- 您現在的位置：買賣IC網 > PDF目錄374059 > C052C102J5R5CA (KEMET Corporation) Bipolar Transistor; Transistor Polarity:N Channel; Power Dissipation:40W; C-E Breakdown Voltage:250V; DC Current Gain Min (hfe):2000; Collector Current:6A; Package/Case:TO-3; Power (Ptot):40W; Current Rating:16A; Voltage Rating:180V PDF資料下載
參數資料
| 型號： | C052C102J5R5CA |
| 廠商： | KEMET Corporation |
| 英文描述： | Bipolar Transistor; Transistor Polarity:N Channel; Power Dissipation:40W; C-E Breakdown Voltage:250V; DC Current Gain Min (hfe):2000; Collector Current:6A; Package/Case:TO-3; Power (Ptot):40W; Current Rating:16A; Voltage Rating:180V |
| 中文描述： | 背面軍事SPECIFCATIONS |
| 文件頁數： | 37/40頁 |
| 文件大小： | 580K |
| 代理商： | C052C102J5R5CA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁當前第37頁第38頁第39頁第40頁
KEMET Electronics Corporation, P.O. Box 5928, Greenville, S.C. 29606, (864) 963-6300
37
KEMET
APPLICATION NOTES FOR MULTILAYER CERAMIC CAPACITORS
A
Effect of Temperature:
Both capacitance and dissipa-
tion factor are affected by variations in temperature. The max-
imum capacitance change with temperature is defined by the
temperature characteristic. However, this only defines a “box”
bounded by the upper and lower operating temperatures and
the minimum and maximum capacitance values. Within this
“box”, the variation with temperature depends upon the spe-
cific dielectric formulation. Typical curves for KEMET capaci-
tors are shown in Figures 3, 4, and 5. These figures also
include the typical change in dissipation factor for KEMET
capacitors.
Insulation resistance decreases with temperature.
Typically, the insulation resistance at maximum rated temper-
ature is 10% of the 25°C value.
Effect of Voltage:
Class I ceramic capacitors are not
affected by variations in applied AC or DC voltages. For Class
II and III ceramic capacitors, variations in voltage affect only
the capacitance and dissipation factor. The application of DC
voltage higher than 5 vdc reduces both the capacitance and
dissipation factor. The application of AC voltages up to 10-20
Vac tends to increase both capacitance and dissipation factor.
At higher AC voltages, both capacitance and dissipation factor
begin to decrease.
Typical curves showing the effect of applied AC and DC
voltage are shown in Figure 6 for KEMET X7R capacitors and
Figure 7 for KEMET Z5U capacitors.
Effect of Frequency:
Frequency affects both capaci-
tance and dissipation factor. Typical curves for KEMET multi-
layer ceramic capacitors are shown in Figures 8 and 9.
T
he variation of impedance with frequency is an impor-
tant consideration in the application of multilayer ceramic
capacitors. Total impedance of the capacitor is the vector of the
capacitive reactance, the inductive reactance, and the ESR, as
illustrated in Figure 2. As frequency increases, the capacitive
reactance decreases. However, the series inductance (L)
shown in Figure 1 produces inductive reactance, which
increases with frequency. At some frequency, the impedance
ceases to be capacitive and becomes inductive. This point, at
the bottom of the V-shaped impedance versus frequency
curves, is the self-resonant frequency. At the self-resonant fre-
quency, the reactance is zero, and the impedance consists of
the ESR only.
Typical impedance versus frequency curves for KEMET
multilayer ceramic capacitors are shown in Figures 10, 11, and
12. These curves apply to KEMET capacitors in chip form, with-
out leads. Lead configuration and lead length have a significant
impact on the series inductance. The lead inductance is
approximately 10nH/inch, which is large compared to the
inductance of the chip. The effect of this additional inductance
is a decrease in the self-resonant frequency, and an increase
in impedance in the inductive region above the self-resonant
frequency.
Effect of Time:
The capacitance of Class II and III
dielectrics change with time as well as with temperature, volt-
age and frequency. This change with time is known as “aging.”
