- 您現在的位置：買賣IC網 > Datasheet目錄61 > GP1L52VJ000F (Sharp Microelectronics)SENSOR OPTO SLOT 3MM DARL THRU Datasheet資料下載
參數資料
| 型號： | GP1L52VJ000F |
| 廠商： | Sharp Microelectronics |
| 文件頁數： | 9/12頁 |
| 文件大小： | 234K |
| 描述： | SENSOR OPTO SLOT 3MM DARL THRU |
| 產品變化通告： | Internal Chip Change 04/May/2007 |
| 標準包裝： | 100 |
| 檢測距離： | 0.118"（3mm） |
| 檢測方法： | 可傳導的 |
| 輸出配置： | 光電達林頓管 |
| 電流 - DC 正向(If)： | 50mA |
| 電流 - 集電極 (Ic)（最大）： | 40mA |
| 電壓 - 集電極發射極擊穿（最大）： | 35V |
| 響應時間： | 80µs，70µs |
| 安裝類型： | 通孔 |
| 封裝/外殼： | PCB 安裝 |
| 包裝： | 散裝 |
| 類型： | 無放大 |
| 工作溫度： | -25°C ~ 85°C |
| 其它名稱： | 425-2781 GP1L52VJ000F-ND |
9
Sheet No.: D3-A03201FEN
GP1L52VJ000F
?SPAN class="pst GP1L52VJ000F_2586869_4">Manufacturing Guidelines
?/DIV>
Soldering Method
Flow Soldering:
Soldering should be completed below 260贑 and within 5 s.
Please take care not to let any external force exert on lead pins.
Please don't do soldering with preheating, and please don't do soldering by re ow.
Hand soldering
Hand soldering should be completed within 3 s when the point of solder iron is below 350
C.
Please solder within one time.
Please don't touch the terminals directly by soldering iron.
Soldered product shall treat at normal temperature.
Other notice
Please test the soldering method in actual condition and make sure the soldering works fine, since the
impact on the junction between the device and PCB varies depending on the cooling and soldering
conditions.
Flux
Some ux, which is used in soldering, may crack the package due to synergistic effect of alcohol in ux and
the rise in temperature by heat in soldering. Therefore, in using ux, please make sure that it does not have
any in uence on appearance and reliability of the photointerrupter.
相關PDF資料 |
PDF描述 |
|---|---|
| GP1S092HCPIF | SENSOR OPTO SLOT 2MM TRANS SMD |
| GP1S093HCZ0F | SENSOR OPTO SLOT 2MM TRANS THRU |
| GP1S094HCZ0F | SENSOR OPTO SLOT 3MM TRANS THRU |
| GP1S096HCZ0F | SENSOR OPTO SLOT 1MM TRANS THRU |
| GP1S097HCZ0F | SENSOR OPTO SLOT 2MM TRANS THRU |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GP1L53 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| GP1L53V | 功能描述:PHOTOINTERRUPTER SLOT 5.0MM PCB RoHS:否 類別:傳感器，轉換器 >> 光學 - 光斷續器 - 槽型 - 晶體管輸出 系列:- 產品變化通告:Internal Chip Change 04/May/2007 標準包裝:100 系列:- 檢測距離:0.063"（1.6mm） 檢測方法:可傳導的 輸出配置:光電晶體管 電流 - DC 正向(If):50mA 電流 - 集電極 (Ic)（最大）:20mA 電壓 - 集電極發射極擊穿（最大）:35V 響應時間:35µs，35µs 安裝類型:通孔 封裝/外殼:PCB 安裝 包裝:管件 類型:無放大 工作溫度:-25°C ~ 85°C 其它名稱:425-1978-5 |
| GP1L53VJ000F | 功能描述:光學開關（透射型，光電晶體管輸出） Photointerrupter Transmissive 5mm RoHS:否 制造商:Omron Electronics 輸出設備:Phototransistor 槽寬:3.4 mm 光圈寬度:0.5 mm 集電極—發射極最大電壓 VCEO:30 V 最大集電極電流:20 mA 正向電流: 安裝風格:Through Hole 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 封裝: |
| GP1L54 | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:High Sensitivity Photointerrupter |
| GP1L55 | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:High Sensitivity Photointerrupter |
發布緊急采購，3分鐘左右您將得到回復。