欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: CS1501-9RD9TB2
元件分類: 電源模塊
英文描述: 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
封裝: METAL, CASE S02, MODULE
文件頁數: 19/31頁
文件大小: 633K
代理商: CS1501-9RD9TB2
Cassette Style
100 Watt DC-DC Converters
S Series
Edition 1/01.2000
26/31
Fig. 28
Paralleling of single output units using option T with the
sense lines connected at the load
1 Leads should have equal length and cross sections and should
run in the same cable loom.
2 Diodes recommended in redundant operation only
3 DC common point
Load
1
2
3
S+
Vo+
Vo–
S–
Vi+
Vi–
T
Vi+
Vi–
S+
Vo+
Vo–
S–
T
1
max. 5 units in parallel connection
11036
Load
max. 5 units in parallel connection
+
Power bus
Module
Vo2–
Vo2+
Vo1–
Vo1+
T
Module
Vo2–
Vo2+
Vo1–
Vo1+
T
11037
Fig. 29
Paralleling of double output units using option T (e.g.
Powerbus)
Vo+
Vo–
Vo+
Vo–
Load
Vo+
Vo–
11003
Fig. 27
An example of poor wiring for connection in parallel
T Current Sharing
This option ensures that the output currents are approxi-
mately shared between all paralleled modules, hence in-
creasing system reliability. To use this facility, simply inter-
connect the T pins of all modules and make sure, that pins
14, the S– pins (S 1000) or the Vo1– pins (S 2000) are also
connected together. The load leads should have equal
length and cross section to ensure equal voltage drops. Not
more than 5 units should be connected in parallel.
Note: If output voltage adjustment is requested we strongly
recommend to use the R-input instead of option P, as with
option P the required setting accuracy is difficult to achieve.
The output voltages must be individually set prior to paral-
leling to within a tolerance of 1...2% or the R pins should be
connected together.
P Potentiometer
The potentiometer provides an output voltage adjustment
range of +10/–60% of
Uo nom and is accessible through a
hole in the front cover. This feature enables compensation
of voltage drops across the connector and wiring. Option P
is not recommended if units are connected in parallel.
Option P excludes the R-function. With double output units
both outputs are affected by the potentiometer setting (dou-
bling the voltage setting if the outputs are in series).
If the output voltages are increased above
Uo nom via R-in-
put control, option P setting, remote sensing or option T, the
output current(s) should be reduced accordingly so that
Po nom is not exceeded.
D Undervoltage Monitor
The input and/or output undervoltage monitoring circuit op-
erates independently of the built-in input undervoltage lock-
out circuit. A logic "low" (JFET output) or "high" signal (NPN
output) is generated at pin 20 as soon as one of the moni-
tored voltages drops below the preselected threshold level
Ut. The return for this signal is Vo1–. The D output recovers
when the monitored voltage(s) exceed(s)
Ut + Uh. The
threshold levels
Uti and Uto are either adjustable by a poten-
tiometer, accessible through a hole in the front cover, or fac-
tory adjusted to a fixed value specified by the customer.
Option D exists in various versions D0...DD as shown in the
following table.
相關PDF資料
PDF描述
CS1601-7PD6B1 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
CS1601-7PD8T 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
CS1601-7RD7B2 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
CS1601-9ERDD 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
CS1601-9PD1TB2 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
CS1501-FSZ 功能描述:功率因數校正 IC DIGITAL PFC CONT. IC FOR SMPS RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel
CS1501-FSZR 制造商:Cirrus Logic 功能描述:IC PFC CONTROLLER DCM OCP - Tape and Reel 制造商:Cirrus Logic 功能描述:IC PFC CTRLR DCM OCP 8SOIC 制造商:Cirrus Logic 功能描述:PFC Controller
CS15020_STRADA-IP-2X6-VSM 功能描述:LENS 0 POS MM (D) MM(H) 制造商:ledil 系列:* 零件狀態:有效 標準包裝:6
CS15-02GO2 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Netzthyristoren Phase control thyristors
CS15-04GO2 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Netzthyristoren Phase control thyristors
主站蜘蛛池模板: 揭西县| 岚皋县| 盖州市| 岳阳市| 小金县| 连山| 兴安盟| 读书| 松原市| 达尔| 子洲县| 罗田县| 将乐县| 永清县| 滨海县| 靖边县| 绍兴市| 梁河县| 增城市| 阿鲁科尔沁旗| 崇左市| 额济纳旗| 格尔木市| 华宁县| 华安县| 拉萨市| 晴隆县| 宁都县| 白沙| 宜良县| 河间市| 阿拉善右旗| 泰兴市| 沽源县| 石首市| 九龙县| 浦城县| 错那县| 温州市| 行唐县| 渭南市|