欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: FM24C32UTHVN
廠商: FAIRCHILD SEMICONDUCTOR CORP
元件分類: DRAM
英文描述: EEPROM
中文描述: 4K X 8 I2C/2-WIRE SERIAL EEPROM, PDIP8
封裝: DIP-8
文件頁數: 8/13頁
文件大小: 85K
代理商: FM24C32UTHVN
8
www.fairchildsemi.com
FM24C32U Rev. A.1
F
Pin Descriptions
Serial Clock (SCL)
The SCL input is used to clock all data into and out of the device.
Serial Data (SDA)
SDA is a bi-directional pin used to transfer data into and out of the
device. It is an open drain output and may be wire
ORed with any
number of open drain or open collector outputs.
Write Protect (WP)
If tied to V
CC
, PROGRAM operations onto the upper half (upper
16Kbits) of the memory will not be executed. READ operations are
possible. If tied to V
SS
, normal operation is enabled, READ/
WRITE over the entire memory is possible.
This feature allows the user to assign the upper half of the memory
as ROM which can be protected against accidental programming.
When write is disabled, slave address and word address will be
acknowledged but data will not be acknowledged.
This pin has an internal pull-down circuit. However, on systems
where write protection is not required it is recommended that this
pin is tied to V
SS
.
Device Selection Inputs A2, A1 and A0 (as
appropriate)
These inputs collectively serve as
chip select
signal to an
EEPROM when multiple EEPROMs are present on the same IIC
bus. Hence these inputs should be connected to V
CC
or V
SS
in a
unique manner to allow proper selection of an EEPROM amongst
multiple EEPROMs. During a typical addressing sequence, every
EEPROM on the IIC bus compares the configuration of these
inputs to the respective 3 bit
Device/Page block selection
information (part of slave address) to determine a valid selection.
For e.g. if the 3 bit
Device/Page block selection
is 1-0-1, then the
EEPROM whose
Device Selection inputs
(A2, A1 and A0) are
connected to V
CC
-V
SS
-V
CC
respectively, is selected.
Device Operation
The FM24C32U supports a bi-directional bus oriented protocol.
The protocol defines any device that sends data onto the bus as
a transmitter and the receiving device as the receiver. The device
controlling the transfer is the master and the device that is
controlled is the slave. The master will always initiate data
transfers and provide the clock for both transmit and receive
operations. Therefore, the FM24C32U will be considered a slave
in all applications.
Clock and Data Conventions
Data states on the SDA line can change only during SCL LOW.
SDA state changes during SCL HIGH are reserved for indicating
start and stop conditions. Refer Figure 1.
Start Condition
All commands are preceded by the start condition, which is a
HIGH to LOW transition of SDA when SCL is HIGH. The FM24C32U
continuously monitors the SDA and SCL lines for the start condi-
tion and will not respond to any command until this condition has
been met. Refer Figure 2.
Stop Condition
All communications are terminated by a stop condition, which is a
LOW to HIGH transition of SDA when SCL is HIGH. The stop
condition is also used by the FM24C32U to place the device in the
standby power mode. Refer Figure 2.
FM24C32U Array Addressing
During Read/Write operations, addressing the EEPROM memory
array involves in providing 2 address bytes,
Word Address 1
and
Word Address 0." However on FM24C32U only the 4 least
significant bits (LSB) of
Word Address 1
byte are used in
decoding the access location. The remaining 4 bits are not used
and are recommended to be set to
0
. All 8 bits of the
Word
Address 0
byte are used in decoding the access location.
相關PDF資料
PDF描述
FM24C32UTLEM8 EEPROM
FM24C32UTLEN EEPROM
FM24C32UTLM8 EEPROM
FM24C32UTLN EEPROM
FM24C32UTLVM8 EEPROM
相關代理商/技術參數
參數描述
FM24C32UTLEM8 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:EEPROM
FM24C32UTLEN 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:EEPROM
FM24C32UTLM8 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:EEPROM
FM24C32UTLN 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:EEPROM
FM24C32UTLVM8 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:EEPROM
主站蜘蛛池模板: 孟州市| 淮安市| 南澳县| 澄江县| 陈巴尔虎旗| 始兴县| 金溪县| 城固县| 揭阳市| 光山县| 沈丘县| 辽宁省| 德昌县| 尤溪县| 沙河市| 晋宁县| 抚顺县| 荔波县| 蒙城县| 安西县| 吉林省| 北流市| 怀化市| 昌宁县| 和硕县| 宜兰市| 永康市| 九龙县| 清徐县| 临汾市| 嵊州市| 旌德县| 文成县| 宁国市| 土默特右旗| 冕宁县| 新余市| 台湾省| 易门县| 安庆市| 米林县|