- 您現在的位置：買賣IC網 > PDF目錄375851 > FM3570 (Fairchild Semiconductor Corporation) 2mm TERMINAL STRIP PDF資料下載
參數資料
| 型號： | FM3570 |
| 廠商： | Fairchild Semiconductor Corporation |
| 英文描述： | 2mm TERMINAL STRIP |
| 中文描述： | CPU的配置控制器注冊/多路微機西元 |
| 文件頁數： | 3/8頁 |
| 文件大?。?/td> | 93K |
| 代理商： | FM3570 |
3
www.fairchildsemi.com
F
R
FM3570 Rev. A
Functional Description
The FM3570 block diagram is shown in Figure 1. The device has
two primary functional modes of operationi and an additional
mode for programming the device.
Operational Modes
During standard operation, the device will either pass an address
to the Y-Port from the I-Port or from an internally programmed
value.
The I-port values are generated from the motherboard of the
system and may be hardwired or driven by another device. Pull-
up resistors are provided on the device to accommodate this
device being driven by open-drain output drivers. The voltage
level to which the I-port is pulled up to is determined by the voltage
on the EPV pin. The device expects standard CMOS input signals.
The the non-multiplexed output is always at CMOS levels. The
OVRD (override) input, when set to 0, will cause all the outputs to
be set to 0. The WP signal, if set to logic 1, will prevent data from
being written to the non-volatile register.
The MUXSEL input, when set to logic 0, will select the data from
the non-volatile register to drive on the Y0-4 outputs. if set to logic
1, the data from the inputs are selected instead. the non_mux_out
latch is transparent when the MUXSEL signal is at logic 0, and will
latch when the MUXSEL is in a logic 1 state.
Output Port: Y0-Y4
The output port is an open-drain output to allow for easy connec-
tion to devices running at different voltage levels. The port is
always active and either passes the value on the I-Port or the value
in the Serial output port (SOPR). Changing the Mux Path is
accomplished by writing to b7 of the Serial Input Port Register.
SOPR-b7 defaults to a value of zero at power up and the default
path is from the I-port though to the output port. The multiplexer
only updates when an IIC stop condition is observed.
Register Description
The FM3570 has 3 registers in total. These registers are made up
of a combination of read-only, write-only and read/write bits. The
two registers are listed below.
Serial Output Port Register A(SOPRA) Address: 00H- A read/
write register that contains the new value to be written to output
Port-Y and the multiplexer select bit.
Serial Output Port Register B(SOPRB) Address: 01H- A read/
write register that contains the new value to be written to output
Port-Y and the multiplexer select bit.
Parallel Input Port Register (PIPR) Address: 02H- A read-only
register that is loaded with the 5-bit value of the I-Port.
Serial Output Port Register (SOPR)
(Address 000b and 001b)
MXSB MXSA
Data Field
0
0
I5
NMO
I3
I2
I1
I0
b7
b6
b5
b4
b3
b2
b1
b0
b7-b6 - Multiplexer Select Bits (MXSB, MXSA)
00 - Multiplexer passes the SOPR(A).
01 - Multiplexer passer the SOPR(B).
10 - Multiplexer defaults to passing the I-Port Value.
b5, b3-b0 - Data Field. New value to be output through the
multiplexer.
NMO - Non-multiplexed output from internal non-volatile bit.
Parallel Input Port Register (PIPR)
(Address 002b)
Address Field
Data Field
0
0
0
I4
I3
I2
I1
I0
b7
b6
b5
b4
b3
b2
B1
b0
b7-b5 - Address field. Value is always 000
b4-b0 - Data Field. Value is equal to the value on the I-Port.
The external Port Register captures the value on the I-Port. Data
is latched into this register on the first clock after a start condition
is seen. This insures that a valid value will always be in this register
if it is read. This register is a-read only register with respect to the
IIC port.
相關PDF資料 |
PDF描述 |
|---|---|
| FM3570M20 | 2mm TERMINAL STRIP |
| FM3570M20X | CPU CONFIGURATION CONTROLLER Register/Multiplexer for Microprocessor VID |
| FM3570MT20 | CPU CONFIGURATION CONTROLLER Register/Multiplexer for Microprocessor VID |
| FM3570MT20X | 2mm TERMINAL STRIP |
| FM3580 | 5-Bit VID Controller with PC Security Element |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FM3570AA_3116B WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| FM3570M20 | 功能描述:編碼器、解碼器、復用器和解復用器 4/5-Bit Multiplexed 1Bit Latched Port RoHS:否 制造商:Micrel 產品:Multiplexers 邏輯系列:CMOS 位數: 線路數量（輸入/輸出）:2 / 12 傳播延遲時間:350 ps, 400 ps 電源電壓-最大:2.625 V, 3.6 V 電源電壓-最小:2.375 V, 3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Tray |
| FM3570M20_Q | 功能描述:編碼器、解碼器、復用器和解復用器 4/5-Bit Multiplexed 1Bit Latched Port RoHS:否 制造商:Micrel 產品:Multiplexers 邏輯系列:CMOS 位數: 線路數量（輸入/輸出）:2 / 12 傳播延遲時間:350 ps, 400 ps 電源電壓-最大:2.625 V, 3.6 V 電源電壓-最小:2.375 V, 3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Tray |
| FM3570M20X | 功能描述:編碼器、解碼器、復用器和解復用器 4/5-Bit Multiplexed 1Bit Latched Port RoHS:否 制造商:Micrel 產品:Multiplexers 邏輯系列:CMOS 位數: 線路數量（輸入/輸出）:2 / 12 傳播延遲時間:350 ps, 400 ps 電源電壓-最大:2.625 V, 3.6 V 電源電壓-最小:2.375 V, 3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Tray |
| FM3570MT20 | 功能描述:編碼器、解碼器、復用器和解復用器 4/5-Bit Multiplexed 1Bit Latched Port RoHS:否 制造商:Micrel 產品:Multiplexers 邏輯系列:CMOS 位數: 線路數量（輸入/輸出）:2 / 12 傳播延遲時間:350 ps, 400 ps 電源電壓-最大:2.625 V, 3.6 V 電源電壓-最小:2.375 V, 3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。