- 您現在的位置：買賣IC網 > PDF目錄375705 > F43D (TT Electronics / Welwyn) High Voltage Thick Film Resistors PDF資料下載
參數資料
| 型號： | F43D |
| 廠商： | TT Electronics / Welwyn |
| 英文描述： | High Voltage Thick Film Resistors |
| 中文描述： | 高壓厚膜電阻 |
| 文件頁數： | 2/2頁 |
| 文件大?。?/td> | 84K |
| 代理商： | F43D |
High Voltage
Thick Film Resistors
F Series
Welwyn Components Limited
Bedlington, Northumberland NE22 7AA, UK
Telephone: +44 (0) 1670 822181 · Facsimile: +44 (0) 1670 829465 · Email: info@welwyn-tt.com · Website: www.welwyn-tt.com
Issue B · 03.02
Welwyn Components
202
Application Notes
Mounting
Due to the high voltage which can appear between the end
cap and any adjacent metal part, resistors should be mounted
at an adequate distance from other conductors.
Resistors may be screwed together to provide an assembly
which will be capable of withstanding any desired voltage,
providing no individual resistor is subjected to a greater stress
or power dissipation than is recommended in this data sheet.
For some high voltage applications it is required to immerse
the components in oil or gas to reduce the effects of corona
and surface tracking. A special lacquer is available, suitable
for immersion in transformer oil of SF6.
When resistors are required to be potted, the preferred
encapsulant is a silicone compound.
For voltage dividers with a low resistance section below the
minimum available value of an F43 resistors, it is entirely
suitable to use an RC Series resistor, available down to 1 ohm.
Standard Quantities Per Box
All Types
10 or 20 per box
Construction
The Cermetox
thick film is fired on to the surface of a high
quality ceramic former. Turned brass end caps are fitted. A
helical cut is made into the film to adjust its ohmic value and
finally a sleeve is fitted to provide mechanical protection and
electrical insulation. Resistors for use in oil SF6 can be
supplied with a lacquer protection instead of the sleeve.
Terminations
Three styles of termination are available to permit resistors to
be screwed together in a series chain, with the end members
having axial wires for soldering.
Wire Terminations:
Styles D and KU
Non standard wire terminations
available upon request.
Solder coated copper wire
The terminations meet the requirements
of IEC 68.2.21.
The terminations meet the requirements
of IEC 115-1, Clause 4.17.3.2.
Material:
Strength:
Solderability:
Screw Terminations:
Material:
Screw Thread:
Styles TU and KU
Turned brass
All caps are tapped UNF - 10 x 4.2
deep. UNF - 10 is 32 TPI, 60° thread
angle 4.72 ±0.07 mm outside diameter,
3.83 mm core diameter.
All KU & TU resistors are supplied with
8 mm long screwed brass studs.
Coupling Stud:
Marking
Type reference, resistance value, tolerance and date code are
legend marked. The resistance values conform to IEC 62.
Solvent Resistance
The lacquer and protective sleeve provide excellent resistance
to all normal industrial cleaning solvents suitable for printed
circuits.
Matched Sets
Matched sets can be supplied for use as voltage dividers.
These may be screwed together to form sticks and, by
selecting the KU type of termination, a wire connection can
be provided at each end of the stick.
Enquiries are welcomed for special resistors and sets when
resistor length, operating voltage or resistance vale is outside
the catalogued range.
Packaging
All components are supplied in boxes.
Maximum
Typical
Load at rated power: 1000 hours at 20°C
R%
R%
5
1
Shelf life: 12 months at room temperature
0.5
Derating from rated power at 20°C
Zero at 100°C
Noise (μV/V in a decade of frequency)
<2.5
Voltage coefficient of resistance
ppm/V
<25
Performance Data
相關PDF資料 |
PDF描述 |
|---|---|
| F4655-01 | WIDE DYNAMIC RANGE MCP ASSEMBLY FOR HELIUM LEAK DETECTOR |
| F4655-12 | COMPACT MCP ASSEMBLY FOR TOF |
| F4655-13 | MCP ASSEMBLY FOR HIGH RESOLUTION TOF-MS |
| F497 | 16-bit Proprietary Microcontroller CMOS |
| F49L160BA | 16 Mbit (2M x 8/1M x 16) 3V Only CMOS Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| F43KI2330ZB01K | 功能描述:薄膜電容器 275vac 0.033uF 10% RoHS:否 制造商:Cornell Dubilier 產品類型: 電介質:Polyester 電容:0.047 uF 容差:10 % 電壓額定值:100 V 系列:225P 工作溫度范圍:- 55 C to + 85 C 端接類型:Radial 引線間隔:9.5 mm |
| F43KI2330ZD01K | 制造商:KEMET Corporation 功能描述: |
| F43KI2470ZA01K | 功能描述:薄膜電容器 275vac 0.047uF 10% RoHS:否 制造商:Cornell Dubilier 產品類型: 電介質:Polyester 電容:0.047 uF 容差:10 % 電壓額定值:100 V 系列:225P 工作溫度范圍:- 55 C to + 85 C 端接類型:Radial 引線間隔:9.5 mm |
| F43KN2330ZF01K | 功能描述:薄膜電容器 275vac 0.033uF 10% RoHS:否 制造商:Cornell Dubilier 產品類型: 電介質:Polyester 電容:0.047 uF 容差:10 % 電壓額定值:100 V 系列:225P 工作溫度范圍:- 55 C to + 85 C 端接類型:Radial 引線間隔:9.5 mm |
| F43KN3100ZB01K | 功能描述:薄膜電容器 275vac 0.1uF 10% RoHS:否 制造商:Cornell Dubilier 產品類型: 電介質:Polyester 電容:0.047 uF 容差:10 % 電壓額定值:100 V 系列:225P 工作溫度范圍:- 55 C to + 85 C 端接類型:Radial 引線間隔:9.5 mm |
發布緊急采購，3分鐘左右您將得到回復。