3000 Series Field-Programmable Gate Arrays
Configuration
Initialization Phase
An internal power-on-reset circuit is triggered when
power is applied. When V
CC
reaches the voltage where
portions of the FPGA begin to operate (2.5 V to 3 V),
the programmable I/O output buffers are disabled and a
high-impedance pull-up resistor is provided for the user
I/O pins. A time-out delay is initiated to allow the power
supply voltage to stabilize. During this time, the power-
down mode is inhibited. The initialization state time-out
(about 11 ms to 33 ms) is determined by a 14-bit
counter driven by a self-generated, internal timer. This
nominal 1 MHz timer is subject to variations with pro-
cess, temperature, and power supply over the range of
0.5 MHz to 1.5 MHz. As shown in Table 2, five configu-
ration mode choices are available, as determined by
the input levels of three mode pins: M0, M1, and M2.
In master configuration mode, the FPGA becomes the
source of configuration clock (CCLK). Beginning con-
figuration of devices using peripheral or slave modes
must be delayed long enough for their initialization to
be completed. An FPGA with mode lines selecting a
master configuration mode extends its initialization
state using four times the delay (43 ms to 130 ms) to
ensure that all daisy-chained slave devices it may be
driving will be ready, even if the master is very fast and
the slave(s), very slow (see Figure 18). At the end of
initialization, the FPGA enters the clear state where it
clears configuration memory. The active-low, open-
drain initialization signal
INIT
indicates when the initial-
ization and clear states are complete. The FPGA tests
for the absence of an external active-low
RESET
before
it makes a final sample of the mode lines and enters
the configuration state. An external wired-AND of one
or more
INIT
pins can be used to control configuration
by the assertion of the active-low
RESET
of a master
mode device or to signal a processor that the FPGAs
are not yet initialized.
If a configuration has begun, a reassertion of
RESET
for
a minimum of three internal timer cycles will be recog-
nized and the FPGA will initiate an abort, returning to
the clear state to clear the partially loaded configura-
tion memory words. The FPGA will then resample
RESET
and the mode lines before reentering the con-
figuration state.
A reprogram is initiated when a configured FPGA
senses a high-to-low transition on the DONE/
PROG
package pin. The FPGA returns to the clear state
where configuration memory is cleared and mode lines
resampled, as for an aborted configuration. The com-
plete configuration program is
cleared and loaded dur-
ing each configuration program cycle.
Table 2. Configuration Modes
M0 M1 M2
Clock
Mode
Data
0
0
0
0
0
1
Active
Active
Master
Master
Bit Serial
Byte Wide
(Address = 0000
up)
—
Byte Wide
(Address = FFFF
down)
—
Byte Wide
—
Bit Serial
0
0
1
1
0
1
—
Reserved
Master
Active
1
1
1
1
0
0
1
1
0
1
0
1
—
Reserved
Peripheral
Reserved
Slave
Active
—
Passive
相關PDF資料 |
PDF描述 |
|---|---|
| ATT3020-50J132I | Field-Programmable Gate Arrays |
| ATT3020-50J44I | Field-Programmable Gate Arrays |
| ATT3020-50J68I | Field-Programmable Gate Arrays |
| ATT3020-50J84I | Field-Programmable Gate Arrays |
| ATT3020-50M132I | Field-Programmable Gate Arrays |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ATT3020-50J132I | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays |
| ATT3020-50J44I | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays |
| ATT3020-50J68I | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays |
| ATT3020-50J84I | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays |
| ATT3020-50M132I | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays |
發布緊急采購，3分鐘左右您將得到回復。