- 您現在的位置：買賣IC網 > PDF目錄366738 > CAT5113R-00TSSOP Network Cable Assembly; Connector Type A:Modular T568A; Connector Type B:Stripped End Leads; Cable Length:25ft; Approval Categories:Augmented Category 6 standards; cord color per TIA/EIA-606 standard RoHS Compliant: Yes PDF資料下載
參數資料
| 型號： | CAT5113R-00TSSOP |
| 英文描述： | Network Cable Assembly; Connector Type A:Modular T568A; Connector Type B:Stripped End Leads; Cable Length:25ft; Approval Categories:Augmented Category 6 standards; cord color per TIA/EIA-606 standard RoHS Compliant: Yes |
| 中文描述： | 100抽頭數字可編程的緩沖雨刮電位（民進黨） |
| 文件頁數： | 1/7頁 |
| 文件大?。?/td> | 67K |
| 代理商： | CAT5113R-00TSSOP |
CAT5111
100-Tap Digitally Programmable Potentiometer (DPP)
with Buffered Wiper
FEATURES
I
100-position linear taper potentiometer
I
Non-volatile NVRAM wiper storage;
buffered wiper
I
Low power CMOS technology
I
Single supply operation: 2.5V-6.0V
I
Increment up/down serial interface
I
Resistance values: 10k
I
Available in PDIP, SOIC, TSSOP and MSOP packages
,
50k
and 100k
APPLICATIONS
I
Automated product calibration
I
Remote control adjustments
I
Offset, gain and zero control
I
Tamper-proof calibrations
I
Contrast, brightness and volume controls
I
Motor controls and feedback systems
I
Programmable analog functions
system values without effecting the stored
setting. Wiper-control of the CAT5111 is
accomplished with three input control pins,
CS
, U/
D
,
and
INC
. The
INC
input increments the wiper in the
direction which is determined by the logic state of
the U/
D
input. The
CS
input is used to select the
device and also store the wiper position prior to
power down.
The digitally programmable potentiometer can be
used as a buffered voltage divider. For applications
where the potentiometer is used as a 2-terminal variable
resistor, please refer to the CAT5113. The buffered
wiper of the CAT5111 is not compatible with that
application. DPPs bring variability and programmability
to a broad range of applications and are used primarily
to control, regulate or adjust a characteristic or parameter
of an analog circuit.
FUNCTIONAL DIAGRAM
DESCRIPTION
The CAT5111 is a single digitally programmable
potentiometer (DPP) designed as a electronic
replacement for mechanical potentiometers and trim
pots. Ideal for automated adjustments on high volume
production lines, they are also well suited for
applications where equipment requiring periodic
adjustment is either difficult to access or located in a
hazardous or remote environment.
The CAT5111 contains a 100-tap series resistor array
connected between two terminals R
H
and R
L
. An up/
down counter and decoder that are controlled by three
input pins, determines which tap is connected to the
wiper, R
WB
. The CAT5111 wiper is buffered by an op
amp that operates rail to rail. The wiper setting, stored in
non-volatile NVRAM memory, is not lost when the device
is powered down and is automatically recalled when
power is returned. The wiper can be adjusted to test new
Electronic Potentiometer
Implementation
RH
+
–
RWB
RL
CS
INC
U
/D
Control
and
Memory
V
CC
R
R
R
WB
H
L
Power On Recall
GND
+
-
2004 by Catalyst Semiconductor, Inc.
Characteristics subject to change without notice
Doc. No. 2008, Rev. O
1
H
A
L
O
G
E
N
F
R
E
E
TM
L
E
A
D
F
R
E
E
相關PDF資料 |
PDF描述 |
|---|---|
| CAT5113R-50MSOP | Network Hub; Approval Categories:12V Portocol Compatibility; Data Rate Max:100Mbps RoHS Compliant: Yes |
| CAT5113R-50SOIC | Network Hub; Approval Categories:12V Portocol Compatibility; Data Rate Max:100Mbps RoHS Compliant: Yes |
| CAT5113R-50TSSOP | Network Hub; Approval Categories:12V Portocol Compatibility; Data Rate Max:100Mbps RoHS Compliant: Yes |
| CAT5113U-00MSOP | WIRE, PTFE, A, PINK, 7/0.15MM, 100M; Area, conductor CSA:0.124mm2; Conductor make-up:7/0.15mm; Voltage rating, AC:300V; Current rating:4A; Colour, primary insulation:Pink; Material, primary insulation:PTFE; Diameter, External:0.8mm; RoHS Compliant: Yes |
| CAT5113U-00SOIC | WIRE, PTFE, A, RED, 7/0.15MM, 100M; Area, conductor CSA:0.124mm2; Conductor make-up:7/0.15mm; Voltage rating, AC:300V; Current rating:4A; Colour, primary insulation:Red; Material, primary insulation:PTFE; Diameter, External:0.8mm; RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CAT5113R-10 | 功能描述:數字電位計 IC Com Temp 10K Up/Dwn RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| CAT5113RI-00 | 功能描述:數字電位計 IC Ind Temp 100K Up/Dwn RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| CAT5113RI-10 | 功能描述:數字電位計 IC Ind Temp 10K Up/Dwn RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| CAT5113S00 | 功能描述:數字電位計 IC Com Temp 100K Up/Dwn RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| CAT5113S-10 | 功能描述:數字電位計 IC Com Temp 10K Up/Dwn RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。