It is caused by gradual realignment of the crystalline structure
of the ceramic dielectric material as it is cooled below its Curie
temperature, which produces a loss of capacitance with time.
The aging process is predictable and follows a logarithmic
decay. Typical aging rates for C0G, X7R, and Z5U dielectrics
are as follows:
C0G
X7R
Z5U
None
1.0% per decade of time
5.0% per decade of time
Typical aging curves for X7R and Z5U dielectrics are
shown in Figure 13.
The aging process is reversible. If the capacitor is heat-
ed to a temperature above its Curie point for some period of
time, de-aging will occur and the capacitor will regain the
capacitance lost during the aging process. The amount of de-
aging depends on both the elevated temperature and the
length of time at that temperature. Exposure to 150°C for one-
half hour or 125°C for two hours is usually sufficient to return
the capacitor to its initial value.
Because the capacitance changes rapidly immediately
after de-aging, capacitance measurements are usually delayed
for at least 10 hours after the de-aging process, which is often
referred to as the “l(fā)ast heat.” In addition, manufacturers utilize
EFFECT OF APPLIED VOLTAGE
0.1
1
10
100
AC or DC Volts Applied
Typical Effects of 1000 Hz AC and DC Voltage Level on
Capacitance and Dissipation Factor - Z5U
Note: C0G Dielectric capacitance and dissipation factor are
stable with voltage.
Figure 7.
1
2
3
4
+20
0
-20
-40
-60
1
2
3
4
+10
+5
0
-5
-10
0.1
1
10
100
AC or DC Volts Applied
Typical Effects of 1000 Hz AC and DC Voltage Level on
Capacitance and Dissipation Factor - X7R
Note: C0G Dielectric capacitance and dissipation factor are
stable with voltage.
Figure 6.
DC
AC
AC
DC
%
%
%
%
DC
AC
AC
DC
相關PDF資料 |
PDF描述 |
|---|---|
| C062C102J5R5CA | MILITARY SPECIFCATIONS ON BACK |
| C052C102J5G5CA | MILITARY SPECIFCATIONS ON BACK |
| C062C102J5G5CA | MILITARY SPECIFCATIONS ON BACK |
| C052G102J5G5CA | MILITARY SPECIFCATIONS ON BACK |
| C062G102J5G5CA | T-PNP-DIFFERENTIAL AMP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| C052C102J5R5HA | 功能描述:多層陶瓷電容器MLCC - 含引線 50volts 1000pF 5% X7R RoHS:否 制造商:Kemet 電容: 容差: 電壓額定值: 端接類型: 工作溫度范圍: 溫度系數/代碼: 引線間隔: 產品: 引線類型: |
| C052C102J5R5TA | 功能描述:多層陶瓷電容器MLCC - 含引線 50volts 1000pF 5% X7R RoHS:否 制造商:Kemet 電容: 容差: 電壓額定值: 端接類型: 工作溫度范圍: 溫度系數/代碼: 引線間隔: 產品: 引線類型: |
| C052C102K1G5CA | 功能描述:多層陶瓷電容器MLCC - 含引線 100volts 1000pF 10% C0G RoHS:否 制造商:AVX 電容:470 pF 容差:10 % 電壓額定值:3 kV 端接類型:Radial 工作溫度范圍: 溫度系數/代碼:X7R 引線間隔:5.08 mm 產品:Automotive MLCCs 引線類型: |
| C052C102K1G5CA7301 | 功能描述:多層陶瓷電容器MLCC - 含引線 100volts 1000pF 10% C0G RoHS:否 制造商:AVX 電容:470 pF 容差:10 % 電壓額定值:3 kV 端接類型:Radial 工作溫度范圍: 溫度系數/代碼:X7R 引線間隔:5.08 mm 產品:Automotive MLCCs 引線類型: |
| C052C102K1G5CA7305 | 制造商:KEMET Corporation 功能描述:Cap Ceramic 0.001uF 100V C0G 10% Radial 5.08mm 125 |
發布緊急采購，3分鐘左右您將得到回復。